4-Aminobicyclo[2.2.2]octanone Derivatives with Antiprotozoal Activities

Summary.  4-Aminobicyclo[2.2.2]octanones which were prepared in one-pot-reactions from benzylidene acetone and dialkylammonium rhodanides were reduced stereoselectively to their corresponding alcohols. The activities of the bicyclic compounds against causative organisms of tropical deseases were examined. The 4-aminobicyclo[2.2.2]octan-2-ols were in general more active against Trypanosoma b. rhodesiense and Plasmodium falciparum than the corresponding keto compounds. Corresponding author. E-mail: robert.weis@uni-graz.at Received November 27, 2002; accepted December 2, 2002 Published online May 2, 2003     

Electrochromic properties of WO<Subscript>3</Subscript> and WO<Subscript>3</Subscript>:P thin films

WO₃ and WO₃:P (5 mol% H₃PO₄) thin films were prepared using the sol-gel route and the electrochromic properties of the films were investigated using in situ spectroelectrochemical methods. The measurements were performed in propylene carbonate solution with 0.1 M LiClO₄ as electrolyte. During the cathodic polarization at –0.8 V a blue coloration is observed with a reversible variation between 14% and 84% of the transmittance at λ=633 nm. The kinetics for the bleaching process is faster for the WO₃:P film than for the undoped WO₃ film. Electronic Publication     

Di‐2‐pyridyl ketone N4,N4‐(butane‐1,4‐diyl)thiosemicarbazone

The title compound, C₁₆H₁₇N₅S, is in the thione form and crystallizes with two independent mol­ecules in the asymmetric unit. In both mol­ecules, the penta­methyl­ene­imine five‐membered ring adopts an envelope conformation, and in one of the molecules this ring shows positional disorder. The thione S and hydrazine N atoms are in the Z configuration with respect to the C—N bond.     

In Situ Monitoring of Generation and Precipitation of Ferric Hydroxide Sol with a Piezoelectric Quartz Crystal Impedance Analyzer

The piezoelectric quartz crystal (PQC) impedance technique was applied to monitor in situ generation and precipitation of the ferric hydroxide sol in aqueous solutions at 90 degrees C. Equivalent circuit parameters and resonant frequencies as well as the half-peak width of the electroacoustic conductance spectrum deltaf(G1/2) for the PQC resonance were obtained and analyzed. Three stages, sol generation and simultaneous adsorption, adsorption equilibrium, and precipitation of ferric hydroxide sol could be identified in the process of adding the ferric nitrate solution into the hot water. A scheme of two consecutive reactions occurring at the electrode/solution interface was used to analyze the adsorption kinetics of ferric hydroxide sol onto the Au electrode. In addition, the electrolyte-induced precipitation of the colloid was monitored and discussed. Temperature effect on the PQC resonance behavior in liquid was also investigated. Since the PQC impedance technique provides multidimensional piezoelectric information in situ, it is highly recommended for studying the process of sol-gel generation and precipitation. Copyright 2001 Academic Press.     

Metal Nanoparticles on Stainless Steel Surfaces as Novel Heterogeneous Catalysts

The goal of this work was the development of a novel type of heterogeneous catalyst, consisting of bare metal nanoparticles on stainless steel foils, which can be shaped to any kind of architecture and, if necessary, heated electrically. Solutions of pre-prepared, ligand protected and monodispersed gold, palladium, platinum and rhodium nanoparticles were sprayed onto stainless steel foils, followed by the careful removal of the ligand molecules by an oxygen plasma treatment. Due to this, bare particles become irreversibly fixed on the steel support. It could be shown that the original particle sizes do not change during the plasma treatment. Foils, densely coated with the nanoparticles, were used for gas phase catalyses in a self-made reactor at room temperature or at 60 °C. Hydrogenation of 1,3-butadiene at 15 nm Pd and 2 nm Pt, CO oxidation at 16 nm, 8 nm and 1.4 nm gold and NO reduction with NH₃ at 2 nm Rh particles were performed, indicating that the novel catalysts might in principle be applicable in technical processes if the experimental conditions like form and temperature would be optimized. Dedicated to Professor Dieter Fenske on the occassion of his 65th birthday.     

