Polarization-modulated analog photonic link with compensation of the dispersion-induced power fading

A novel integrable modulator consisting of a polarization modulator and a polarizer is proposed for constructing a high-performance analog photonic link. By adjusting a polarization controller placed before the modulator, both amplitude modulation and phase modulation with adjustable ratio between them are implemented. This feature is used to shift the peak of the frequency response of a dispersive link to any desired frequency, so the dispersion-induced power fading around the frequency is compensated. A proof-of-concept experiment is performed. The compensation of the dispersion-induced power fading in the proposed analog photonic link increases the spur-free dynamic range as large as 12.5 dB.     

Phase sensitive amplifier for PSK signals based on non-degenerate four-wave-mixing in the optical fiber

A phase-sensitive-amplifier (PSA) using only one pump channel based on frequency non-degenerate four-wave-mixing (FWM) process for phase-shift-keying (PSK) signals is proposed and demonstrated. Theoretical analyses are given first. By optimizing power levels of three channels and parameters of the highly nonlinear fiber (HNLF), the PSA is able to restore the signal fidelity (down to a BER of 10^? 9) as the input signal shows an error-floor with the BER of 10^? 6. Moreover, the PSA for the multi-level PSK signals could be achieved by adjusting the phase relationship between two input signals.     

XANES analysis of spectral properties and structures of arsenate adsorption on TiO2 surfaces

X‐ray absorption near‐edge structure (XANES) of arsenate adsorption on TiO₂ surfaces was calculated using self‐consistent multiple‐scattering methods, allowing a structural analysis of experimental spectra. A quantitative analysis of the effect of disorder revealed that the broadening and weakening of the characteristic absorption in experimental XANES was due to the structural disorder of the arsenate–TiO₂ adsorption system. The success with calculating the scattering amplitude of a specific set of paths using the path expansion approach enables the scattering contributions of different coordination shells to the XANES to be sorted out. The results showed that the scattering resonances from high‐level shells inherently overlapped onto the first‐shell scattering amplitudes, and formed the fine structures in the XANES region. A variation in one oscillatory feature could be due to several structural changes affecting specific single/multiple‐scattering amplitudes. Therefore, direct assignments of spectral features with structural elements should be based on adequate theoretical analysis.     

一种混沌密码序列周期特性检测新方法

针对数字混沌密码序列发生器产生的二值序列局部范围内存在的周期特性评价难问题,提出一种新的周期特性分析方法——BSPD(binary sequence’s periodic detection)方法,用于评价二值序列具有的周期特性.该方法除可用于检测二值序列是否存在精确周期,或在部分时域范围内存在周期现象;还可检测出序列局部出现的周期性重叠模板,用于具体分析二值序列中周期现象的统计特征.一个基于经典Logistical映射的BSPD检验表明,该方法可以有效地定位一个类似随机混沌二值序列中蕴含的周期现象.     

新型半导体开关高压电磁脉冲产生技术

基于独特结构和物理特性的两类高性能新型高压半导体开关漂移阶跃恢复二极管和快速离化开关,提出一种新型高功率高压纳秒电磁脉冲产生方法,其技术路径是通过高压漂移阶跃恢复二极管开关将高贮能电感能量向高压快速离化开关及负载转移,产生高功率、高重复频率纳秒电磁脉冲,并用实验验证该方法在高重复频率（120,200,300 kHz）下产生高功率、高重复频率纳秒脉冲的有效性,输出脉冲电压分别为1.62,1.41,1.36 kV。     

Yb3+/Ho3+/Tm3+共掺碲酸盐玻璃的上转换白光发射及其机理研究

采用高温熔融法分别制备了Yb3+/Ho3+,Yb3+/Tm3+和Yb3+/Ho3+/Tm3+共掺的碲酸盐玻璃。在980nm红外激光激发下,Yb3+/Ho3+/Tm3+共掺的玻璃样品显示了强的蓝光、绿光和红光发射,分别对应于Tm3+的1 G4→3 H6跃迁、Ho3+的5 F4(5 S2)→5I 8跃迁以及Ho3+的5 F5→5I 8和Tm3+的1 G4→3 F4跃迁。通过对比发现,Yb3+/Ho3+/Tm3+共掺样品中的红、绿光积分发射强度比值(3.95)明显大于Yb3+/Ho3+共掺样品(1.69),这是由于Ho3+和Tm3+间存在交叉弛豫过程3 H4(Tm3+)+5I 6(Ho3+)→3 F4(Tm3+)+5 F5(Ho3+)和3 F4(Tm3+)+5I 8(Ho3+)→3 H6(Tm3+)+5I 7(Ho3+)所致。在激发功率密度为8.2 W.cm-2时,Yb3+/Ho3+/Tm3+共掺样品的上转换发光色坐标值为x=0.345,y=0.338,非常接近于等能白光(x=0.333,y=0.333)。     

便携式X射线荧光光谱分析仪测定土壤中重金属

应用NITON XL3t600型便携式X射线荧光谱分析仪对土壤中主要重金属污染物Cu,Zn,Pb,Cr和As进行了测试。结果表明,Cu,Zn,Pb,Cr和As元素的最低检出限分别为:23.96,11.69,8.58,19.23,6.24mg.kg-1;对土壤成分分析标准物质GSS-5进行5次重复测定,准确度在96%～102%之间,RSD在1.0%～7.6%范围内,表明仪器对于土壤中较高浓度重金属检测准确度和精密度良好;田间进行原位检测,相对标准偏差均小于20%,与国标方法检测结果相比,准确度在55%～119%之间。通过实验室测试和田间原位检测,验证了便携式X射线荧光谱分析仪检测土壤中重金属元素有较好的准确度和精密度,适用于土壤中重金属的快速检测。     

Improving lithographic masks with the assistance of indentations

Indentations etched on the output surface of a metallic mask are proposed to produce fine lithographic patterns with a resolution of 500 nm using the finite-difference time domain(FDTD) method.Such a designed mask is capable of enhancing near field lithography(NFL) resolution more than three times compared with the structure without indentations.The simulation results show that the interference disturbance between the adjacent lithographic channels can be eliminated efficiently by employing the indentations.As a straightforward consequence,the channel-to-channel interspaces can be shortened significantly,maintaining a uniform field distribution and high contrast.     

A functional probe with bowtie aperture and bull's eye structure for nanolithograph

The bowtie aperture surrounded by concentric gratings(the bull’s eye structure) integrated on the near-field scanning optical microscopy(NSOM) probe(aluminum coated fiber tip) for nanolithography has been investigated using the finite-difference time domain(FDTD) method.By modifying the parameters of the bowtie aperture and the concentric gratings,a maximal field enhancement factor of 391.69 has been achieved,which is 18 times larger than that obtained from the single bowtie aperture.Additionally,the light spot depends on the gap size of the bowtie aperture and can be confined to sub-wavelength.The superiority of the combination of the bowtie aperture and the bull’s eye structure is confirmed,and the mechanism for the electric field enhancement in this derived structure is analyzed.     

Evolution of Spiral Waves under Modulated Electric Fields

Spirals generated from the excitable media within the Barkley model is investigated under the gradient electric fields by a numerical simulation. The spiral drift and spiral break up are observed when the amplitude of the electric fields is modulated by a constant signal or a chaotic signal. It is also verified that, even in the presence of the white noise, the whole system can reach homogeneous states after the spiral breakup, by using an adaptive strategy.