Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

Melt rheology of polylactide/montmorillonite nanocomposites

In this article, the linear and nonlinear shear rheological behaviors of polylactide (PLA)/clay (organophilic‐montmorillonite) nanocomposites (PLACNs) were investigated by an Advanced Rheology Expanded System rheometer. The nanocomposites were prepared by master batch method using a twin‐screw extruder with poly(ε‐caprolactone) (PCL) as a compatibilizer. The presence of org‐MMT leads to obvious pseudo‐solid‐like behaviors of nanocomposite melts. The behaviors caused by the formation of a “percolating network” derived from the reciprocity among the strong related sheet particles. Therefore, the storage moduli, loss moduli, and dynamic viscosities of PLACNs show a monotonic increase with MMT content. Nonterminal behaviors exists in PLACNs nanocomposites. Besides the PLACNs melts show a greater shear thinning tendency than pure PLA melt because of the preferential orientation of the MMT layers. Therefore, PLACNs have higher moduli but better processibility compared with pure PLA. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3189–3196, 2007     

白光干涉条纹变密的原因探讨

讨论了在测定透明介质折射率的过程中彩色条纹变密的现象，并在其基础上分析其成因：一是由于媒质折射率加大；二是由于平形板介质平行度不好造成楔形的倾角变大，最后在实验中验证了理论结果。     

求解非对称线性方程组的QMRGCGS方法

1 引言 求解非对称线性方程组Ax=b的双共轭梯度方法(BCG)[3]和它的变形共轭梯度平方方法(CGS)[6]都有典型的不规则收敛行为,后来Freund和Nachtigal提出一种BCG类方法,即拟极小剩余方法(QMR)[7],用来补救BCG方法的收敛性并且产生了光滑的收敛曲线。然而,象BCG方法一样,QMR方法要用到系数矩阵A及其转置A~T与向量的乘积,为了解决这一问题,Freund提出TFQMR方法,此方法具有拟极小剩余性,同时不需用到A~T与向量的乘积。     

常规投资项目的外部收益率研究

揭示了常规投资项目外部收益率的实质 ,明确了常规投资项目外部收益率的缺陷 .研究表明 ,在实际工作中 ,不宜用外部收益率替代内部收益率进行常规投资项目的经济性分析评价     

Photo-induced effect in the layered perovskite manganite La<Subscript>1.2</Subscript>Sr<Subscript>1.8</Subscript>Mn<Subscript>1.8</Subscript>Co<Subscript>0.2</Subscript>O<Subscript>7</Subscript>

It is helpful to study the photo-induced effect in the perovskite manganites not only for elucidating the mechanism of colossal magnetoresistance (CMR) effect but also for potential applications in technology. The laser-induced effect in the Co doping layered perovskite manganites La_1.2Sr_1.8Mn_1.8Co_0.2O₇, is studied in this paper and the obtained results are also compared with that gained in the Nd-doping manganites with cubic perovskite structure.     

Reduction of dislocation density and improvement of optical quality in ZnO layers by MgO-buffer annealing

Optical properties of ZnO thin films with/without MgO-buffer annealing were investigated by low and room temperature photoluminescence measurements. The ZnO films were grown on c-sapphire substrates by plasma-assisted molecular-beam epitaxy employing a thin MgO-buffer layer. Dislocation density of ZnO layer was reduced from 5.3 × 10⁹ to 1.9 × 10⁹ cm⁻² by annealing MgO-buffer prior to the growth of ZnO. The intensity of free exciton emission from the sample with MgO-buffer annealing was almost twice of that from the sample without annealing, while the deep level emission from the sample with MgO-buffer annealing was about 1/3 of that without annealing. The MgO-buffer annealing improves optical quality of overgrown ZnO films.     

Experimental 511 W Composite Nd：YAG Ceramic Laser

We demonstrate a 511 W laser diode pumped composite Nd：YAG ceramic laser. The optical pumping system is consisted of five laser diode stacked arrays arranged in a pentagonal shape around the ceramic rod whose size is φ6.35×144mm. When the pumping power is 1600 W, the cw laser output up to 511 W at 1064nm can be obtained with a linear piano-piano cavity, and the optical-to-optical efficiency is 31.9%. To our knowledge, this is the highest value of laser output by using a newly invented composite Nd：YAG ceramic rod as the gain medium.     

Optical characterization of CdTe/ZnSe fractional monolayer structures grown by atomic layer epitaxy

Luminescence properties of CdTe/ZnSe fractional monolayer grown by atomic layer epitaxy have been investigated. To investigate the origin of the highly efficient luminescence, various optical spectroscopic methods such as, photoluminescence (PL), temporal/spatial resolved PL, temperature dependence PL, and excitation power dependence PL have been used. It is found that structural inhomogeneities affect dominant influence on the line width and line shape of luminescence. The luminescence intensity greatly enhanced by the localization of exciton at the disorder induced localized states.     

Lanthanide Complexes for Oligomerization of Phenyl Isocyanate

IntroductionThestudyonthereactivitiesoflanthanidecomplexesto wardisocyanateshasattractedmuchattention .Ithasbeenre portedthatlanthanidealkoxides,1anddivalentdiaza pentadi enyllanthanidecomplexes2 canbeusedasthesinglecompo nentinitiatorsforisocyanatespolymerization .Recentlyourre searchgrouphasalsofoundthatlanthanoceneamide ,3diva lentaryloxideofsamarium4 ,5anddivalentsamarocene6 areallactivefortheoligomerizationofphenylisocyanate,andtheactivespeciesforthesethreesystemswereallsuccessfullyisolat…