聚丙烯及增韧剂对复合材料熔接痕强度的影响

研究了聚丙烯基体的熔体粘度(以熔体流动速率表征)、增韧剂POE的粘度(以门尼粘度表征)、增韧剂POE的含量等因素对聚丙烯复合材料熔接痕强度的影响。结果表明:聚丙烯基体/增韧剂的粘度比越小,聚丙烯复合材料的熔接痕强度越高,即聚丙烯粘度越小、增韧剂粘度越大,整个复合材料的熔接痕强度越高;增韧剂POE的含量越大复合材料的熔接痕强度越小。     

��β�ӳ��������ģ�����Ʋ����ʵĽ�����

In this paper, for a kind of risk models with heavy-tailed and delayed claims, we derive the asymptotics of the infinite-time ruin probability and the uniform asymptotics of the finite-time ruin probability. The numerical simulation results are also presented. The results of theoretical analysis and numerical simulation show that the influence of the delay for the claim payment is nearly negligible to the ruin probability when the initial capital and running-time are all large.     

光谱法锌离子检测系统的研究

采取标准锌显色剂与锌发生显色反应，生成不溶于水的絮状络合物。用光谱仪测它的吸光度，研究其特征谱与吸光度的特点，建立其浓度与特征波长吸光度间的数学模型。本文所采用的显色剂主要与锌、铜、镉、镍四种离子发生络合反应。因此分别探索了四种离子高浓度以及低浓度时显色反应的吸光度，最终通过得到锌离子浓度与吸光度的关系式以及锌离子浓度与四波长下四种离子混合溶液显色后的吸光度的关系式，给出了锌离子的吸光度与总吸光度的关系式。显色反应能否满足分光光度法的要求，主要与显色剂的性质有关，同时显色反应的条件也至关重要。因为在显色反应过程中，主要是锌离子与锌显色剂发生络合反应形成络离子，进而形成絮状络合物。络离子一般比较稳定，但在水溶液中也存在着电离平衡，也就是说当显色条件发生变化时，既有可能形成络离子，也有可能发生络离子的分解，从而影响络合反应的程度。显色条件包括显色剂用量、pH值、反应温度、显色时间、待测溶液的盐度以及浊度等。重点研究待测溶液的盐度对锌离子浓度测量值的影响，并通过实验给出影响规律以及校正模型。     

三光气与酚制备三氯甲氧基甲酸芳酯研究

研究了不同取代酚与三光气的反应,得到七种未见报道的新化合物,以IR、MS、1H NMR、13C NMR对产物进行了表征,并探索得到合适的反应催化剂、反应物浓度配比、反应时间,讨论了酚上不同取代基对反应的影响,收率在78.5～90.5%之间。     

Co/SBA-16:对柴油组分有高选择性的费托合成催化剂(英文)

使用浸渍法制备了一系列Co/SBA-16催化剂,并通过氮物理吸附、X射线衍射、氢程序升温还原、氢化学吸附和透射电镜技术对催化剂行了表征。研究表明,随着负载钴含量的增加,金属钴的分散度降低了,这是同Co3O4晶粒增长和比表面积降低相一致的。Co/SBA-16催化剂展示了高的一氧化碳转化率,低的C1选择性和高的C5+选择性,特别对柴油组分有高选择性。     

Simulation of beam gas coulomb scattering in HALS

In conventional research on beam gas coulomb scattering(BGCS), only the related beam lifetime using the analytical method is studied. In this paper, using the particle-in-cell Monte Carlo collisions(PIC-MCC) method,we not only simulated the beam lifetime but also explored the effect of BGCS on the beam distribution. In order to better estimate the effect on particle distribution, we study the ultra-low emittance electron beam. Here we choose the He Fei Advanced Light Source. By counting the lost particles in a certain time, the corresponding beam lifetime we simulated is 4.8482 h/13.8492 h in x/y, which is very close to the theoretic value(5.0555 h /13.7024 h in x/y).By counting the lost particles relative to the collided particles, the simulated value of the loss probability of collided particles is 1.3431e-04, which is also very close to the theoretical value(1.3824e-04). Besides, the simulation shows there is a tail in the transverse distribution due to the BGCS. The close match of the simulation with the theoretic value in beam lifetime and loss probability indicates our simulation is reliable.     

