Skeletal modification of a non-planar phthalocyanine analogue under very mild conditions

A sterically congested tetraphenyl-substituted dibenzo-tetraaza-isobacteriochlorinato nickel derivative unexpectedly reacts with methanol at room temperature to release internal molecular strains, leading to the formation of a ligand having a skeleton bearing two cis-methoxy substituents.     

In VivoLongitudinally Detected ESR Measurements at Microwave Regions of 300, 700, and 900 MHz in Rats Treated with a Nitroxide Radical

A signal detector of longitudinally detected ESR (LODESR) is independent of the resonant frequency. We developed anin vivoLODESR spectrometer operating in the regions of 300, 700, and 900 MHz. Using this apparatus, we estimated signal intensities at different operating frequencies obtained from non- or high-dielectric loss phantoms that contained nitroxide radical solutions and from live rats that had received a nitroxide radical. Our result, higher signal intensities in the high-dielectric loss samples (such as physiological saline solution and animals) at a lower frequency, shows that the influence of a decrease in dielectric loss dominates over the signal reduction caused by smaller Zeeman splitting. We believe that this finding strongly supports anin vivoESR resonant frequency that tends to be low.     

The effect of divinylsulfone on the irradiation crosslinking of polypropylene

Polypropylene films were irradiated with ⁶⁰Co γ-rays in divinylsulfone (DVS) or butadiene (BD) gases. The variations of the intrinsic viscosities of the samples irradiated in vacuum or in DVS with dose showed usual patterns but the variation of the latter was somewhat more rapid. The intrinsic viscosity of the sample irradiated in BD could not be measured due to the early appearance of gel. The gel fraction of the sample irradiated in DVS appeared at lower dose than that irradiated in vacuum, but the former did not increase as much as the latter. The gel fraction of the sample irradiated in BD increased remarkably. The concentrations of the two kinds of double bonds increased in the sample irradiated in BD but levelled off gradually with dose. ESR study showed that the polypropylene radical reacted with DVS to form anisotropic radicals. The mechanisms of the effects of both reagents on irradiation of polypropylene were discussed.     

Total synthesis of buergerinin F via effective construction of the asymmetric quaternary carbons using an enantioselective aldol reaction

An efficient method for the synthesis of (+)-buergerinin F is established via the enantioselective aldol reaction of a tetra-substituted ketene silyl acetal with crotonaldehyde, followed by intramolecular Wacker-type ketalization.     

Modes of conformational changes of proteins adsorbed on a planar hydrophobic polymer surface reflecting their adsorption behaviors

Infrared spectra of hen egg white lysozyme and bovine serum albumin (BSA) adsorbed on a solid poly tris(trimethylsiloxy)silylstyrene (pTSS) surface in D2O solution were measured using attenuated total reflection (ATR) Fourier transform infrared spectroscopy. From the area and shape of the amide I' band of each spectrum, the adsorption amount and the secondary structure were determined simultaneously, as a function of adsorption time. We could show that the average conformation for all the adsorbed lysozyme molecules was solely determined by the adsorption time, and independent of the bulk concentration, while the adsorption amount increased with the bulk concentration as well as the adsorption time. These results suggest that lysozyme molecules form discrete assemblies on the surface, and that the surface assemblies grow over several hours to have a definite architecture independent of the adsorption amount. As for BSA, the extent of the conformational change was solely determined by the adsorption amount, regardless of the bulk concentration and the adsorption time. These differences in the adsorption properties of lysozyme and BSA may reflect differences in their conformational stabilities.     

