Parathyroid hormone and bone mineral content in male and female patients receiving hemodialysis

Relative bone mineral content in the lumbar spine was measured by phantom B-MAs with the apparatus of computerized tomography in order to study the relationships between bone mineral content with age and parathyroid hormone in sera of randomized out- and in-patients and the hemodialysis patients. There exists a significant difference between male and female in the loss of bone mineral content of three groups.     

Aqueous Titanate Sols from Ti Alkoxide-α-Hydroxycarboxylic Acid System and Preparation of Titania Films from the Sols

Aqueous titanate sols were prepared by reactions of titanium tetraisopropoxide (TIP) with -hydroxycarboxylic acids in water. IR and Raman spectra, and elemental analyses of the precipitates obtained from the sols revealed that the carboxylates were chelated to titanium but the Ti species were polymerized to form a cluster that had a colloidal nature. Spin-coating of titania (TiO₂) thin films from these sols was also examined. Interestingly, it was found that (004) preferentially oriented anatase films with refractive index of 2.54 were obtained from TIP-lactic acid-NH₃ (1:1:1, molar ratio) aqueous sol. This crystallographic orientation was characteristic of the TIP-lactic acid-NH₃ (1:1:1) system, and was not affected by the kinds of substrates used and the heating rate of the film. TEM observation indicated that small anatase grains had already formed at 200°C. Therefore, the crystallographic orientation might depend strongly on the structure of the chemical species of the precursor solutions.     

(2,7-Disubstituted-1,8-biphenylenedioxy)bis(dimethylaluminum) as bidentate organoaluminum Lewis acids: elucidation and synthetic Utility of the double electrophilic activation phenomenon

A series of (2,7-disubstituted-1,8-biphenylenedioxy)bis(dimethylaluminum) (2) has been readily prepared in situ by treatment of the requisite 2,7-disubstituted-1,8-biphenylenediol (1) with Me3Al (2 equiv) in CH2Cl2 at room temperature; this primarily relies on the successful establishment of a new synthetic procedure of 1 starting from inexpensive m-anisidine. Evaluation of 2 as a bidentate organoaluminum Lewis acid has been performed by the reduction of ketonic substrates using Bu3SnH as a hydride source in comparison to the conventional monodentate Lewis acid dimethylaluminum 2,6-xylenoxide (11), uncovering the significantly high activation ability of 2 toward carbonyl. Particularly, (2,7-dimethyl-1,8-biphenylenedioxy)bis(dimethylaluminum) (2a) exerted the highest reactivity, which has also been emphasized in the Mukaiyama aldol reaction. The structure of the bidentate Lewis acid 2 was unambiguously determined by single-crystal X-ray diffraction analysis of 2g possessing a bulky 3,5-di-tert-butylphenyl substituent, revealing the rigid dimeric assembly in the solid state. The double electrophilic activation of carbonyl substrate by 2a has been supported by low-temperature 13C NMR analysis as well as theoretical study using the Gaussian 98 program. Moreover, unique stereoselectivity has been observed in the 2a-promoted Mukaiyama Michael addition, and highly chemoselective functionalization of carbonyl compounds in the presence of their acetal counterparts has been realized using 2a. Finally, the effectiveness of 2a for the activation of ether functionality has been demonstrated in the Claisen rearrangement of allyl vinyl ethers.     

Separation and simultaneous determination of cobalt, nickel and copper with 2-(4-methyl-2-quinolylazo)-5-diethylaminophenol by reversed-phase high-performance liquid chromatography

Performance of six quinolylazo compounds was studied as a pre-column derivatizing reagent for the separation of metal ions in the reversed-phase high-performance liquid chromatography. 2-(4-Methyl-2-quinolylazo)-5-diethylaminophenol (QADP) was suited for the determination of Co, Ni and Cu in the presence of a large amount of Fe. The detection limits under the optimized conditions [stationary phase: L-column ODS; mobile phase: acetone-water (62:38, v/v) containing 0.01 M NH(4)SCN and 0.01 M 2-morpholinoethanesulfonic acid-NaOH (pH 6); injection volume: 10 mul] were 0.24 ng for Co, 0.22 for Ni and 0.53 for Cu. This method was successfully applied to the determination of these metal ions in a standard steel sample.     

