Determination of capsaicin and dihydrocapsaicin in Capsicum fruit samples using high performance liquid chromatography

The aim of the present study was to determine the content of capsaicin and dihydrocapsaicin in Capsicum samples collected from city markets in Riyadh (Saudi Arabia), calculate their pungency in Scoville heat units (SHU) and evaluate the average daily intake of capsaicin for the population of Riyadh. The investigated samples consisted of hot chillies, red chillies, green chillies, green peppers, red peppers and yellow peppers. Extraction of capsaicinoids was done using ethanol as solvent, while high performance liquid chromatography (HPLC) was used for separation, identification and quantitation of the components. The limit of detection (LOD) of the method was 0.09 and 0.10 μg/g for capsaicin and dihydrocapsaicin, respectively, while the limit of quantification (LOQ) was 0.30 and 0.36 μg/g for capsaicin and dihydrocapsaicin, respectively. Hot chillies showed the highest concentration of capsaicin (4249.0 ± 190.3 μg/g) and the highest pungency level (67984.60 SHU), whereas green peppers had the lowest detected concentration (1.0 ± 0.9 μg/g); green peppers, red peppers and yellow peppers were non pungent. The mean consumption of peppers for Riyadh city population was determined to be 15.5 g/person/day while the daily capsaicin intake was 7.584 mg/person/day.     

Dubins’ problem on surfaces. I. nonnegative curvature

Let M be a complete, connected, two-dimensional Riemannian manifold. Consider the following question: Given any (p₁,v₁) and (p₂, v₂) in T M, is it possible to connect p₁ to P₂ by a curve y in M with arbitrary small geodesic curvature such that, for i = 1, 2, y is equal to v_i at p_i? In this article, we bring a positive answer to the question if M verifies one of the following three conditions: (a) M is compact, (b) M is asymptotically flat, and (c) M has bounded nonnegative curvature outside a compact subset.     

Rate constants and H atom branching ratios of the gas-phase reactions of methylidyne CH(X2Pi) radical with a series of alkanes

The reactions of the CH radical with several alkanes were studied, at room temperature, in a low-pressure fast-flow reactor. CH(X2Pi, v = 0) radicals were obtained from the reaction of CHBr(3) with potassium atoms. The overall rate constants at 300 K are (0.76 +/- 0.20) x 10(-10) [Fleurat-Lessard, P.; Rayez, J. C.; Bergeat, A.; Loison, J. C. Chem. Phys. 2002, 279, 87],1 (1.60 +/- 0.60) x 10(-10)[Galland, N.; Caralp, F.; Hannachi, Y.; Bergeat, A.; Loison, J.-C. J. Phys. Chem. A 2003, 107, 5419],2 (2.20 +/- 0.80) x 10(-10), (2.80 +/- 0.80) x 10(-10), (3.20 +/- 0.80) x 10(-10), (3.30 +/- 0.60) x 10(-10), and (3.60 +/- 0.80) x 10(-10) cm3 molecule(-1) s(-1), (errors refer to +/-2sigma) for methane, ethane, propane, n-butane, n-pentane, neo-pentane, and n-hexane respectively. The experimental overall rate constants correspond to those obtained using a simple classical capture theory. Absolute atomic hydrogen production was determined by V.U.V. resonance fluorescence, with H production from the CH + CH4 reaction being used as a reference. Observed H branching ratios were for CH4, 1.00[Fleurat-Lessard, P.; Rayez, J. C.; Bergeat, A.; Loison, J. C. Chem. Phys. 2002, 279, 87];1 C(2)H(6), 0.22 +/- 0.08 [Galland, N.; Caralp, F.; Hannachi, Y.; Bergeat, A.; Loison, J.-C. J. Phys. Chem. A 2003, 107, 5419];2 C(3)H(8), 0.19 +/- 0.07; C(4)H(10) (n-butane), 0.14 +/- 0.06; C(5)H(12) (n-pentane), 0.52 +/- 0.08; C(5)H(12) (neo-pentane), 0.51 +/- 0.08; C(5)H(12) (iso-pentane), 0.12 +/- 0.06; C(6)H(14) (n-hexane), 0.06 +/- 0.04.     

Semimartingale: Itô or not ?

Itô semimartingales are the semimartingales whose characteristics are absolutely continuous with respect to Lebesgue measure. We study the importance of this assumption for statistical inference on a discretely sampled semimartingale in terms of the identifiability of its characteristics, their estimation, and propose tests of the Itô property against the non-Itô alternative when the observed semimartingale is continuous, or discontinuous with finite activity jumps, and under a number of technical assumptions.     

Capillarylike fluctuations at the interface of falling granular jets

We study the interface fluctuations of a granular jet falling under gravity and show that for small scales they are the analog of the thermally induced capillary waves. Experimental results from radial height and velocity fluctuations, static correlation functions and capillary ripple velocities allow us to estimate a granular surface tension. The ultralow interfacial tensions measured (of the order of 100 microN/m) can be rationalized using a simple model.     

