Single crystal tin nano-rod arrays electrodeposited by a soft template

Single crystal tin nano-rod arrays were fabricated by the electrodeposition method when amphiphilic triblock copolymer P123 was used as a soft template at a concentration much lower than that for forming a liquid crystalline phase.     

锂电池Li／KIBr2—非水体系的研究

本非水电池体系由Ｌｉ负极、多孔石墨电极和电解质溶液组成；电解质溶液由无机溶剂ＰＯＣｌ＿３（或有机溶剂硝基苯）和溶解在该溶剂中的活性物质（ＫＩＢｒ＿２）及支持电解质构成。该电池体系的开路电压为８．５０伏左右，放电性能良好，可望在实际中得到应用。此外，对电池体系的反应机理也作了初步的探讨。     

用共振电离飞行时间质谱仪分析土壤中超痕量气态金

采用激光共振电离飞行时间质谱技术（简称ＲＩＳ－ＴＯＦ技术）对土壤中超痕量气态金的含量进行了分析研究。ＲＩＳ－ＴＯＦ谱仪具有极高的灵敏度和很强的选择性，避免了对样品的预富集过程。本文给出了该谱仪对金元素的检测限和６５个土壤中气态金样品的分析结果，以及用中子活化法随机抽样检查的结果。     

催化裂化汽油脱硫添加剂USY/ZnO/Al2O3的性能评价

 在固定流化床催化裂化装置上，以减压蜡油为原料，对制备的U\r\nSY／ZnO／Al2O3催化裂化汽油脱硫添加剂的性能进行了评价．结果表明\r\n，随着添加剂添加量和剂油比的增加，生成汽油的硫含量降低．在500\r\n℃和剂油比为5的条件下，在FCC平衡催化剂中添加30％的添加剂时，汽\r\n油的硫含量可由不加添加剂时的1230μg／g降低到770μg／g左右．添\r\n加剂的添加量（10％）较低时，对催化裂化产物的分布基本没有影响；\r\n添加30％的添加剂时，焦炭的产率有所增加，但汽油收率基本不变．X\r\nRD表征结果表明，USY／ZnO／Al2O3添加剂中的ZnO对USY的晶相结构有\r\n一定的破坏作用，但随着反应与再生次数的增多，ZnO与Al2O3之间形成\r\n较为稳定的锌铝尖晶石结构，使添加剂的性能趋于稳定．     

Extraction of Americium(III) and Europium(III) with Two Open-Chain Crown Ethers of Amide Type

The extraction of Am³⁺ and Eu³⁺ from aqueous picric acid solution by N, N-dinaphthyl-N, N-diphenyl-3,6-dioxaoctanediamide (L^I) and 1, 1-(3, 6, 9-trioxaundecanedionyl)diphenothiazine (L^II) was investigated by a radioactive tracer technique. Extraction distribution ratios of Am³⁺ and Eu³⁺ have been measured as a function of pH, picric acid concentration, extractant concentration, diluent and temperature. The extraction of Am³⁺ is preferred to that of Eu³⁺ for both L^I and L^II, and the latter gives larger separation factor than the former. The equilibrium constants and thermodynamic parameters of extraction reactions were also calculated.     

微乳液介质—1—（2—吡啶偶氮）—2—萘酚光度法测定汽油中环烷酸铁的含量

本研究了微乳液为介质时，铁与１－（２－吡啶偶氮）－２－萘酚（ＰＡＮ）的显色反应。选择７３０ｎｍ处为测定波长，ε为１．４×１０＾４Ｌ．ｍｏｌ＾－＾１．ｃｍ＾－＾１，铁量在０－５０μｇ／２５ｍｌ范围内符合比耳定律，该法适用于汽油中环烷酸铁的测定。     

One-pot synthesis of N-protected α-amino aldehyde acetals from three-component reaction of fluoroalkanesulfonyl azide, vinyl ether and alcohol

A facile one-step method has been developed for the synthesis of N-protected α-amino aldehyde acetals in moderate to good yields by three-component reaction of fluoroalkanesulfonyl azides, vinyl ethers and alcohol at 0 °C within 10 min. This practical synthetic method provides a convenient and expeditious access to N-per(poly)fluoroalkanesulfonyl α-amino aldehyde acetals.     

5,7′-(亚甲胺基)-二-8-羟基喹啉的合成及其理论研究

以4-甲基苯磺酸作催化剂、用三乙胺调节pH值约为9的条件下, 由5-甲酰基-8-羟基喹啉和5-氨基-8-羟基喹啉合成了新的5,7′-(亚甲胺基)-二-8-羟基喹啉, 利用IR, UV, ¹H NMR, MS确认了分子结构, 比较研究了其光致发光特性, 运用Gaussian 98量子化学程序包, 采用B3LYP密度泛函(DFT)的方法, 在6-31G(d,p)水平上对分子的几何构型进行结构优化; 并对目标化合物的稳定结构通过计算预测其振动光谱, 计算结果与实验值基本相符.     

Synthesis of gramicidin S and its analogues via an on-resin macrolactamization assisted by a predisposed conformation of the linear precursors

A simple and efficient preparation of gramicidin S and its analogues is described. It involves solid-phase peptide synthesis and on-resin macrolactamization without side chain protection, affording cyclic products in high yield and high purity. The high specificity of the cyclization reaction was shown to originate in the formation of a pre-organized conformation of the linear biosynthetic precursor of gramicidin S. This facile method will provide convenient access to the analogues of the natural product for functional optimization to counter microbial resistance.     

Method development for the quantitation of ABT-578 in rabbit artery tissue by 96-well liquid-liquid extraction and liquid chromatography/tandem mass spectrometric detection

Quantitative determination of drug concentrations in tissue samples can provide critical information for drug metabolism, kinetics, and toxicity evaluations. For analysis of tissue samples using liquid chromatography/tandem mass spectrometric (LC/MS/MS) detection, homogenization is a critical step in achieving good assay performance. Assay performance can be closely evaluated by spiking the drug directly into tissue samples prior to homogenization. It is especially important to include this assay evaluation for the analysis of artery tissue samples because artery tissue is very elastic, making it quite a challenge to develop an effective procedure for homogenization. An LC/MS/MS assay in 96-well format using liquid-liquid extraction was developed for analyzing ABT-578 in rabbit artery samples. Tissue quality control samples were prepared by spiking ABT-578 stock solutions directly into the tissue before homogenization. The usage of the tissue control samples gives a thorough evaluation of the sample preparation process that includes both homogenization and sample extraction. A 20% blood in saline solution was used as a homogenization solution. Calibration standards were made by spiking ABT-578 into rabbit whole blood. Blood quality control samples were also prepared by spiking ABT-578 into rabbit whole blood. These blood QC samples were used to confirm the validity of the calibration curve. A lower limit of quantitation of 0.050 ng/mL was achieved. The linear dynamic range of blood standards was from 0.050-30.3 ng/mL with the correlation coefficient (r) ranging from 0.9969-0.9996. Overall %CV was between 1.3 and 7.0%, and analytical recovery was between 98.2 and 105.8% for blood QC samples. The %CVs for tissue QC samples were between 6.7 and 13.0%, and analytical recovery after correction was between 93.5 and 114.3%.