WAXS studies on block copolymers of ethylene and propylene

Wide-angle X-ray scattering from presumed block copolymers of polypropylene (PP) and ethylene-propylene copolymer (EPR), i.e., PP-EPR and PP-EPR-PP, synthesized by sequential polymerization with δ-TiCl₃? Et₂AlCl, was examined and compared with WAXS of mechanical blends and chain-transfer mixtures of PP and EPR with comparable compositions. The peak at 2θ = 20° for both the copolymers and the mixtures was attributed to the γ modification of PP in EPR. A strong variation in the ratio of diffraction intensities I₀₄₀/I₁₁₀ of PP in block copolymers and mixtures was explained in terms of crystallite growth in different directions. Analysis of the patterns and calculation of crystallinity, crystallite size, and lattice parameters led to the conclusion that block structure existed in the prepared copolymers.     

�۱��ƫ��������ˮ��������ǿ�����������о�

By using Fluent software with the Eulerian multiphase model and Non-equilibrium boiling model, the subcooled flow boiling heat transfers was numerically simulated in the plain upward vertical tubes under the condition of one-side heating. The influences of the different mass flux, inlet temperatures and heat flux on the heat transfer coefficient, the void fraction and heat transfer deterioration were investigated.     

Ethylene–propylene copolymerization with bis(β‐enaminoketonato) titanium complexes activated with modified methylaluminoxane

Ethylene–propylene copolymerization, using [(Ph)NC(R₂)CHC(R₁)O]₂TiCl₂ (R₁ = CF₃, Ph, or t‐Bu; R₂ = CH₃ or CF₃) titanium complexes activated with modified methylaluminoxane as a cocatalyst, was investigated. High‐molecular‐weight ethylene–propylene copolymers with relatively narrow molecular weight distributions and a broad range of chemical compositions were obtained. Substituents R₁ and R₂ influenced the copolymerization behavior, including the copolymerization activity, methylene sequence distribution, molecular weight, and polydispersity. With small steric hindrance at R₁ and R₂, one complex (R₁ = CF₃; R₂ = CH₃) displayed high catalytic activity and produced copolymers with high propylene incorporation but low molecular weight. The microstructures of the copolymers were analyzed with ¹³C NMR to determine the methylene sequence distribution and number‐average sequence lengths of uninterrupted methylene carbons. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5846–5854, 2006     

Highly soluble and optically transparent poly (ether imide)s based on 2,6‐ or 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and aromatic bis(ether amine)s bearing trifluoromethyl groups

Two series of novel fluorinated poly(ether imide)s (coded IIIA and IIIB ) were prepared from 2,6‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride, respectively, with various trifluoromethyl‐substituted aromatic bis(ether amine)s by a standard two‐step process with thermal or chemical imidization of the poly(amic acid) precursors. These fluorinated poly(ether imide)s showed good solubility in many organic solvents and could be solution‐cast into transparent, flexible, and tough films. These films were nearly colorless, with an ultraviolet–visible absorption edge of 364–386 nm. They also showed good thermal stability with glass‐transition temperatures of 221–298 °C, 10% weight loss temperatures in excess of 489 °C, and char yields at 800 °C in nitrogen greater than 50%. The 2,7‐substituted IIIB series also showed better solubility and higher transparency than the isomeric 2,6‐substituted IIIA series. In comparison with nonfluorinated poly (ether imide)s, the fluorinated IIIA and IIIB series showed better solubility, higher transparency, and lower dielectric constants and water absorption. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5909–5922, 2006     

交换自同构群的若干结果

借助于环论的方法研究了具有交换自同构群的有限群,提出了一种新的自同构构作技术,并用之证明了这样的非交换有限群具有非循环的中心子群,以及其每个极大子群的中心子群也都非循环.     

模糊神经网络在复合地基沉降量预测中的应用

复合地基后期沉降变形对于建筑物设计及安全具有重要意义,针对通过长期沉降观测以得到复合地基的最终沉降需要耗费较多资源的问题,提出了一种基于模糊神经网络的预测方法.该方法考虑沉降变化过程有较大的随机性和模糊性,直接将样本数据进行模糊化,所得的模糊数代表了样本点集与控制点集中各分量之间的相关度,并依此建立模糊BP神经网络进行学习和估算.实验结果表明了该方法对沉降进行预测是可行与有效的,且在相对误差的有效控制方面优于BP网络方法与灰色方法.     

Finite-element calculation of the influence of interdiffusion on eigenstates in a GaAs/Al x Ga1-x As single-quantum-well structure

The influence of interdiffusion on eigenstates in an interdiffusion-induced GaAs/Al_xGa_1-xAs single-quantum-well structure is analysed numerically by the finite element method. In this approach, the confinement potential profile of the interdiffused quantum well structure is nonlinear and is modelled by an error function and, in particular, the nature of the effective mass of an electron is considered. The results show that the number of eigenstates and energy levels varies with the extent of the interdiffusion. Numerical results for the quasi-bound states in the quantum well structure with an applied electric field are also presented.     

Preparation of AgBiVMoO/-Al2O3 Catalysts for the Partial Oxidation of Propane

A novel mixed sol method was developed for the preparation of supported catalysts. Analyses by means of XRD and BET show that a 40%AgBiVMoO/γ-Al2O3 catalyst prepared by this method possessed high specific surface area and high dispersion of the active phase. As a result, high acrylic acid selectivity of 8.5% was obtained when the catalyst was used in the reaction of propane partial oxidation to acrylic acid in a fixed-bed reactor.     

传感法研究固态钢中镧活度

本文采用LaF3单晶固体电解质测量了473～1223K温度范围内钢中镧的活度.两个平行样品的活度值符合很好,并且LaF3单晶的起始工作温度约为880K.     

FFC-1离子交换纤维对酸碱有害气体吸附性能的研究

系统考察了不同直径及反离子形式的FFC-1聚羧酸离子交换纤维对酸碱有害气体的穿透吸附,各种温、湿度条件下的吸水率,以及作为有害气体吸附滤除材料的重复使用与再生性能。研究表明:FFC-1纤维直径的减小有利于提高对有害气体的动态吸附容量。在体系温度、相对湿度分别为15℃、50%时,以3D腈纶为起始原料的钠型FFC-1离子交换纤维的吸水率≥350mg/g.纤维;对SO2的穿透吸附容量可达200mg/g.纤维。FFC-1离子交换纤维具有良好的重复使用与再生能力,经20次再生循环使用后,纤维交换容量未见明显变化。