Theoretical Study of the Rate Coefficients for CH3NHNH2 + NO2 and Related Reactions

The kinetics and mechanisms of H atom abstraction reactions from CH₃NHNH₂ by NO₂ (R1) and related reactions have been investigated theoretically by using ωB97X‐D and CCSD(T)‐F12 quantum chemical calculations and the steady‐state unimolecular master equation analysis based on Rice–Ramsperger–Kassel–Marcus (RRKM) theory. For reaction (R1), both dissociation and isomerization steps between intermediate complexes were found to be important for the distribution of the dissociated bimolecular products. The dominant products of (R1) were found to be cis‐CH₃NHNH and HONO at lower temperature. The branching ratios for CH₃NNH₂ formation paths increased with increasing temperature. On the same reaction potential energy surface, six reactions including isomerization reactions between CH₃NNH₂ and cis‐/trans‐CH₃NHNH catalyzed by HONO were suggested to compete with the reverse reaction of (R1). The temperature‐ and pressure‐dependent rate expressions are proposed for kinetic modeling.     

CH4/空气简化动力学机理数值验证

选择绕圆柱预混燃烧算例，验证CH₄/空气三种简化动力学机理（16s41r、15s19r和53s325r）.考虑均匀来流，忽略湍流和湍流与燃烧相互作用以及燃料扩散效应，假设层流有限反应速率，采用保自由流5阶WENO格式求解多组分Euler方程组，得到CH₄/空气预混燃烧流场温度等值线、沿驻点线压力和温度及其CH₄、CO和CO₂质量百分数分布.结果表明：三种简化动力学机理给出的流场均出现弓形激波和火焰面，弓形激波和火焰驻点距离及其形状、诱导区宽度和简化动力学机理相关.当圆柱直径增大，弓形激波和火焰向圆柱上游移动，对应的驻点距离均增大，诱导区宽度变短，点火延时变小，但火焰和弓形激波位置次序未变化.53s325r模型要比16s41r模型和15s19r模型精度要高，点火延时覆盖的压力和温度范围也较宽，所有简化机理均未完全反应，在较大圆柱直径下游达到化学平衡.     

企业自主研发与合作创新的风险测度及组合优化

企业在整合内部创新要素进行自主研发的同时,也会寻求外部创新资源进行合作创新,当前同时从事多个R&D项目已成为常见的企业经营活动,如何在不确定条件下分析多个R&D项目投资的策略选择及风险优化,对于企业的长期发展具有重要意义。根据企业是否采取合作创新策略,可将其R&D项目分为自主研发与合作创新两类,以项目的研发成功率和投资收益率代表技术风险和市场风险,分别测度自主研发与合作创新项目的风险特性,并在此基础上构建企业R&D项目投资组合优化模型,以在自主研发与合作创新项目之间进行权衡取舍。结果表明,企业对于自主研发与合作创新项目投资组合的最优投资权重,主要取决于这两类组合的期望收益率、收益率方差、期望成功率以及两组合之间的协方差。企业可基于关键参数制定出最优的R&D项目投资组合选择策略,合理分配资金以达到风险最小化的投资目标。     

直觉模糊模型检测在工程决策上的应用

将直觉模糊Kripke结构扩展到加权直觉模糊Kripke结构,将直觉模糊计算树逻辑诱导到加权直觉模糊计算树逻辑;研究在此之上的直觉模糊期望测度和多属性工程决策问题。用加权直觉模糊Kripke结构的权值自然地刻画了工程问题中的成本和收益,直觉模糊测度量化工程进展的不确定性,用加权直觉模糊计算树逻辑描述不确定性工程属性约束。给出了基于直觉模糊模型检测的多属性工程寻优算法,并讨论了算法的复杂度。