（Z）—3—丁烯基—4,5—二羟基苯酞的合成

（Ｚ）－３－丁烯基苯酞和它的衍生物广泛地存在于微形科植物，如当归、川芎等，这些植物有些是重要的中药材。（Ｚ）－３－丁烯基－４，５－二羟基苯酞是（Ｚ）－３－丁烯基苯酞的类似物；它对前列腺素Ｆ２α具有抑制作用。本文以３，４－二甲氧基苯甲醇（２）或价廉易得的胡椒醇（６）为起始原料，分别经四步反应顺利地合成了（Ｚ）－３－丁烯基－４，５羟基苯酞（１）。和一步是本方法的关键，即利用杂原子诱导的区域选择性的芳环     

硅胶担载四核羰基钴催化剂的EXAFS和IR研究

本文以透射法EXAFS和IR等手段研究了四核羰基钴金属簇Co_4(CO)_(10)(PPh)_2担载在SiO_2上以后及用于烯烃醛化反应前后的变化,确定了相应的结构参数并探讨了催化活性与结构的关系。     

Solvent extraction of uranium(VI) with benzyloctadecyldimethylammonium chloride (BODMAC) from highly concentrated chloride solution

The ²²²Rn emanation fraction (EF) released from the technically enhanced naturally occurring radioactive material (TE-NORM) wastes at certain sites of petroleum and gas production was determined. The samples were analyzed by γ-ray spectrometry to determine the activity concentration of the ²²⁶Ra content, of which the ²²²Rn emanation fraction was calculated. The results showed that the ²²²Rn emanation fraction differs in the oil and gas production sites and it is independent of the activity concentration of ²²⁶Ra. This revised version was published online in August 2006 with corrections to the Cover Date.     

A comparison between the SBR vulcanizates reinforced by magnesium methacrylate added directly or prepared in situ

The styrene-butadiene rubber (SBR) cured by dicumyl peroxide was reinforced by magnesium methacrylate [Mg(MAA)₂], which was added into SBR directly or prepared in situ in SBR through the neutralization of magnesium oxide (MgO) and methacrylic acid (MAA). The experimental results show that the SBR vulcanizates reinforced by Mg(MAA)₂ prepared in situ have better mechanical properties than those reinforced by Mg(MAA)₂ added directly. The SBR vulcanizates with Mg(MAA)₂ prepared in situ are semi-transparent, but those with Mg(MAA)₂ added directly are opaque. The Fourier transform infrared analysis shows that the polymerization conversion of Mg(MAA)₂ in the SBR vulcanizates with Mg(MAA)₂ prepared in situ is much higher than that in the SBR vulcanizates with Mg(MAA)₂ added directly. The scan probe microscopy photographs show that the particles in the SBR vulcanizates with Mg(MAA)₂ prepared in situ are much finer and disperse more evenly than that in the SBR vulcanizates with Mg(MAA)₂ added directly.     

Liquid chromatographic enantiomer resolution of N-fluorenylmethoxycarbonyl alpha-amino acids and their ester derivatives on polysaccharide-derived chiral stationary phases

The liquid chromatographic enantiomer separation of N-fluorenylmethoxycarbonyl (FMOC) protected alpha-amino acids and their ethyl ester derivatives was performed on polysaccharide-derived chiral stationary phases, Chiralcel OD, Chiralpak AD, and Chiralpak AS. In general, Chiralcel OD and Chiralpak AD showed good performance for resolution of N-FMOC alpha-amino acids and their ethyl esters, respectively. All investigated N-FMOC alpha-amino acid enantiomers were baseline separated on Chiralcel OD or Chiralpak AD, whereas N-FMOC alpha-amino acid ethyl ester enantiomers were baseline resolved (alpha = 1.15-3.03) on Chiralpak AD, except for two analytes. The L-enantiomers of all examined FMOC alpha-amino acid ethyl ester derivatives are preferentially retained on Chiralpak AD, while the elution orders of the other enantiomer separations are not consistent.     

Interface characteristics in diffusion bonding of Fe3Al with Cr18-Ni8 stainless steel

Fe3Al and Cr18-Ni8 stainless steel were diffusion-bonded in vacuum and a Fe3Al/Cr18-Ni8 interface with reaction layer was formed. Microstructure in the reaction layer at Fe3Al/Cr18-Ni8 interface was analyzed by means of scanning electron microscope (SEM) and electron probe micro-analyzer (EPMA). The growth of reaction layer with heating temperature (T) and holding time (t) was researched. The results indicate that FeAl, Fe3Al, Ni3Al, and alpha-Fe (Al) solid solution are formed in the reaction layer. These phases are favorable to promote the element diffusion and to accelerate the formation of the reaction layer at Fe3Al/Cr18-Ni8 interface. The growth of reaction layer obeys the parabolic law and its thickness (X) is expressed by X2 = 7.5 x 10(-4)exp(-83.59/RT)(t - t0).     

A delicate balance of energetics. Subtleties associated with alpha-ketol-based bridge migration to afford 9-keto-10beta-p-methoxybenzyloxytaxanes

The feasibility of the title reaction has been pursued for the purpose of advancing a concise total synthesis of Taxol. Of the two closely related series examined, the first featured an exo-methylene group at C4. The second consisted of an alpha-epoxide at that site. Strikingly, the olefinic construct proved inert to attempted alpha-ketol rearrangement. In contrast, the oxiranyl derivative isomerized smoothly. The reaction sequence associated with arrival at taxane 18 is short (15 steps from a D-camphor derivative) and notably efficient. The thermodynamic issues that are raised by this investigation have been clarified by an assessment of molecular mechanics-derived (MM3) steric energy calculations.     

八—4—(四氢糠氧基)双酞菁衍生物钕(Ⅲ)、铕(Ⅲ)的合成和LB膜的气敏性

八—４—（四氢糠氧基）双酞菁衍生物钕（Ⅲ）、铕（Ⅲ）的合成和ＬＢ膜的气敏性张引＊辛春梅王丹（吉林省教育学院化学系，长春１３００２２）梁冰洁＊＊陈文启席时权（中科院长春应用化学研究所，长春１３００２２）关键词：希土双酞菁衍生物ＬＢ膜气敏性荧光性紫外可见...     

N-（4＇-取代嘧啶-2＇-基）-取代苯氧基磺酰脲的合成及除草活性

光谱;N-（4＇-取代嘧啶-2＇-基）-取代苯氧基磺酰脲的合成及除草活性     

溶剂浓度对PVDF相转换膜大孔结构的影响

提出决定大孔能否发展的初始分相点处溶剂浓度临界点的概念 ,认为初始分相点处较高的溶剂浓度有利于大孔的发展 ,溶剂浓度低于一定的界限后 ,大孔停止发展 ,转为海绵状结构 .实验考察了不同凝胶液组成下制得的PVDF中空膜的结构 ,建立了相应的传质模型 ,模拟不同制膜条件下初生态膜内的组成分布情况 ,根据初始分相点处溶剂浓度临界点的概念 ,预测膜的形态结构 .模拟结果与相应制膜条件下的电镜照片有很好的对应关系 ,证明了上述大孔形成机理的正确性 .