The computer‐assisted design and synthesis of molecularly imprinted polymers for the simultaneous capture of six carbamate pesticides from environmental water are reported in this work. The quantum mechanical computational approach was employed to design the molecularly imprinted polymers with carbofuran as template. The interaction energies between the template molecule and different functional monomers in various solvents were calculated to assist in the selection of the functional monomer and porogen. The optimised molecularly imprinted polymer was subsequently used as a class‐selective sorbent in solid‐phase extraction for pre‐concentration and determination of carbamates from environmental water. The parameters influencing the extraction efficiency of the molecularly imprinted solid‐phase extraction procedure were systematically investigated to facilitate the class‐selective extraction. For the proposed method, linearity was observed over the range of 2–500 ng/mL with the correlation coefficient ranging from 0.9760 to 1.000. The limits of detection ranged from 0.2 to 1.2 ng/mL, and the limit of quantification was 4 ng/mL. These results confirm that computer‐assisted design is an effective evaluation tool for molecularly imprinted polymers synthesis, and that molecularly imprinted solid‐phase extraction can be applied to the simultaneous analysis of carbamates in environmental water. 相似文献
A simple, low-cost, and efficient online focusing method that combines a dynamic pH junction and sweeping by capillary electrophoresis with polymer solutions was developed and optimized for the simultaneous determination of benzoic acid (BA) and sorbic acid (SA). A sample solution consisting of 2.5 mM phosphate at pH 3.0 and a buffer solution containing 15 mM tetraborate (pH 9.2), 40 mM sodium dodecyl sulfate, and 0.100 % (w/v) poly(ethylene oxide) were utilized to realize dynamic pH junction–sweeping for BA and SA. Under the optimized conditions, the entire analysis process was completed in 7 min, and a 900-fold sensitivity enhancement was achieved with limits of detection (S/N?=?3) as low as 8.2 and 6.1 nM for BA and SA, respectively. The linear ranges were between 20 nM and 20 μM for BA and 20 nM and 10 μM for SA, with correlation coefficients greater than 0.992. The recoveries of the proposed method ranged from 90 to 113 %. These satisfactory results indicate that this method has the potential to be an effective analytical tool for the rapid screening of BA and SA in different food products.
Figure An online focusing strategy combining dynamic pH junction and sweeping for sensitive determination of benzoic and sorbic acid in food products using capillary electrophoresis wit polymer solutions
The 304 nm photodissociation of the C-H symmetric stretch excited CH3I[v1=1,v2=0](v1 denotes the C-H symmetric stretch mode,and v2 denotes the umbrella mode)is studied with our simple photofragment translational spectrometer.An IR laser is used to excite the ground state CH3I[0,0]to the C-H symmetric stretch excited CH3I[1,0].With IR laser OFF and ON,the fractions of photofragments CH3(ν1,ν2)from the 304 nm photodissociation of CH3I[1,0]have been determined through the photofragment translational spectra(PTS)from measuring I and I*and also through the PTS from measuring CH3(0,0)(1,0)(0,1)and(1,1).The experimental results show that the C-H symmetric stretch vibration(v1=1)in parent molecules is about 66%retained in the photofragments in the I channel,but only 24%in the I*channel.The populations of photofragments CH3(0,2)and(0,3)are higher than CH3(0,0)and(0,1),showing strong inverted population both in I and I*channels. 相似文献
We differentiated the effects of Cu films deposited on single crystalline a-,r-,and c-plane sapphire substrates upon graphene films synthesized with atmospheric pressure chemical vapor deposition(CVD).The data illustrate that the realization of high-crystalline Cu film is dependent not only on the crystallinity of underlying substrate,but also on the symmetric match of crystallographic geometry between metal film and substrate.We also systematically investigated the effects of PMMA removal on the Raman ID/IG and IG/I2D values of transferred graphene.The results reveal that different PMMA removal methods do not alter the ID/IG values;instead,the residue of PMMA increases the IG/I2D values and the thermal decomposition of PMMA leads to higher IG/I2D values than the removal of PMMA with acetone.The effects of PMMA removal on variations of the Raman spectra are also discussed. 相似文献
Half-sandwich zirconium complex 3 containing tridentate carborane [S,S,O] ligand 2 [(HOC6H2R2-4,6)(CH2)SC(B10H10) C(Ph)2P=S, R=tBu] was synthesized by the reaction of CpZrCl3(Cp=η5-C5H5) with sodium salt of ligand 2. Zirconium complex 3 was characterized by elemental and NMR analyses. DFT calculations were also performed on complex 3 to analyze the stereochemistry. The results from DFT calculations indicate that structure S1, in which no sulfur atom bonds to the zirconium atom, exists at the lowest energy level. In the presence of methylaluminoxane(MAO), complex 3 exhibited good catalytic activities for ethylene polymerization and long life-time up to 10 h. Moreover, the complex 3/MAO system displayed excellent catalytic activities toword ethylene copolymerization with 1-hexene or polar olefins. 相似文献
