A nonlinear regression model applied to kinetic studies of ester hydrolysis with a surface acoustic wave sensor

A non-linear regression model was derived for the simultaneous determination of the rate constant in alkaline hydrolysis of esters and the initial concentration of esters based on the linear relationship between the frequency response of the surface acoustic wave sensor system and the conductivity of the solution. The model was tested theoretically and experimentally with the methyl-, ethyl-, and n-propyl-acetate systems. The corresponding rate constants estimated at 25 degrees C are 0.147, 0.103 and 0.0671 respectively.     

光化学-荧光分析法研究——Ⅲ.片剂及注射液中安定的测定

本文提出了测定安定的光化学—荧光分析新方法。安定在含有十二烷基硫酸钠的稀硫酸介质中,经紫外光照射后,产物能发射荧光(=368nm,=476nm)。安定浓度在0～2.5μg/ml范围内,荧光强度与浓度成良好的线性关系。方法的相对标准偏差为1.5％,检出限为0.044μg/ml,可用于片剂及注射液中安定含量的测定。     

Simultaneous determination of triterpene saponins in ginseng drugs by high-performance liquid chromatography

A HPLC method for the simultaneous determination of 11 triterpene saponins with four-type aglycones (protopanaxadiol, protopanaxatriol, ocotillol and oleanolic acid types) in Ginseng drugs was developed and validated. Using a gradient of acetonitrile and 10 mM K-phosphate buffer (pH 5.80) as the mobile phase and UV detection at 196 nm, more than 18 ginsenosides with different aglycones were separated satisfactorily within 60 min. The detection limits (signal/noise> or =3) were 0.1 microg for ginsenosides Rb1, Rc, Rd, Re and Rg1, chikusetsusaponin III, and notoginsenoside R2, 0.2 microg for gisenoside Ro and chikusetsusaponin IVa, 0.3 microg for chikusetsusaponin IV, and 3 microg for majonoside R2. The calibration curve of each saponin had a correlation coefficient close to 1. Intra- and interday precisions were less than 2.1% (n=5) and 3.3% (n=15), respectively. The recovery rates of extraction were in the range of 96.4-102.7% for all ginsenosides. By adopting this method, the determinations of 11 ginsenosides in three Ginseng drugs derived from Panax ginseng, Panax vietnamensis var. fuscidiscus and Panax japonicus (Japan) were achieved.     

Synthesis and Characterization of Novel Organosoluble Methyl Substituted Poly(aryl Ether Ketone)s Containing Sulfone Linkage

Several new methyl substituted poly(aryl ether ketone)s containing sulfone linkage with inherent viscosities of 0.62–0.84 dL/g have been prepared from 4,4′‐bis(2‐methylphenoxy)diphenylsulfone and 4,4′‐bis(3‐methylphenoxy)diphenylsulfone with terephthaloyl chloride and isophthaloyl chloride by electrophilic Friedel‐Crafts acylation in the presence of DMF with anhydrous AlCl₃ as a catalyst in 1,2‐dichloroethane, respectively. These polymers having weight‐average molecular weight in the range of 71,000–49,000 are all amorphous and show high glass transition temperatures ranging from 167 °C to 191 °C, excellent thermal stability at temperatures over 400 °C in air or nitrogen, high char yields of 51–58% in nitrogen and good solubility in CHCl₃ and polar solvents such as DMF, DMSO and NMP at room temperature.     

SAPO-34分子筛骨架稳定性的研究

利用差热分析，原位ＸＲＤ技术，高温条件下的焙烧和水蒸气处理并关联其催化性能变化，研究了ＳＡＰＯ－３４分子筛的热及水热稳定性，差热分析结果表明，ＳＡＰＯ－３４的骨架破坏温度高于１３００Ｋ，原位ＸＲＤ跟踪研究证实，ＳＡＰＯ－３４分子筛原粉在高温焙烧以除掉有机胺及随后的降温过程中无明显的骨架破坏；而焙烧型ＳＡＰＯ－３４在空气中放置一定时间后，水分子吸附微孔中明业降低样品的ＸＲＤ峰强度，且降低幅度随放置时     

担体对Fe—MnO催化剂CO＋H2反应性能的影响

考察氧化物担体对Fe-MnO催化剂反应性能影响的结果表明,担体的类型对Fe-MnO催化剂CO加氢反应性能影响很大,其低碳烯烃选择性相差悬殊,Al_2O_3、SiO_2和MgO担载的Fe-MnO催化剂都不利于低碳烯烃的生成,而TiO_2担载的Fe-MnO催化剂则具有较高的烯烃选择性和催化活性。从担体-金属相互作用本质的差异,研究了担体对金属活性组分化学状态的影响及催化活性相与F-T合成烯烃的关系,发现担体-金属间的电子效应有利于催化剂活性和选择性的提高,其它物理化学效应引起的相互作用则不利于改善催化剂性能;还表明Fe_(?)C是催化活性相,Fe~(2+)物种的存在不利于提高烯烃的选择性。     

内噪声作用下的随机共振算法对弱信号的检测

基于随机共振理论提出了一种简便、有效地检测弱信号的方法。在内噪声协同作用下，通过调节输入噪声信号的大小能较好地提高系统输出信号的信噪比，从而实现检测背景噪声很强的弱信号的目的。应用于模拟信号和实验信号的结果证明了方法是可行的。     

PAN共沉淀富集原子吸收测定饮水和人发中的微量锰

使用PAN-Ni(Ⅱ)共沉淀体系分离富集、微量流向进样火焰原子吸收光谱测定饮水和人发中的微量锰。样品中的共存元素不干扰测定，锰的标准加入回收率90%-108%之间。12次重复测定锰含量为0.15μg/mL的试样溶液的变异系数为4.6%,本法简便快捷,取得了较满意的结果.     

null

利用太阳能光解水制氢和降解有机污染物对解决能源和环境问题具有重要意义，而可见光响应催化剂的研制是实现太阳光高效利用的关键。本文从可见光响应光催化剂的设计思路出发，从电子能带结构、固溶体结构和微观复合结构三方面介绍了目前光催化剂的研究进展和发展方向。     

Photophysical properties of oligo(2,3-thienyleneethynylene)s

Photophysical properties of oligo(2,3-thienyleneethynylene)s (nTE, n denotes the number of thiophene rings, n = 2, 3) in benzene were investigated using steady-state, time-resolved fluorescence, and transient absorption spectroscopies. For 2TE, generation of the radiative S2 and nonradiative S1 states was confirmed. Upon excitation, the S2 state was initially generated and deactivated to the S1 state within 10 ps. The S1 state exhibited the transient absorption band at 470 nm, of which the lifetime was estimated to be 5.3 ns. In the case of 3TE, on the other hand, it was revealed that the radiative S1 state with a transient absorption peak at 650 nm was generated upon excitation. The T1 states of nTE were generated from the S1 states. The quantum yields were estimated to be 0.52 and 0.54 for 2TE and 3TE, respectively. Extremely fast reactions in the higher triplet excited state were indicated for both 2TE and 3TE.