On-line measurement of intramolecular carbon isotope distribution of acetic acid by continuous-flow isotope ratio mass spectrometry

Molecular and intramolecular carbon isotope measurements of acetic acid present in natural environments have been performed by off-line procedures. The off-line method is complicated and time-consuming and requires micromolar to millimolar amounts of sample. This limits geochemical isotopic studies, especially at the intramolecular level, on acetic acid present in natural samples. Here, we examine an on-line measurement of intramolecular carbon isotope distribution of acetic acid using continuous-flow isotope ratio mass spectrometry (CF-IRMS) coupled with an on-line pyrolysis system. This is achieved by measurement of the respective carbon isotope ratios of CH4 and CO2 produced by on-line pyrolysis of acetic acid. Results for authentic standards of pure acetic acid demonstrated the practicality of this on-line method, although the carbon isotope ratio of the methyl group could not be determined directly. The precision of the carbon isotope measurements was 0.4 per thousand (1sigma). The carbon isotope distribution determined by the on-line method was identical to that determined by the conventional off-line method within analytical error. The advantages of the on-line method compared with the conventional off-line method are that it is less laborious, requires less analytical time (less than one hour per sample) and, most importantly, uses smaller sample sizes (ca. 10 nanomole). An application of this on-line method to natural geochemical samples will provide an insight into the geochemical cycle of acetic acid.     

Efficient regioselective aldol condensation of methyl ketones promoted by organoaluminum compounds,and its application to muscone synthesis

Regioselective aldol condensation of 2-octanone and 2-butanone at the methyl side proceeded in high yields using a system of dialkylaluminum phenoxide/tertiary amine. The intramolecular aldol condensation of 2,15-hexadecanedione was carried out by the same system, especially di-i-butylaluminum phenoxide/pyridine, to give dehydromuscone in 65% yield. Its hydrogenation afforded muscone (3-methylcyclopentadecanone).     

Metal-complex assemblies constructed from the flexible hinge-like ligand H2bhnq: structural versatility and dynamic behavior in the solid state

Novel metal-complex assemblies constructed from the flexible hinge-like ligand H(2)bhnq (H(2)bhnq=2,2'-bi(3-hydroxy-1,4-naphthoquinone)) have been synthesized. The X-ray crystal structures of these compounds reveal that four types of architectures are accessible by variation of the metal ions. In copper(II) compounds 1-3, the chelating bhnq(2-) ions bridge copper(II) centers to form one-dimensional zigzag chains. The chains of 1-3 are arranged by hydrogen-bonding interactions and stacking interactions to produce porous structures. Cobalt(II) and zinc(II) compounds 4 and 5 form one-dimensional helical chains. In 4 and 5, the crystal packing induces spontaneous resolution of the helical chains with chiral cavities formed perpendicular to the helices. Nickel(II) compounds 6 and 7 form cyclic tetramers. The fourth architecture, a dimer (compound 8), is obtained by the reaction of zinc(II) and bhnq(2-) in MeOH. In these compounds, changes of the dihedral angles and the metal-coordination mode of the bhnq(2-) ion induce the structural versatility. The assemblies of the zigzag chains of the copper(II) compounds exhibit reversible vapochromic behavior. UV/Vis, powder X-ray diffraction, EPR, and adsorption isotherm measurements indicate that this vapochromic behavior is based on the hinge-like flexibility of the bhnq(2-) ion.     

Chlorovulones,new halogenated marine prostanoids with an antitumor activity from the stolonifer clavularia viridis Quoy and Gaimard

New halogenated marine prostanoids, chlorovulone I, II and III were isolated from the stolonifer $\text{Clavularia}$$\text{viridis}$ Quoy and Gaimard. The structure elucidation and the antitumor activity of chlorovulones were described.     

Triple hydrogen bonds direct crystal engineering of metal-assembled complexes: the effect of a novel organic-inorganic module on supramolecular structure

Novel triply hydrogen bonded suprastructures based on [M(tdpd)2(L)2]2- (H2tdpd=1,4,5,6-tetrahydro-5,6-dioxo-2,3-pyrazinedicarbonitrile, L=solvent) and melamine-analogous cations have been synthesized and characterized. The use of anions containing two AAA sets from [M(tdpd)2(L)2]2- together with cations containing one DDD set (A=hydrogen-bond acceptor, D=hydrogen-bond donor) leads to the formation of complementary triply hydrogen bonded modules in the solid state. In all cases, the building module is further extended via additional hydrogen-bonding interactions to produce a tape, and tapes are assembled into sheets. These results show that a hydrogen-bonded module consisting of different kinds of building blocks, one of which is a metal complex that includes hydrogen-bond acceptor sites and the other is a hydrogen-bond donor molecule, will be attractive for constructing metal-containing supramolecular systems by the self-assembly technique.     

N-Arylation of 4-fluoro-5-trimethylsilyl-1H-pyrazole

The 1,3-dipolar cycloaddition reaction of fluoro(trimethylsilyl)acetylene prepared in situ with an excess of diazomethane smoothly proceeded to give the corresponding 4-fluoro-5-trimethylsilyl-1H-pyrazole in 84% yield. The copper iodide-catalyzed N-arylation of the fluorinated pyrazole with a variety of aryl iodides afforded N-aryl-4-fluoropyrazoles as desilylation products in good to excellent yields.