Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

The performance of uspported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investgated.An evaluation of the catalysts indicates that bulk molybdenum carbied has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products.The rapid deactivation of the catalyst is also a significant problem.However,the supported molybdenum carbide catalyst shows a much higher methane conversion,increased selectivity and significantly improved catalytic stability.The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier.The bulk or the supported molybdenum carbide exists in the β-Mo2C phase,while it is transformed into molybdenum dioxide postcatalysis which is an improtant cause of molybdenum carbide deactivation.     

笼形聚氨肟树脂的研究：碱处理对吸附性能的影响

研究碱处理的笼形聚氨肟树脂（ＢＣＡＯ）对二价金属离子的吸附行为。吸附结果若生成２：１配的，得Ｍｇ＾２＋，Ｃａ＾２＋，Ｂａ＾２＋，Ｍｎ＾２＋，Ｃｏ＾２＋，Ｎｉ＾２＋，Ｚｎ＾２＋，Ｃｄ＾２＋，Ｐｂ＾２＋，Ｃｕ＾２＋离子的吸附效率分别是２７．１、２９．２、３０．４、２９．０、２７．１、３０．８、４５．０、３９．８、６０．３、６２．１％，Ｈｇ＾２＋离子的吸附效率高达１０５％，表明在吸附过程中同时生成２：１     

Preparation and properties of polyarylates from 5-t-butylisophthaloyl chloride and various bisphenols

Polyarylates containing a t-butyl pendant group were prepared from 5-t-butylisophthaloyl chloride and various bisphenols through the phase-transfer catalyzed two-phase polycondensation. The polyarylates having inherent viscosities up to 3.1 dL/g were obtained quantitatively. They were readily soluble in various solvents such as chloroform, m-cresol, and pyridine. Coloreless, transparent, and flexible films could be cast from the chloroform solutions of the polymers. The polyarylates had glass transition temperatures between 210 and 320°C, and did not lose weight below 350°C, with 10% weight loss being recorded at 395–450°C in air.     

脊髓小脑变性疾病病人血清铜,锌,铝,铁含量的研究

脊髓小脑变性疾病（ＳＣＤ）的病因可能与遗传、神经生化紊乱、感染、微量元素平衡障碍及自由基损伤等因素有关，其中微量元素平衡障碍的研究具有重要意义。检测了ＳＣＤ中发病率较高的橄榄桥小脑萎缩症（ＯＰＣＡ）及晚发性小脑皮质萎缩症（ＬＣＣＡ）病人１５例血清中铜、锌、铝、铁等微量元素含量。发现病人比对照组铜明显降低，Ｐ〈０．０１；锌明显降低，Ｐ〈０．０１；铝明显升高，Ｐ〈０．０１；铁无明显差别。     

过敏性哮喘患者血清中10种必需微量元素水平的研究

３４例过敏性哮喘患者血清中铁，锌、铜，锰硒铬，钴镍，钡，钼的含量水平与对照组比较，揭示：（１）铁，铜，铬的含量升高；（２）硒，镍，钴、钒的钼的含量降低；（３）锌和锰的含量差异无显著性，Ｐ〉０．０５。     

Exposure dose assessment and discussion on radioisotope production and application

The exposure dose status on radioisotope production and application in China has been assessed in the paper. The average annual occupational exposure dose received by workers in the radioisotope production is about one tenth of the annual dose limit in normal situation. It is less than one twentieth for workers in the radioisotope applications. However, the annual collective dose for the latter is higher than the former by one oder of magnitude due to the larger number of workers in the application field. Although the output of radioisotopes increased doubly in 1980's as compared with 1970's, the increase on the annual collective dose was not obvious. For exposure to the public,¹³¹I for example, the collective dose in the radioisotope production decreased by one to two orders of magnitude and the releasing factor reduced by two orders of magnitude. Therefore, the exposure dose received by workers in radioisotope production and application is lower in normal situation. However, the facts worth paying attention to are that there were many events and accidents which happened in the radioisotope applications, especially at the irradiation facilities. The probability of fatal accident was as high as 10^–3 per irradiator year. In order to improve the radiation safety situation, it is imperative to conduct the safety assessment for irradiation facilities, to enhance management of the radioactive wastes and spent sources and to establish the experience feedback system.     

