STUDIES OF MULTICOMPONENT COMPLEX OXIDE CATALYSTS FOR OXIDATIVE COUPLING OF METHANE VI.SURFACE BASICITY AND SURFACE ACTIVE OXYGEN SPECIES OF LiTi_xLa_(1-x)O_2 λ MULTICOMPONENT OXIDE CATALYSTS

The surface basicity of Ti-La-Li multicoinponent oxides has been investigated by means of CO2-TPD. The experiment results show that C2 (C2H6 C2H4) selectivity is related to surface basic strength. The surface active oxygen species have also been characterized by means of XPS, O2-TPD and so on. It has been indicated that C2 selectivity and CH4 conversion are correlated with lattice oxygen and the adsorbed oxygen on the surface of the catalyst respectively In the O2-TPD experiments, it has also been found that there are three kinds of oxygen species on the surface of the series catalvsts, which are a (100℃ 750℃) Among them α-oxvgen causes deep oxidation whileβand γ oxygen species are related to oxidalive coupling of methane (OCM).     

W／O型微乳液中超氧化物阴离子的产生——微环境中SOD酶活性测定方法 …

分别在水溶液中和W／O型CTAB／正戊醇／异辛烷／水微乳液体系中研究了测定SOD酶活性的邻苯三酚法,发现在反向微乳液中,"小水池"的低介电常数和pH抑制了底物超氧化物阴离子O2-·的产生．只有提高外加缓冲液的pH或"小水池"的水化度,才能得到所需浓度的O2-·,从而初步解决了在微乳液中SOD作用底物的产生问题,为在微乳液中准确测定SOD酶活性创造了条件．     

溶剂聚合膜pH电极作内电极的气敏电极的研究

研究了以中性载体为活性物的石墨内导平头溶剂聚合膜(SPM)pH电极作内电极的二氧化碳和氨气敏电极。电极的性能取决于中性载体的特性,其中以菸酸十八酯为内电极膜活性物的二氧化碳气敏电极和以二辛基十八胺为活性物的氨气敏电极性能较佳。二氧化碳气敏电极用作丙酮酸脱羧酶酶电极的原电极,其性能院于传统的以玻璃pH电极作内电极的二氧化碳气敏电极。     

阳离子无皂含氟丙烯酸酯的合成与表面性能

在合成甲基丙烯酸全氟辛酰氧基乙酯(FA)基础上,用半连续法制备了无皂阳离子含氟丙烯酸酯乳液。当乳液的粒径在100~200 nm、ζ电位大于40 mV时,乳液较稳定。阳离子亲水单体甲基丙烯酰氧乙基三甲基氯化铵(DMC)在含氟丙烯酸酯中质量分数为0.10~0.18、固含量小于20%时乳液的稳定性好,且随DMC含量的增加稳定性提高;含氟丙烯酸酯乳胶膜的附着力与耐磨性好,乳胶膜的透湿率随DMC的增加而增加。随热处理温度的提高,膜表面自由能下降;经160℃热处理后膜发生了交联,表面自由能为18 mN/m,与聚四氟乙烯(PTFE)的表面能相近,DMC含量对膜表面自由能影响不大。XPS分析也表明膜表面氟含量随热处理温度的提高而增加。     

A New Amperometric Biosensor Based on HRP/Nano-Au/L-Cysteine/Poly（o-Aminobenzoic acid）-Membrane-Modified Platinum Electrode for the Determination of Hydrogen Peroxide

The third generation amperometric biosensor for the determination of hydrogen peroxide （H2O2） has been described. For the fabrication of biosensor, o-aminobenzoic acid （oABA） was first electropolymerized on the surface of platinum （Pt） electrode as an electrostatic repulsion layer to reject interferences. Horseradish peroxidase （HRP） absorbed by nano-scaled particulate gold （nano-Au） was immobilized on the electrode modified with polymerized o-aminobenzoic acid （poABA） with L-cysteine as a linker to prepare a biosensor for the detection of H2O2. Amperometric detection of H2O2 was realized at a potential of ＋20 mV versus SCE. The resulting biosensor exhibited fast response, excellent reproducibility and sensibility, expanded linear range and low interferences. Temperature and pH dependence and stability of the sensor were investigated. The optimal sensor gave a linear response in the range of 2.99×10^-6 to 3.55×10^-3 mol·L^-1 to H2O2 with a sensibility of 0.0177 A·L^-1·mol^-1 and a detection limit （S/N = 3） of 4.3×10^-7 mol·L^-1. The biosensor demonstrated a 95% response within less than 10 s.     