The origin of the catalytic power of enzymes with a meta-stable native state,e.g.molten globular state,is an unsolved challenging issue in biochemistry.To help understand the possible differences between this special class of enzymes and the typical ones,we report here computer simulations of the catalysis of both the well-folded wild-type and the molten globular mutant of chorismate mutase.Using the ab initio quantum mechanical/molecular mechanical minimum free-energy path method,we determined the height of reaction barriers that are in good agreement with experimental measurements.Enzyme-substrate interactions were analyzed in detail to identify factors contributing to catalysis.Computed angular order parameters of backbone N–H bonds and side-chain methyl groups suggested site-specific,non-uniform rigidity changes of the enzymes during catalysis.The change of conformational entropy from the ground state to the transition state revealed distinctly contrasting entropy/enthalpy compensations in the dimeric wild-type enzyme and its molten globular monomeric variant.A unique catalytic strategy was suggested for enzymes that are natively molten globules:some may possess large conformational flexibility to provide strong electrostatic interactions to stabilize the transition state of the substrate and compensate for the entropy loss in the transition state.The equilibrium conformational dynamics in the reactant state were analyzed to quantify their contributions to the structural transitions enzymes needed to reach the transition states.The results suggest that large-scale conformational dynamics make important catalytic contributions to sampling conformational regions in favor of binding the transition state of substrate. 相似文献
In this paper Cu3Mo2O9 nanosheet was prepared by a hydrothermal method and further used to investigate the direct electrochemistry of hemoglobin (Hb) with a carbon ionic liquid electrode (CILE) as the substrate electrode. Hb was mixed with Cu3Mo2O9 nanosheet and cast on the CILE surface with chitosan (CTS) as the film-forming material. UV-vis and FT-IR spectroscopic results showed that Hb remained in its native structure in the composite film. Direct electron transfer of Hb on the modified electrode was realized with a pair of well-defined quasi-reversible redox waves that appeared on cyclic voltammograms. The redox peak potential appeared at ?0.252 V (Epc) and ?0.141 V (Epa), respectively, with the formal peak potential calculated as ?0.196 V, which was the characteristic of electroactive center of Hb heme Fe(III)/Fe(II). The result could be attributed to the presence of Cu3Mo2O9 nanosheet on the electrode surface that was of benefit for the protein orientation and promoted direct electron transfer between the redox active center of Hb and the substrate electrode. The CTS/Cu3Mo2O9–Hb/CILE showed good electrocatalytic ability in reducing different substrates such as trichloroacetic acid, H2O2 and O2, with wider linear range and lower detection limit, thus exhibiting the potential application of the Cu3Mo2O9 nanosheet in third-generation electrochemical biosensors. 相似文献
The chemical state of a transition‐metal dopant in TiO2 can intrinsically determine the performance of the doped material in applications such as photocatalysis and photovoltaics. In this study, manganese‐doped TiO2 is fabricated by a near‐equilibrium process, in which the TiO2 precursor powder precipitates from a hydrothermally obtained transparent mother solution. The doping level and subsequent thermal treatment influence the morphology and crystallization of the TiO2 samples. FTIR spectroscopy and X‐ray photoelectron spectroscopy analyses indicate that the manganese dopant is substitutionally incorporated by replacing Ti4+ cations. The absorption band edge can be gradually shifted to 1.8 eV by increasing the nominal manganese content to 10 at %. Manganese atoms doped into the titanium lattice are associated with the dominant 4+ valence oxidation state, which introduces two curved, intermediate bands within the band gap and results in a significant enhancement in photoabsorption and the quantity of photogenerated hydroxyl radicals. Additionally, the high photocatalytic performance of manganese‐doped TiO2 is also attributed to the low oxygen content, owing to the equilibrium fabrication conditions. This work provides an important strategy to control the chemical and defect states of dopants by using an equilibrium fabrication process. 相似文献
An efficient chemical system for electron generation and transfer is constructed by the integration of an electron mediator ([Co(bpy)3]2+; bpy=2,2′‐bipyridine) with semiconductor photocatalysts. The introduction of [Co(bpy)3]2+ remarkably enhances the photocatalytic activity of pristine semiconductor photocatalysts for heterogeneous CO2 conversion; this is attributable to the acceleration of charge separation. Of particular interest is that the excellent photocatalytic activity of heterogeneous catalysts can be developed as a universal photocatalytic CO2 reduction system. The present findings clearly demonstrate that the integration of an electron mediator with semiconductors is a feasible process for the design and development of efficient photochemical systems for CO2 conversion. 相似文献
Recently, more and more rhodamine derivatives have been used as fluorophores to construct sensors due to their excellent spectroscopic properties. A rhodamine-based fluorescent and colorimetric Fe3+ chemosensor 3’,6’-bis(ethylamino)-2-acetoxyl-2’,7’-dimethyl-spiro[1H-isoindole-1,9’-[9H]xanthen]-3(2H)-one (RAE) was designed and synthesized. Upon the addition of Fe3+, the dramatic enhancement of both fluorescence and absorbance intensity, as well as the color change of the solution, could be observed. The detection limit of RAE for Fe3+ was around 7.98 ppb. Common coexistent metal ions showed little or no interference in the detection of Fe3+. Moreover, the addition of CN− could quench the fluorescence of the acetonitrile solution of RAE and Fe3+, indicating the regeneration of the chemosensor RAE. The robust nature of the sensor was shown by the detection of Fe3+ even after repeated rounds of quenching. As iron is a ubiquitous metal in cells and plays vital roles in many biological processes, this chemosensor could be developed to have applications in biological studies. 相似文献