纳米ZnO和ZnO-SiO2复合薄膜的光学性质研究

通过溶胶凝胶(sol-gel)法分别在玻璃衬底上制备了ZnO纳米薄膜和ZnO-SiO₂纳米复合薄膜,并利用紫外-可见光分光光度计对薄膜的光学性能进行了分析.可见光-紫外透射谱显示,随着ZnO溶胶浓度从0.7mol/L降低到0.006mol/L,制备的ZnO薄膜从只出现一个380nm(对应的光学禁带宽度为3.27eV)左右的吸收边到在380和320nm(对应的光学禁带宽度为3.76eV)左右各出现一个吸收边,并且随着ZnO溶胶浓度的降低,在380—320nm波段内的透过率明显提高.而Z 关键词： 纳米ZnO 2复合薄膜')" href="#">ZnO-SiO₂复合薄膜 溶胶凝胶法 透射率     

针孔辅助点投影诊断方法实验研究

针孔辅助点投影背光成像是近几年国外新兴的等离子体诊断技术,在惯性约束聚变相关物理实验诊断中具有重要的应用前景.为验证这一诊断方法的实用性,在神光Ⅱ第九路平台上开展了演示实验.利用激光驱动平面Ti靶获得约4.7 keV的Ti K壳层X射线,在十几微米的针孔约束下作为次级点源并对Au栅格样品投影成像,并用CCD记录.实验成功获得了清晰的样品二维空间分辨的时间积分图像,空间分辨力优于16.1 μm.实验结果表明针孔辅助点投影具有较高的空间分辨力、较大的视场、较高的图像对比度,将成为瑞利泰勒不稳定性研究、激光状态方程研究等物理实验的重要诊断方法之一.     

372-mJ long pulse pyrotechnically pumped laser

A pyrotechnically pumped Nd glass laser is demonstrated by the use of pyrotechnic flashlamps composed of several chemical materials arranged in a stable plane concave resonator cavity. The flashlamp was made of chemical mixture with oxidant, fuel, and binder. The emission spectrum of pyrotechnic flame covered most of the absorption bands of Nda＋ in phosphate glass. Under 4.56-g chemical mixture pumping, long pulse output power of about 5.5 W was achieved.     

低速/微振动测量实验中的激光多普勒频移计算机测量方法

基于实验教学使用的迈克耳孙干涉仪开发出的低速/微振动测量实验系统,给出了一种激光多普勒频移的计算机自动测量方法,并通过大量的比较实验数据,验证了激光多普勒频移计算机自动测量方法的有效性.     

超导电缆的性能检测方法研究

超导电缆与常规电缆在电磁特性上有很大差异。因此,有必要对其试验内容、性能检测方法和试验设备进行研究和规范。文中从超导电缆的电磁特性出发,探讨了超导电缆的试验内容及性能检测方法,并重点介绍了超导电缆交流损耗的测量方法。     

不同型线离心风机叶轮的性能对比研究

本文分别对采用常规单圆弧叶片和等减速叶片两种不同型线叶轮的离心风机进行了试验研究,并做了整机全工况数值模拟计算.流场分析表明:应用等减速流型设计的离心风机,其叶轮内部的流动损失小,压力梯度变化更规律,叶轮出口的射流-尾迹结构较弱,出口速度场均匀且最大速度值较低.所以,等减速流型设计的叶轮,其流动损失、扩压损失、出口混合损失以及出口截面突变损失均比较小,效率较高.     

Calculation of the reactor neutron time of flight spectrum by convolution technique

It is a very complex and time-consuming process to simulate the nuclear reactor neutron spectrum from the reactor core to the export channel by applying a Monte Carlo program. This paper presents a new method to calculate the neutron spectrum by using the convolution technique which considers the channel transportation as a linear system and the transportation scattering as the response function. It also applies Monte Carlo Neutron and Photon Transport Code （MCNP） to simulate the response function numerically. With the application of convolution technique to calculate the spectrum distribution from the core to the channel, the process is then much more convenient only with the simple numerical integral numeration. This saves computer time and reduces some trouble in re-writing of the MCNP program.     

基于仪器线型订正的开放光程FTIR测量中的水汽谱在线扣除方法

水汽吸收分布于整个中红外波段,它的存在干扰红外光谱的定量分析。文章介绍了一种从傅里叶变换红外光谱仪的测量数据中扣除水汽干扰信号的新方法。该方法首先通过气象参数测量获得气压、温度和相对湿度,结合HITRAN数据库中提供的水汽线强、自展宽、空气展宽等参数,使用逐线积分方法计算出高分辨率水汽吸收谱,再通过仪器线型订正,合成出与仪器分辨率相匹配的水汽谱,将其作为干扰组分直接从测量所得到的含有水汽的混合光谱中扣除。对开放光程FTIR系统的实测数据的分析结果表明,使用该方法可以有效消除水汽干扰,扣除后的光谱包含待测组分的吸收特征和噪声。在开放光程FTIR等无法使用干燥设备去水的观测条件下,使用该方法可以达到较理想的水汽扣除效果。     

Temperature dependent phonon modes and ionicity of LiGaO2 single crystal

This paper reports that polarized far-infrared reflectivity measurements have been done on LiGaO2 single crystal along two crystalline taxes at different temperatures. The temperature dependent frequencies of the longitudinal and transverse optical phonon have been obtained from the real part of optical conductivity and the loss function respectively. A small Drude component is observed at frequency below 300 cm^-1 which could arise from Li ions or oxygen deficiencies. The ionicity of LiGaO2 has been studied from the analysis of the Born effective charge of different ions.     

A closer look into DESIRE for NMR microscopy

The major challenge of nuclear magnetic resonance (NMR) microscopy at a spatial resolution of a few micrometers is to obtain a sufficiently high signal-to-noise-ratio (SNR) within a reasonable measurement time. As a particular difficulty, molecular self-diffusion poses a serious limitation to true spatial resolution and SNR if conventional Fourier encoding techniques are used. Opposed to that, the alternative DESIRE (Diffusion Enhancement of SIgnal and REsolution) approach to NMR microscopy utilises diffusion to increase the SNR. Being a real-space imaging method, spatial localisation is accomplished by saturation pulses while diffusion continuously replaces the saturated by unsaturated spins. For this technique a signal enhancement of up to three orders of magnitude has been predicted and initial experimental data have provided a proof of principle. In the present work, a detailed investigation of one-dimensional (1D) DESIRE is presented including simulations of a real implementation of the method, a quantitative experimental analysis, and basic 1D imaging. The simulations reveal the importance and provide the means of ensuring the true spatial resolution for this particular way of localisation, enable the selection of useful experimental parameters, and predict the specific image contrast to be expected around barriers restricting diffusion. Experimental data are presented with resolutions down to 3 microm and DESIRE enhancement up to 25 that are in good agreement with the simulation results. In particular, 1D DESIRE imaging in a phantom confirms the expected signal drop close to barriers due to spatially restricted diffusion.