A staggered six-vertex model with non-compact continuum limit

The antiferromagnetic critical point of the Potts model on the square lattice was identified by Baxter [R.J. Baxter, Proc. R. Soc. London A 383 (1982) 43] as a staggered integrable six-vertex model. In this work, we investigate the integrable structure of this model. It enables us to derive some new properties, such as the Hamiltonian limit of the model, an equivalent vertex model, and the structure resulting from the Z₂$Z_2$ symmetry. Using this material, we discuss the low-energy spectrum, and relate it to geometrical excitations. We also compute the critical exponents by solving the Bethe equations for a large lattice width N  . The results confirm that the low-energy spectrum is a collection of continua with typical exponent gaps of order (logN)⁻²${(\log N)}^{\mathrm{-2}}$.     

High-throughput Synthesis of Solution-Processable van der Waals Heterostructures through Electrochemistry

Two-dimensional van der Waals heterostructures (2D vdWHs) have recently gained widespread attention because of their abundant and exotic properties, which open up many new possibilities for next-generation nanoelectronics. However, practical applications remain challenging due to the lack of high-throughput techniques for fabricating high-quality vdWHs. Here, we demonstrate a general electrochemical strategy to prepare solution-processable high-quality vdWHs, in which electrostatic forces drive the stacking of electrochemically exfoliated individual assemblies with intact structures and clean interfaces into vdWHs with strong interlayer interactions. Thanks to the excellent combination of strong light absorption, interfacial charge transfer, and decent charge transport properties in individual layers, thin-film photodetectors based on graphene/In₂Se₃ vdWHs exhibit great promise for near-infrared (NIR) photodetection, owing to a high responsivity (267 mA W⁻¹), fast rise (72 ms) and decay (426 ms) times under NIR illumination. This approach enables various hybrid systems, including graphene/In₂Se₃, graphene/MoS₂ and graphene/MoSe₂ vdWHs, providing a broad avenue for exploring emerging electronic, photonic, and exotic quantum phenomena.     

Solar-Driven CO2 Conversion via Optimized Photothermal Catalysis in a Lotus Pod Structure

Photothermal CO₂ reduction is one of the most promising routes to efficiently utilize solar energy for fuel production at high rates. However, this reaction is currently limited by underdeveloped catalysts with low photothermal conversion efficiency, insufficient exposure of active sites, low active material loading, and high material cost. Herein, we report a potassium-modified carbon-supported cobalt (K⁺−Co−C) catalyst mimicking the structure of a lotus pod that addresses these challenges. As a result of the designed lotus-pod structure which features an efficient photothermal C substrate with hierarchical pores, an intimate Co/C interface with covalent bonding, and exposed Co catalytic sites with optimized CO binding strength, the K⁺−Co−C catalyst shows a record-high photothermal CO₂ hydrogenation rate of 758 mmol g_cat⁻¹ h⁻¹ (2871 mmol g_Co⁻¹ h⁻¹) with a 99.8 % selectivity for CO, three orders of magnitude higher than typical photochemical CO₂ reduction reactions. We further demonstrate with this catalyst effective CO₂ conversion under natural sunlight one hour before sunset during the winter season, putting forward an important step towards practical solar fuel production.     

A combined spectroscopic and theoretical study of dibutyltin diacetate and dilaurate in supercritical CO2

Two organotin catalysts, namely, dibutyltin dilaurate (DBTDL) and dibutyltin diacetate (DBTDA), commonly used in the synthesis of polyurethanes, have been investigated combining vibrational spectroscopic measurements with molecular modeling. The structure and vibrational spectra of the DBTDA molecule have been simulated using density functional theory. Thus, because of the Sn...O interactions, the lowest energy conformer reveals an asymmetrically chelated structure of the acetate groups with a C2v symmetry. The experimental IR spectra of DBTDA and DBTDL diluted in carbon tetrachloride and in supercritical CO2 show unambiguously that these molecules adopt the asymmetrically chelated conformation in the solvent. A new attribution of the main peaks constituting the respective IR spectra of the catalysts could be carried out. Finally, from the IR spectra of the two catalysts diluted in supercritical CO2 reported as a function of time, it was found that both molecules react slightly with CO2. However, their spectrum remains unchanged at the earliest stage of the polymerization, indicating that these molecules preserve a catalytic activity similar to that noted in conventional organic solvent.     

Poly(<Emphasis Type="Italic">n</Emphasis>-octyl methacrylate) viscosity index improver: Kinetic study via on-line <Superscript>1</Superscript>H-NMR technique

The free radical solution polymerization of n-octyl methacrylate has been studied in benzene-d ₆ in the presence of 2,2′-azobisisobutyronitrile as thermal initiator. An on-line nuclear magnetic resonance spectroscopy was applied to record the reaction data and to determine the monomer conversion at different times during the polymerization reaction. Effect of monomer and initiator concentration as well as reaction temperature on polymerization rate was studied. The order of the reaction with respect to initiator (0.45) was consistent with the classical kinetic rate equation, while the order of reaction with respect to monomer (1.87) was much greater than unity. An overall activation energy (E _a = 53.8 kJ/mol) was obtained over the temperature range 328?338 K. Also, the efficiency of the synthesized poly(n-octyl methacrylate) for improving the viscosity index of the lube oil was investigated.