Investigation of thermal hazard during the hydrosilylation of 1,6-divinyl(perfluorohexane) with trichlorosilane

In this study, we examined the reaction hazard during the hydrosilylation reaction between trichlorosilane (TCS) and 1,6-divinyl(perfluorohexane) (FDV) in the presence of a butanol solution of chloroplatinic acid (Pt-Cat) as the catalyst. Assuming the three industrial risks of excessive addition of Pt-Cat, contamination by iron rust and mixing with cooling water, we observed the temperature and pressure change of TCS/FDV with an excessive amount of Pt-Cat, TCS/FDV/Pt-Cat with Fe₂O₃ and TCS/FDV/Pt-Cat with distilled water, using an accelerating rate calorimeter (ARC). The temperature and pressure greatly increased, especially in the sample with Fe₂O₃. For instance, in TCS/FDV/Pt-Cat with 1.5 wt.% Fe₂O₃, the heat release rate exceeded 624 K · min^?1 and the pressure rose above 25 MPa during the exothermic reaction.     

Dioxygenases, key enzymes to determine the aglycon structures of fusicoccin and brassicicene, diterpene compounds produced by fungi

Fusicoccin A and cotylenin A are structurally related diterpene glucosides and show a phytohormone-like activity. However, only cotylenin A induces the differentiation of human myeloid leukemia cells. Since the cotylenin A producer lost its ability to proliferate during preservation, a study on the relationship between structure and activity was carried out and a modified fusicoccin A with hydroxyl group at the 3-position showed a similar biological activity with that of cotylenin A. We then searched for an enzyme source that catalyzes the introduction of a hydroxyl group into the 3-position and found that brassicicene C, which is structurally related to fusicoccin A with hydroxyl group at the 3-position, was produced by Alternaria brassicicola ATCC96836. We recently cloned a brassicicene C biosynthetic gene cluster including the genes encoding fusicocca-2,10(14)-diene synthase and two cytochrome P450s, which were responsible for the formation of fusicocca-2,10(14)-diene-8β,16-diol. In this study, we report that a α-ketoglutarate dependent dioxygenase, the gene coding for which was located in the cluster, catalyzed a hydroxylation at the 3-position of fusicocca-2,10(14)-diene-8β,16-diol. On the other hand, a α-ketoglutarate-dependent dioxygenase, which had been identified in a fusicoccin A biosynthetic gene cluster, catalyzed the 16-oxidation of fusicocca-2,10(14)-diene-8β,16-diol to yield an aldehyde (8β-hydroxyfusicocca-1,10(14)-dien-16-al), although both dioxygenases had 51% amino acid sequence identity. These findings suggested that the dioxygenases played critical roles for the formation of the fusicoccin A-type and cotylenin A-/brassicicene C-type aglycons. Moreover, we showed that short-chain dehydrogenase/reductase located in the fusicoccin A biosynthetic gene cluster catalyzed the reduction of the aldehyde to yield fusicocca-1,10(14)-diene-8β,16-diol.     

Fabrication of mesoporous silica/polymer composites through solvent evaporation process and investigation of their excellent low thermal expansion property

We fabricate mesoporous silica/epoxy polymer composites through a solvent evaporation process. The easy penetration of the epoxy polymers into mesopores is achieved by using a diluted polymer solution including a volatile organic solvent. After the complete solvent evaporation, around 90% of the mesopores are estimated to be filled with the epoxy polymer chains. Here we carefully investigate the thermal expansion behavior of the obtained mesoporous silica/polymer composites. Thermal mechanical analysis (TMA) charts revealed that coefficient of linear thermal expansion (CTE) gradually decreases, as the amount of the doped mesoporous silica increases. Compared with spherical silica particle without mesopores, mesoporous silica particles show a greater effect on lowering the CTE values. Interestingly, it is found that the CTE values are proportionally decreased with the decrease of the total amount of the polymers outside the mesopores. These data demonstrate that polymers embedded inside the mesopores become thermally stable, and do not greatly contribute to the thermal expansion behavior of the composites.     

Rational synthesis of Pt spheres with hollow interior and nanosponge shell using silica particles as template

Here we report a facile and efficient method to prepare Pt spheres with hollow interior and nanosponge shell with high surface area. Such a unique Pt nanostructure can effectively improve the electrocatalytic performance of Pt catalysts by facilitating the access of electroactive species to the full-extent Pt surface.