Structural, magnetic properties and photoemission study of Ni-doped ZnO

Nickel-doped ZnO (Zn_1−xNi_xO) have been produced using rf magnetron sputtering. X-ray diffraction measurements revealed that nickel atoms were successfully incorporated into ZnO host matrix without forming any detectable secondary phase. Ni 2p core-level photoemission spectroscopy confirmed this result and suggested Ni has a chemical valence of 2+. According to the magnetization measurements, no ferromagnetic but paramagnetic behavior was found for Zn_0.86Ni_0.14O. We studied the electronic structure of Zn_0.86Ni_0.14O by valence-band photoemission spectroscopy. The spectra demonstrate a structure at ∼2 eV below the Fermi energy E_F, which is of Ni 3d origin. No emission was found at E_F, suggesting the insulating nature of the film.     

具有周期非均匀扰动的色散管理系统中的孤子传输

在准理想的色散管理系统中建立了非均匀扰动模型,研究了它们对孤子传输和相互作用的影响.这些扰动导致孤子崩塌,加剧了孤子间相互作用.它们影响的大小与周期长度和扰动强度有关,并且存在最坏周期长度和扰动共振现像.最后,引入非线性增益和滤波器来有效控制这些扰动的影响.     

ABS防抱死系统及其检测

现代汽车中有一种先进的制动机构。可保证在制动时不是完全刹死滑行，而是让车轮仍有一定的滚动．经研究这种方法可以更有效地制动．防抱死系统有一个自动检测车速的装置，用来控制车轮的转动，其原理如图1，铁质齿圈P与车轮同步转动，右端有一个绕有线圈的磁体，G是一个电流检测器．当车轮带动齿轮转动时，由于齿靠近线圈时被磁化，使磁通量增强，     

THE COMRENSATED COMPACTNESS METHOD APPLIED TO QUASILINEAR PARABOLIC EQUATIONS OF HIGHER ORDER WITH BOUBLY STRONG DEGENERATION

This paper applies the compensated compactnessmethod to the study of a class of quasilinear parbolic equations of higher order with doubly strong degeneration. Some existence and uniqueness results are proved under certain conditions.     

Synthesis of cellulose carbamate by supercritical CO2-assisted impregnation: Structure and rheological properties

Cellulose carbamate, an environmentally friendly material presents an interesting alternative to petroleum-based polymers because of its renewable, biodegradable, biocompatible nature and its solubility in conventional solvents. In synthesis process of cellulose carbamate, urea was firstly impregnated into the cellulose pulp by supercritical CO₂(scCO₂), followed by the esterification of cellulose. The structure of cellulose carbamate was characterized by Fourier transform infrared spectroscopy (FTIR), X-ray diffractometry (XRD) and scanning electron microscopy (SEM). The rheological properties of these cellulose carbamates in 9% sodium hydroxide solution were investigated, using a range of the nitrogen content, concentrations and shear rates.     

Electroless deposition of open-end Cu nanotube arrays

Cu nanotube arrays were fabricated by electroless deposition using porous anodic aluminium oxide membranes as templates. This was accomplished by a four-step procedure, i.e. pore-wall modification, polishing treatment, sensitization-activation and electroless deposition. The as-synthesized Cu nanotubes possess controllable inner diameter and open ends.     

Microstructure and wear properties of laser clad Cuss/Cr5Si3 metal silicide composite coatings

Wear resistant Cu-based solid solution (Cu_ss) toughened Cr₅Si₃ metal silicide composite coatings were fabricated on austenitic stainless steel AISI321 by laser cladding process. Due to the rapidly solidified microstructural characteristics and the excellent toughening effect of Cu_ss on Cr₅Si₃, the Cu_ss/Cr₅Si₃ coatings have outstanding wear resistance and low coefficient of friction under room temperature dry sliding wear test conditions coupling with hardened 0.45% C steel.     

Chemically modified proton‐conducting membranes based on sulfonated polyimides: Improved water stability and fuel‐cell performance

A series of branched/crosslinked sulfonated polyimide (B/C‐SPI) membranes were prepared and evaluated as proton‐conducting ionomers based on the new concept of in situ crosslinking from sulfonated polyimide (SPI) oligomers and triamine monomers. Chemical branching and crosslinking in SPI oligomers with 1,3,5‐tris(4‐aminophenoxy)benzene as a crosslinker gave the polymer membranes very good water stability and mechanical properties under an accelerated aging treatment in water at 130 °C, despite their high ion‐exchange capacity (2.2–2.6 mequiv g^?1). The resulting polymer electrolytes displayed high proton conductivities of 0.2–0.3 S cm^?1 at 120 °C in water and reasonably high conductivities of 0.02–0.03 S cm^?1 at 50% relative humidity. In a single H₂/O₂ fuel‐cell system at 90 °C, they exhibited high fuel‐cell performances comparable to those of Nafion 112. The B/C‐SPI membranes also displayed good performances in a direct methanol fuel cell with methanol concentrations as high as 50 wt % that were superior to those of Nafion 112. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3751–3762, 2006     

Sulfonated poly(aryl ether ether ketone ketone)s containing fluorinated moieties as proton exchange membrane materials

A series of sulfonated poly(aryl ether ether ketone ketone)s statistical copolymers with high molecular weights were synthesized via an aromatic nucleophilic substitution polymerization. The sulfonation content (SC), defined as the number of sulfonic acid groups contained in an average repeat unit, could be controlled by the feed ratios of monomers. Flexible and strong membranes in sodium sulfonate form could be prepared by the solution casting method, and readily transformed to their proton forms by treating them in 2 N sulfuric acid. The polymers showed high T_gs, which increased with an increase in SC. Membranes prepared from the present sulfonated poly(ether ether ketone ketone) copolymers containing the hexafluoroisopropylidene moiety (SPEEKK‐6F) and copolymers containing the pendant 3,5‐ditrifluoromethylphenyl moiety (SPEEKK‐6FP) had lower water uptakes and lower swelling ratios in comparison with previously prepared copolymers containing 6F units. All of the polymers possessed proton conductivities higher than 1 × 10^?2 S/cm at room temperature, and proton conductivity values of several polymers were comparable to that of Nafion at high relative humidity. Their thermal stability, oxidative stability, and mechanical properties were also evaluated. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2299–2310, 2006     

Novel photoswitching dithienylethenes with ferrocene units

Two novel dithienylethenes with ferrocene units were synthesized by Wittig reaction. The structure of 2a has been established by X‐ray diffraction studies. They could reversibly interconvert between two thermally stable forms, an open and a closed one, using light of different wavelengths as triggers. Copyright © 2006 John Wiley & Sons, Ltd.