The axial Ward identity in the presence of a quark-condensing vacuum

Quark-condensate contributions to triangle amplitudes arising from the nonperturbative content of the QCD vacuum are shown to uphold the anomalous axial Ward identity to leading and next-to-leading order in both the expansion parameter [m _quark/momentum]², as well as in the expansion parameter [m _π/m _quark]² appropriate forπ ⁰→ kinematics.     

宝石辐照的颜色改善

宝石的颜色是其最重要的物理性质之一,也是宝石学界最关切的,提高宝石档次的关键问题之一,本文介绍了宝石致色的一些因素和作为宝石颜色改善的新方法—辐照改色的一些动态. The colour of gem is one of the most important physical properties of gem.Some factorson the colouring of gem and situations of colour improvement by irradiation are introduced in this pa-per.     

大气湍流对天文望远镜光电导行精度的影响

讨论了由大气湍流造成的望远镜导行误差,这一误差将给望远镜光电导行的精度带来较大影响。其中使用单点源目标的导行精度受限于大气相干长度和大气相干时间,而多点源目标及面源的导行精度还与湍流随高度的变化有关。通过分析和仿真(数值模拟)结果表明,现代天文观测必须考虑大气湍流对光电导行精度的影响。通过延长曝光时间可以有效降低湍流大气的影响,同时也降低了光电导行的反馈控制频率。当导行信标为多星或面源则可在一定程度上降低高层大气湍流带来的光电导行误差,从而可以适度减少光电导行曝光时间,提高其反馈控制频率。     

一种双段多层长周期光纤光栅光谱特性研究

长周期光纤光栅(LPFG)传感器具有非常广泛的应用价值,而有效解决物理量交叉敏感问题是其实用化的关键。基于LPFG对包层外介质折射率和厚度的敏感性,提出一种双段多层折射率横向分布结构的新型LPFG传感器的设计,并利用耦合模理论和传输矩阵方法分析了镀膜材料折射率、膜层厚度和镀层长度对新型LPFG传感器光谱特性的影响。软件仿真结果证明,这种LPFG由于结构设计上的特殊性,将使LPFG的谐振峰发生分裂,即一个透射峰分裂为两个。由于两个分裂峰对应力和温度的灵敏度不同,利用该结构的LPFG作为传感器,可以实现温度、应力等物理量的同步测量,从而解决LPFG传感器的交叉敏感问题。     

光子晶体异质结耦合波导光开关

以二维三角晶格光子晶体为研究对象,在该光子晶体中引入两行平行的单模线缺陷波导,以一行耦合介质柱为间距,通过调节部分耦合介质柱的折射率,构筑了光子晶体异质结耦合波导光开关结构。利用平面波展开法和定向耦合原理计算了在不同入射光频率下,缺陷波导间耦合介质柱的折射率不同时的耦合长度,确定了合适的光子晶体异质结耦合波导光开关的结构参数。利用时域有限差分法研究了该光开关中耦合介质柱的折射率变化及异质结构介质柱的位置分布对光信号输出路径的影响。结果表明,通过改变该结构中耦合介质柱的折射率可以改变光的输出路径,可实现光的开关行为。并且异质结构介质柱位置的随机分布对该光开关的影响不大,有助于光子晶体新型滤波器、定向耦合器、波分复用器以及光开关等光子器件的研究。     

时间延迟积分型面阵CMOS图像传感器MTF速度失配模型研究

研究了时间延迟积分型面阵互补金属氧化物半导体(CMOS)图像传感器调制传递函数(MTF)速度失配特性,在分析累加级数、像素尺寸、镜头放大倍数、行周期及电机运动速度失配等影响因素的基础上,建立了MTF速度失配模型。基于现场可编程门阵列(FPGA)开发板,搭建面阵CMOS图像传感器实现线阵时间延时积分(TDI)的CMOS测试系统。实验结果表明,在光强为3lx,速度失配M(ΔV/V)<2,8级时间延迟积分与面阵成像相比,MTF值提高50%;当累加级数为8级,速度失配满足M(ΔV/V)=2的速度失配容限时,奈奎斯特频率处的MTF值下降10%,当速度失配达到M(ΔV/V)=10时,MTF值下降35%。     

