Binary colloidal crystals with a wide range of size ratios via template-assisted electric-field-induced assembly

Here we present a simple but general method for constructing complex binary colloidal crystals with an almost full range of size ratios, which is referred to as "template-assisted electric-field-induced assembly (TAEFIA)". The dependence of the structures of binary colloidal crystals on size ratio (gamma) and volume fraction (varphi) of the colloidal suspension was investigated. Binary colloidal crystals with gamma ranges from 0.10 to 0.91 were fabricated, and an attempt to fabricate a triple colloidal crystal via TAEFIA was presented. We suggest that TAEFIA is a versatile way to grow colloidal crystals with binary or more complex structures.     

Cu-catalyzed cross-couplings under ligandless conditions

The possibility to carry out Cu-catalyzed cross-couplings under ligandless conditions was studied.It was found that by using K_3PO_4 as the base,the cross-coupling could proceed successfully between aryl iodides and several types of nucleophiles.Aryl bromides were completely inactive under the same reaction conditions.     

Relation between the permeability and the degree of coil overlap of polymer in the bulk state

Based on the expression of the index of coil interpenetration (i.e.,the degree of coil overlap,ξ_b) of amorphous polymers in the bulk state proposed by Qian,theξ_b was rewritten asξ_b=ρ_b[η]_θ/1.66 via Flory's intrinsic viscosity equation at them conditions.Theξ_b ofpoly (vinyl chloride) (PVC) dense membranes with different molecular weights and cellulose diacetate (CA) dense membranes prepared using different solvents were determined.The permeability,permeation coefficient (P) of nitrogen and permeation flux (J) of liquid through both membranes,respectively,was measured.P and J decreased exponentially with increasingξ_b for PVC and CA membranes were revealed.     

紫外光度法间接测定脱脂乳中的芽孢数量

为了有效控制乳制品生产过程、保证质量,克服芽孢杆菌传统计数方法周期长的缺点,本实验通过分光光度法检测芽孢中特异性物质2,6-吡啶二羧酸(DPA)。根据DPA浓度与芽孢数量的关系,建立了快速检测脱脂乳中芽孢数量的方法。本研究对脱脂乳及其芽孢处理、DPA释放及采用紫外分光光度法检测做了研究。通过准确度和加标回收率检验,建立DPA含量与芽孢数的线性关系,回归方程为y=0.2084x-0.9363,r=0.6998,经验证可有效估测脱脂乳中芽孢数量(P<0.05)。     

N-苯基苯二甲酰亚胺和2-苯基喹噁啉晶态分子动力学行为研究

本文在晶体结构分析的基础上, 对二个芳香杂环高聚物模型化合物N-苯基苯二甲酰亚胺和2-苯基喹噁啉分子的原子热振动参数进行分析, 结果表明N-苯基苯二甲酰亚胺晶态分子基本上为刚性分子, 而2-苯基喹噁啉分子的热振动应包含分子内取代苯基的内旋转运动, 其平均平方振幅为53(25) deg~2。     

乙基乙酰胺热解反应机理的MO研究

对于烷基乙酰胺的初始热解反应机理, 通常认为与酯类的热解反应相类似。Maccoll和Nagra通过对该热解反应的动力学研究, 认为两者存在不同。差异之一, 烷基乙酰胺存在两种可能的热解途径【参见本文(129页)前述反应方程(1),(2)】。而在酯类热解反应中(2)的活化能过高, 且四元环过渡态极不稳定。差异之二, 极性溶剂(比如乙酸)对酰胺热解反应的催化作用不明显, 而对酯类等气相热解反应的催化作用是十分显著的。为此, 我们用MINDO/3分子轨道法对乙基乙酰胺的初始热解反应进行了较全面的研究。用能量梯度法对此反应的反应物、中间体和生成物的平衡几何构型进行了全优化。(如图1所示)用极小能量途径法分别寻找反应(1)和反应(2)的初始过渡态, 继而用Powell法全优化过渡态的几何构型, 计算所得的过渡态TS1、TS2和TS3分别见图2a, 图3a和图4a。为了确证这些过渡态, 进行了振动分析研究, 结果表明这些过渡态的力常数矩阵的诸本征值中均只有一个负值, 且虚振动模式展示了走向各自的反应物和生成物的趋势, (如图2b,图3b和图4b所示)。它们的总能量及反应(1)和反应(2)的活化能列于表1. 对整个热解反应(1)作了内禀反应坐标(IRC)理论分析, 反应历程见图5所示. 与IRC相应的总能偶极矩以及部分关键的键长和原子净电荷变化一并列于表2.本文研究结果表明, 在乙基乙酰胺的初始反应中主反应即反应(1)与酯类反应相类似, ...     

测定晶体结构的系统试差法的研究(II)系统位相超解方程得改进

本文证明了|E(k)E(h-k)|的大小是由结构决定的。与原点无关, 在这种认识的基础上, 提出了用归一化结构振幅|E|估量它的三种模式。特别是通过四位相结构不变量的二级Noighborhood~[1,2]原理解决三位相不变量间的匹配问题而算出的|E(k)E(h-k)|_(QE), 这是在没有位相数据的情况下对它的理想的估量。予期它能改进系统试差法中位相超解方程的功能, 提高测得位相的准确性。     

用铜物理显影的多级放大成像过程 Ⅰ.影像强化和节银效应

感光乳剂中卤化银颗粒接收足够的曝光量后可形成潜影,经过显影便成为可见影像。这个过程可以看作是第一级放大。它的放大因子为10~9。但是影像的密度取决于单位面积上显出的银量和银影像的遮盖本领。如果单位面积上显出的银颗粒太少,影像就不能被眼睛或仪器(如密度计)检测出来。单位面积上银颗粒太少可由两个原因造成的:或是因为曝光量太低以致具有可显潜影的颗粒太少;或是因为乳剂层中卤化银颗粒本来就太少。