X射线荧光光谱法在稀土元素分析中的应用

本文研究了Ｘ射线荧光光谱在混合稀土氧化物和高纯稀土氧化物分析中的应用，并探讨了在常量分析中影响分析准确度和精密度的主要因素；样品及标样制备，基体效应校正方法在痕量分析中降低检测限的方法，选择最佳测量条件，降低背景，与分离富集手段相结合，取得满意的结果。     

Microcalorimetric investigation of the growth of the <Emphasis Type="Italic">Escherichia coli</Emphasis> DH5α in different antibiotics

The effects of Amoxicillin Sodium and Cefuroxime Sodium on the growth of E. coli DH5α were investigated by microcalorimetry. The metabolic power-time curves of E. coli DH5α growth were determined by using a TAM air isothermal microcalorimeter at 37°C. By evaluation of the obtained parameters, such as growth rate constants (k), inhibitory ratio (I), the maximum heat power (P _m) and the time of the maximum heat power (t _m), one found that the inhibitory activity of Amoxicillin Sodium vs. E. coli DH5α is enhanced with the increasing of the Amoxicillin Sodium concentration, and the Cefuroxime Sodium has a stimulatory effect on the E. coli DH5α growth when the concentration is about 1 μg mL⁻¹. The IC₅₀ for the Amoxicillin Sodium and the Cefuroxime Sodium are 1.6 and 2.0 μg mL⁻¹, respectively, it implicates that the E. coli DH5α is more sensitive to Amoxicillin Sodium than Cefuroxime Sodium.     

离子交换色谱法检测离子液体中阴离子

建立了用阴离子交换分离柱、化学抑制模式、电导检测测定系列离子液体中BF-4阴离子及其他杂阴离子(F-、Cl-、Br-)含量的方法,并用于在线监控离子液体合成工艺中阴离子杂质含量.确定淋洗液组成为1.6 mmol/L Na2CO3+3.9 mmol/L NaHCO3,流速为0.6 mL/min.本方法对所测阴离子检出限分别为50 μg/L(F-、Br-)和80 μg/L(BF-4);线性范围在3个数量级以上;r＞0.999;回收率在98%～102%之间.方法用于对离子液体小试工艺样品分析及过程监控时,结果满意,样品的RSD小于2.6%(n＝6).     

Highly photoluminescent multilayer QD-glass films prepared by LbL self-assembly

A novel and facile preparation method for layer-by-layer (LbL) self-assembled films incorporating quantum dots (QDs) and having intense photoluminescence (PL) from blue to red is presented. Functional sol-gel-derived glass layers prepared by the hydrolysis of 3-aminopropyltrimethoxysilane (APS) or 3-mercaptopropyltrimethoxysilane (MPS) have been used as a linkage between QD layers. Absorption, PL spectroscopy, transmission electron microscopy, and atomic force microscopy were employed for characterization, which revealed that the QDs in the prepared films had a nearly close-packed coverage and were not aggregated. The PL efficiencies of the QDs (CdTe or ZnSe, both are thioglycolic acid-stabilized) dispersed in the films were roughly half that of the initial colloidal solutions but reached 24% before a refractive index correction. The thickness of the red-emitting film with 10 CdTe QD layers was approximately 50 nm. The concentration of QDs in the film derived from the first absorption peak was approximately 0.01 M. Because the PL starts to show a red shift, the obtained concentration is practically the ultimate one in the glass matrix. The mercapto, amino, and carboxyl groups play important roles in LbL self-assembling processes.