Chemical constituents from the roots of <Emphasis Type="Italic">Polygonum bistorta</Emphasis>

Investigation of the roots of Polygonum bistorta L. afforded seven compounds including five triterpenoids, a coumarin, and a steroid, the structures of which were identified by EIMS, ¹H NMR, ¹³C NMR, DEPT, and HMBC experiments. All the compounds have been isolated from Polygonum genus for the first time. Published in Khimiya Prirodnykh Soedinenii, No. 5, pp. 463–465, September–October, 2007.     

Formation of α-Mn2O3 nanorods via a hydrothermal-assisted cleavage-decomposition mechanism

A hydrothermal cleavage-decomposition mechanism was used to synthesize single-crystal α-Mn₂O₃ nanorods at 160 °C for 16 h using KMnO₄ as manganese source and CTAB as reducing regent. The as-synthesized products were characterized by powder X-ray diffraction, transmission electron microscopy, high-resolution transmission electron microscopy and infrared spectrum. The results indicate that the reaction temperature is a crucial factor for the formation of α-Mn₂O₃ nanorods. These nanorods exhibit single-crystal nature, and have an average diameter of 36 nm and lengths of up to 1 μm. Based on our experimental results, a hydrothermal cleavage-decomposition mechanism has been proposed on the formation of α-Mn₂O₃ nanorods.     

Synthesis and characterization of cobalt(II), nickel(II), copper(II), palladium(II) and dioxouranium(VI) complexes of the antipyrine Schiff base of 3-formylsalicylic acid

A new Schiff base has been synthesized from 4-aminoantipyrine and 3-formylsalicylic acid. The ligand has a dianionic tetradentate compartmental OONO donor system. The cobalt(II), nickel(II), copper(II) and dioxouranium(VI) complexes exist in phenolato-bridged dinuclear species, while palladium(II) gives a mononuclear complex with free –COOH groups. The complexes have been characterized by elemental analyses, i.r., u.v.-vis, thermal and magnetic measurements.     

Carboxylic Acids from <Emphasis Type="Italic">Phyllanthus urinaria</Emphasis>

Five compounds, terephthalic acid mono-[2-(4-carboxy-phenoxycarbonyl)-vinyl] ester (1), (E)-3-(5′-hydroperoxy-2,2′-dihydroxy[1,1′-biphenyl]-4-yl)-2-propenoic acid (2), 3,4,5-trihydroxybenzoic acid (3), succinic acid (or butanedioic acid) (4), and 2,3,4,5,6-pentahydroxybenzoic acid (5), were isolated from Phyllanthus urinaria. The structures of these compounds were elucidated by means of spectral techniques including IR, MS, and 1D/2D NMR. 1 and 2 are new compounds.__________Published in Khimiya Prirodnykh Soedinenii, No. 1, pp. 14–17, January–February, 2005.     

Sol–gel preparation and properties of hydroxypropylcellulose–titania hybrid thin films

Hydroxypropylcellulose (HPC)–titania hybrid thin films were prepared by sol–gel method where titanium tetraisopropoxide Ti(OC₃H₇ ⁱ )₄ was hydrolyzed under acidic conditions in the presence of HPC, followed by dip-coating and drying at 120 °C for 24 h. The viscosity average molecular weight of HPC was 55,000–70,000 or 110,000–150,000, and the TiO₂/(HPC + TiO₂) mass ratio ranged from 0 to 1, which was calculated on the assumption that all Ti(OC₃H₇ ⁱ )₄ is converted into TiO₂. The films were 0.35–1.0 μm thick, transparent in visible region and opaque in ultraviolet (UV) region, where the optical absorption coefficient in UV region increased with increasing titania content. The refractive index increased with increasing titania content, ranging from 1.6 to 1.8 for the hybrid thin films. The pencil hardness increased from 6B to 5H, the durability in hot water significantly increased and the contact angle of water on films increased from 35° to 89° with increasing titania content. Crack-free films could be deposited on organic polymer substrates irrespective of titania or HPC contents, where cracking did not occur at higher HPC contents even when the substrate was bent.