Electrochemical Characteristics of Mg0.9Ti0.1-xZrxNi （x=0.02, 0.04, 0.06） Alloys

Mg-based hydrogen storage alloys Mg0.9Ti0.1-xZrxNi (x=0.02, 0.04, 0.06) were successfully prepared by means of mechanical alloying (MA). The effects of Zr addition on the discharge capacity and the cycle performance of the Mg-based electrodes were also studied. It was found that the discharge capacities were improved with addition of a small amount of Zr and the cycle performances of the alloy were stabilized with the addition of Ti. The effects of surface modification or coating on the properties of Mg0.9Ti0.06Zr0.04Ni were also studied. The results indicated that coating with graphite improved both the discharge capacity and cycle life of the amorphous Mg0.9Ti0.06Zr0.04Ni electrode.     

Improved method for the determination of sulfur components in natural gas

Determination of trace concentrations of sulfur components in natural gas is a true analytical challenge. Only analytical procedures based on gas chromatography can meet the sensitivity and accuracy requirements dictated by environmental regulation institutions and modern chemical industry. In the present contribution the sample pretreatment and chromatographic separation steps have been evaluated and optimized based on the use of a flamebased sulfur chemiluminescence detector (SCD) for target compound detection. The proposed instrument consists of a programmed temperature vaporizing (PTV) injector employing a liner packed with Chromosorb 104, a 4 μm thick film apolar column and a flame-based SCD. Using a 13 mL sample loop the detection limit achievable with the new method is 3 μg S/m³. The precision of replicate measure. ments is generally in the range of 5–15% relative standard deviation. Lower detection limits can be achieved by preconcentrating larger sample volumes, e.g. 100 mL.     

Synthesis, structural, spectroscopic, and electrochemical characterization of high oxidation state diruthenium complexes containing four identical unsymmetrical bridging ligands

Six Ru2(6+) derivatives of the form Ru2(L)4(C[triple bond]CC6H5)(2), where L = 2-Fap, 2,3-F(2)ap, 2,4-F(2)ap, 2,5-F(2)ap, 3,4-F(2)ap, or 2,4,6-F(3)ap, are synthesized and characterized as to their electrochemical, spectroscopic, and/or structural properties. These compounds are synthesized from a reaction between LiC[triple bond]CC6H5 and Ru2(L)4Cl. Two of the investigated complexes exist in a (4,0) isomeric form while four adopt a (3,1) geometric conformation. These two series of geometric isomers are compared with previously characterized (4,0) Ru2(ap)4(C[triple bond]CC6H5)(2), (4,0) Ru2(F5ap)4(C[triple bond]CC6H5)(2), and (3,1) Ru2(F5ap)4(C[triple bond]CC6H5)(2). The overall data on the nine compounds thus provide an opportunity to systematically examine how the electrochemical and structural properties of these Ru2(6+) complexes vary with respect to isomer type and electronic properties of the bridging ligands.     

μ‐{N,N′‐Bis[2‐(dimethyl­amino)ethyl]oxamidato(2–)}‐1κ2O,O′:2κ4N,N′,N′′,N′′′‐bis­(4,4′‐dimethyl‐2,2′‐bipyridine‐1κ2N,N′)dinickel(II) bis­(perchlorate)

In the crystal structure of the title complex, [Ni₂(C₁₀H₂₀N₄O₂)(C₁₂H₁₂N₂)₂](ClO₄)₂ or [Ni(dmaeoxd)Ni(dmbp)₂](ClO₄)₂ {H₂dmaeoxd is N,N′‐bis­[2‐(dimethyl­amino)ethyl]oxamide and dmbp is 4,4′‐dimethyl‐2,2′‐bipyridine}, the deprotonated dmaeoxd²⁻ ligand is in a cis conformation and bridges two Ni^II atoms, one of which is located in a slightly distorted square‐planar environment, while the other is in an irregular octa­hedral environment. The cation is located on a twofold symmetry axis running through both Ni atoms. The dmaeoxd²⁻ ligands inter­act with each other via C—H⋯O hydrogen bonds and π–π inter­actions, which results in an extended chain along the c axis.