超高数值孔径Schwarzschild投影光刻物镜的光学设计

针对45nm及以下节点光刻相关技术的研究需求,确定了实验型投影光刻物镜的结构型式及设计指标。依据像差理论在非同心小遮拦的Schwarzschild反射系统中添加折射补偿镜组来进一步减小系统的中心遮拦,扩大像方数值孔径。设计了一套小中心遮拦,数值孔径为1.20的Schwarzschild折反式投影光刻物镜。设计结果表明,该投影光刻物镜工作带宽为100pm,像方视场为50μm,线中心遮拦比为13%,光学分辨力为80nm时(6240lp/mm)的系统调制传递函数大于0.45,全视场最大畸变为6.5nm,满足了45nm深紫外(DUV)浸没光刻实验平台对投影光刻物镜的需求。     

Effect of Ag underlayer thickness on the microstructure and magnetic properties of L10-FePt films

FePt/Ag films were deposited on thermally oxidized Si(100) substrates by magnetron sputtering at room temperature and then the as-deposited films were annealed at 500 ^°C. The microstructure and magnetic properties of the films have been investigated by X-ray diffraction and vibrating sample magnetometry. The results indicate that introduction of the Ag underlayer promotes an ordering transformation of the FePt phase due to thermal tensile stress between the Ag underlayer and the FePt film. The in-plane tensile stress induced by the Ag underlayer should stretch the horizontal lattice parameter of FePt; thus, it is helpful for the ordering transformation. With increasing Ag underlayer thickness, the ordering parameter and coercivity first increase and then decrease. When the Ag underlayer thickness is 12 nm, the ordering parameter and coercivity of the film reach the maximum values, respectively. The Ag underlayer thickness also affects the magnetization reversal mechanism.     

Enhanced electrocatalytic oxidation of hydroxylamine on Pt/polypyrrole composite modified glassy carbon electrode

A sensitive hydroxylamine sensor is developed by electrodeposition of Pt nanoparticles on pre-synthesized polypyrrole nanoparticles modified glassy carbon electrode. The modified electrode presents distinctly electrocatalytic activity toward hydroxylamine oxidation. The kinetic parameters such as the overall numbers of electrons involved in hydroxylamine oxidation, the electron transfer coefficient, standard heterogeneous rate constant, and diffusion coefficient are evaluated. The current response increases linearly with increasing hydroxylamine concentrations and exhibits two wide linear ranges of 5.0?×?10^?7–1.1?×?10^?3 and 1.1?×?10^?3–18.8?×?10^?3 M with a detection limit of 0.08 μM (s/n?=?3). The proposed electrode presents excellent operational and storage ability for determining hydroxylamine. Moreover, the sensor shows good sensitivity, selectivity, and reproducibility properties.     

Feasibility Study on Quantitative Measurements of Singlet Oxygen Generation Using Singlet Oxygen Sensor Green

The purpose of this study is to investigate the feasibility for quantitative measurement of singlet oxygen (¹O₂) generation by using a newly developed ¹O₂-specific fluorescence probe Singlet Oxygen Sensor Green reagent (SOSG). ¹O₂ generation from photoirradiation of a model photosensitizer Rose Bengal (RB), in initially air-statured phosphate buffered saline (PBS) was indirectly monitored with SOSG. In the presence of ¹O₂, SOSG can react with ¹O₂ to produce SOSG endoperoxides (SOSG-EP) that emit strong green fluorescence with the maximum at 531 nm. The green fluorescence of SOSG-EP is mainly dependent on the initial concentrations of RB and SOSG, and the photoirradiation time for ¹O₂ generation. Furthermore, kinetic analysis of the RB-sensitized photooxidation of SOSG is performed that, for the first time, allows quantitative measurement of ¹O₂ generation directly from the determination of reaction rate. In addition, the obtained ¹O₂ quantum yield of porphyrin-based photosensitizer hematoporphyrin monomethyl ether (HMME) in PBS by using SOSG is in good agreement with the value that independently determined by using direct measurement of ¹O₂ luminescence. The results of this study clearly demonstrate that the quantitative measurement of ¹O₂ generation using SOSG can be achieved by determining the reaction rate with an appropriate measurement protocol.