Large-scale separation of metallic and semiconducting single-walled carbon nanotubes

In the applications of single-walled carbon nanotubes (SWNTs), it is extremely important to separate semiconducting and metallic SWNTs. Although several methods have been reported for the separation, only low yields have been achieved at great expense. We show a separation method involving a dispersion-centrifugation process in a tetrahydrofuran solution of amine, which makes metallic SWNTs highly concentrated to 87% in a simple way.     

Recovery of palladium from basic reprocessing waste of spent nuclear fuel

The methods including collection method, extraction-collection method, and special extraction-collection method have been investigated for high speed and efficient recovery of palladium from high pH reprocessing waste of spent nuclear fuel. The equilibrium of the reactions can be obtained is less than 1 minute. The maximum percent recovery of Pd is about 89%, 96% and 97% for collection, extraction-collection, and special extraction-collection methods, respectively. Nearly 100% of back extraction of Pd in the organic phase can be attained by using 7.4M ammonia solution, with a phase ratio of 1:1. The purity of the Pd product is high. The percent recovery of Pd is constant, up to 5·10³ Gy of irradiation dose.     

钛胶的制备条件和物性关系

钛胶是新型有广泛用途的催化剂载体。本实验测定了钛胶的孔容、比表面积、铁含量和晶型结构；研究了钛胶的制备条件和物性关系，得到一些有实用价值的实验结果。     

KF/Al~2O~3/PEG 4000(FAP)存在下氯仿的Michael加成反应

在KF/Al~2O~3/PEG4000(FAP)存在下,氯仿可与α,β-不饱和羰基化合物进行Michael加成反应,得到中等产率的三氯甲基化合物。     

钴(Ⅱ)与5-(5-硝基-2-吡啶偶氮)-2,4-二氨基甲苯络合物吸附波及其应用

钴 (Ⅱ )在NH3·H2O -NH2OH·HCl-5_(5_硝基_2_吡啶偶氮)_2,4_二氨基甲苯体系中有一灵敏的极谱波 ,其峰电位Vp 为 -1.20V(vsSCE) ,钴质量浓度在0.25～25μg/L范围内与峰电流Ip′有良好的线性关系 ,检出限为0.12μg/L;经多种电化学方法证明该波为络合物吸附波 ,其电极过程为不可逆过程 ,电子转移数为2 ,此外还试验了多种离子对峰电流Ip′的影响;所拟方法已用于维生素B12 和模拟样中痕量钴的测定     

Morin applied in speciation of aluminium in natural waters and biological samples by reversed-phase high-performance liquid chromatography with fluorescence detection

A reversed-phase high-performance liquid chromatographic method with fluorescence detection for the determination of labile monomeric aluminium has been developed through pre-column complexation using morin as the analytical reagent. The highly fluorescent aluminium-morin complex (excitation wavelength 418 nm, emission wavelength 490 nm) was separated on a Spherisorb ODS 2 column with an eluent consisting of 30% methanol and 70% water (pH 1.0 with perchloric acid). The most remarkable point of this protocol was that only the most toxic aluminium species, that is, free aqua-aluminium ion and its monomeric hydroxo complex ions, selectively respond among various aluminium complexes. This strategy has been successfully applied to direct fractionation of the toxic aluminium in natural waters and biological samples without any pretreatment.     

Excited-state metal-to-ligand charge transfer dynamics of a ruthenium(II) dye in solution and adsorbed on TiO2 nanoparticles from resonance Raman spectroscopy

The dynamics of metal-to-ligand charge transfer (MLCT) in a cis-bis(4,4'-dicarboxy-2,2'-bipyridine)-bis(isothiocyanato)ruthenium(II) dye (N3) are compared for the free dye in solution and the dye adsorbed on the surface of the TiO(2) nanoparticles from resonance Raman spectroscopy. The 544-nm MLCT absorption band of N3 adsorbed on TiO(2) is slightly blue-shifted from that of the free N3, indicating a weak electronic coupling between N3 and TiO(2). The resonance Raman spectra of N3 and the N3|TiO(2) complex obtained upon excitation within the lowest-lying MLCT singlet state of the dye are similar except for slight shifts in band positions. Resonance Raman cross sections have been obtained for the vibrational modes of both N3 and N3|TiO(2) with excitation frequencies spanning the 544-nm MLCT band. Self-consistent analysis of the resulting resonance Raman excitation profiles and absorption spectrum using a time-dependent wave packet formalism over two electronic states yields mode-specific vibrational and solvent reorganization energies. Despite the weak electronic coupling between N3 and TiO(2) in N3|TiO(2), adsorption strongly affects the reorganization energies of N3 in the intramolecular MLCT state. Adsorption of N3 onto TiO(2) increases the absolute Raman cross section of each mode by a factor of ca. 1.6 and decreases the vibrational and solvent reorganization energies by factors of 2 and 6, respectively. The excited-state dynamics of N3 adsorbed on the surface of TiO(2) nanoparticles were observed to be independent of the number of N3 molecules adsorbed per TiO(2) nanoparticle. The effect of TiO(2) on the dynamics of the adsorbed N3 is primarily due to both mode-specific vibrational and electronic pure dephasing, with the dominant contribution from the latter process.     

Kinetic Monte Carlo simulations of nucleation and growth in electrodeposition

Nucleation and growth during bulk electrodeposition is studied using kinetic Monte Carlo (KMC) simulations. Ion transport in solution is modeled using Brownian dynamics, and the kinetics of nucleation and growth are dependent on the probabilities of metal-on-substrate and metal-on-metal deposition. Using this approach, we make no assumptions about the nucleation rate, island density, or island distribution. The influence of the attachment probabilities and concentration on the time-dependent island density and current transients is reported. Various models have been assessed by recovering the nucleation rate and island density from the current-time transients.     

Chloride substitution of [CpRu(dppf)Cl] with sulfur-containing ligands

The reactions of CpRu(dppf)Cl (1) with the sulfur-containing ligands, thiophenol HSPh, 2-mercaptopyridine C₅H₄N(SH), thiourea SC(NH₂)₂, vinylene trithiocarbonate SCS(CH)₂S and ethylene trithiocarbonate SCS(CH₂)₂S, yielded chloro-substituted derivatives, viz. the mono-ruthenium(II) complexes CpRu(dppf)(SPh) (2), [CpRu(dppf)(SC₅H₄NH)]BPh₄ (3)BPh₄, [CpRu(dppf)(SC(NH₂)₂]PF₆ (4)PF₆, [CpRu(dppf)(SCS(CH)₂S)]Cl (5)Cl and [CpRu(dppf)(SCS(CH₂)₂S)]Cl (6)Cl, respectively. Treatment of 1 with AuCl(SMe₂) in the presence of NH₄PF₆ gave [(CpRu(dppf)(SMe₂)]PF₆ (7)PF₆. The reaction of 1 or 6 with SnCl₂ resulted in cleavage of chloro and dithiocarbonate ligands, respectively, to give CpRu(dppf)SnCl₃ (8). All complexes were spectroscopically characterized and the structures of 2 and cationic complexes 4-7 were determined by single-crystal diffraction analyses.