纳米通道单分子检测低噪音电流放大器系统的研究

研制了一种新型微电流放大器系统,用于检测琢-Hemolysin生物蛋白纳米通道在单分子检测实验中所产生的微弱电流信号(<100 pA)。在1 mol/L KCl、10 mmol/L Tris-HCl,1 mmol/L EDTA的缓冲液(pH 8.0)中测定了DNA-PEG-DNA交联物与纳米通道的穿越和碰撞信号。实验中使用3 kHz贝塞尔滤波器和100 kHz模数转换器来对电流进行采样。结果表明,此放大器系统能够有效降低电流记录过程中的噪音,有利于分辨待测物分子与纳米通道作用所产生的较小阻断的电流信号(<10 pA)。     

还原氧化石墨烯修饰Bi2WO6提高其在可见光下的光催化性能

通过两步水热法合成了一种新型的还原氧化石墨烯(RGO)修饰的Bi₂WO₆(Bi₂WO₆-RGO), 结果表明其在可见光下的光催化性能得到了显著的提高. 研究了RGO在Bi₂WO₆-RGO中的含量对其光催化性能的影响, 从而确定出RGO相对于Bi₂WO₆的最佳掺杂质量比值为1%. 通过扫描电镜(SEM)研究发现, RGO并没有改变Bi₂WO₆光催化剂的结构和形貌. Bi₂WO₆-RGO在可见光下的光催化性能得以提高可以归功于RGO. 其可能的机理是石墨烯的存在有利于光生载流子(激子)的分离, 从而导致产生更多的O₂^·-用于有机染料污染物(如罗丹明B (RhB))的降解. RhB分子在石墨烯上的有效吸附可能也是导致Bi₂WO₆-RGO光催化性能提高的另一原因.     

铝基火花源发射光谱仪测定MB1镁合金中锰含量

建立了用铝基体火花源原子发射光谱仪现有通道硬件测定镁合金(MB1)中锰元素含量的方法.方法线性相关系数为0.967 6,RSD为1.66%.对8个未知样品进行了测试,结果与化学分析方法所得结果一致.     

某软土深基坑工程时间效应有限元分析

软土地区的深基坑因土体的固结作用和流变性而具有了时间效应。本文以Biot固结有限元法为基础,用三元件模型中的第一个线性弹簧模拟固结作用,弹性模量考虑了开挖应力路径和应力历史的影响;另外一部分(KELVIN模型)来模拟土体的流变性,以实际变形的反演来得到两个参数的大致取值,再对基坑的变形情况以及进一步开挖进行分析。假定为正常固结饱和粘土,平面应变问题。通过对某饱和软粘土地基深基坑开挖工程实例的分析,得到的挡墙水平位移曲线与实测曲线很吻合,表明程序较好地反映出基坑的时间效应。     

基于自动磁珠转运的转基因蛋白Cry1Ab检测

基于自动磁珠转运,建立了转基因蛋白Cry1Ab免疫检测的新方法.利用水热法制备了粒径约400 nm的纳米磁球,并进行电镜表征,通过溶胶法对磁球表面进行氨基修饰,采用戊二醛偶联对磁珠实现抗体包被,在核酸提取仪中进行酶联免疫反应,采用分光光度法进行检测.本方法对转基因蛋白Cry1Ab的检出限低于1 μg/L,与商品化酶联免...     

基于吡啶多羧酸和N，N′-桥联混合配体的钴配合物的合成及结构分析

将吡啶-2,4,6-三羧酸(2,4,6-pytaH3),4-氨基-3,5-二(4-吡啶基)-1,2,4-三氮唑(4,4′-abpt)和CoCl2在不同的pH条件下发生水热反应,得到2个新的配位聚合物[Co(2,4,6-pytaH)(4,4′-abpt)(H2O)](1)和[Co1.5(2,4,6-pyta)(4,4′-abpt)(H2O)3].3.5H2O(2)。配合物1是在吡啶-2,4,6-三羧酸酸性环境下产生的,吡啶-2,4,6-三羧酸在水热条件下只脱去2个羧基上的质子变成2,4,6-pytaH2-,而配合物2是在NaOH碱性溶液下反应得到的,其中吡啶-2,4,6-三羧酸完全脱去3个羧基上的质子变成2,4,6-pyta3-。配合物1中包含一维Co-羧酸链,2中存在具有(4,4)拓扑网络的二维层。1和2中的一维链和二维层通过π-π堆积和丰富的氢键作用分别拓展成三维超分子网络。单晶结构分析表明,配合物1结晶于单斜晶系,P21/n空间群,a=0.961 30(10)nm,b=0.632 09(6)nm,c=3.372 9(4)nm,β=95.104(2)°,V=2.041 3(4)nm3,Z=4。而配合物2结晶于单斜晶系,P21/c空间群,a=1.795 2(2)nm,b=0.729 62(8)nm,c=2.078 7(2)nm,β=112.323(2)°,V=2.518 6(5)nm3,Z=4。     

固相微萃取-气相色谱/质谱联用快速鉴定香稻香味特征化合物2-乙酰基吡咯啉

建立了固相微萃取-气相色谱/质谱(SPME-GC/MS)联用快速鉴定香稻香味特征化舍物2-乙酰基吡咯啉的方法.香米加入内标物2,4,6-三甲基吡啶,密封,在80℃水浴条件下经固相微萃取(萃取纤维头为100 μm聚二甲基硅氧烷)提取2 h,提取物经毛细管气相色谱柱HP-5MS(30 mx0.25mm×0.25μm)分离,...     

Tin (IV) chloride-promoted one-pot synthesis of novel tacrine analogues

A facile synthesis of potential acetylcholinesterase (AChE) inhibitors, the tacrine analogues 3a-p, has been accomplished by direct cyclocondensation of 1-aryl-4-cyano-5-aminopyrazole with β-ketoesters using tin(IV) chloride as catalyst. The structures of all the compounds have been confirmed by IR, 1H- and 13C-NMR.     

Hydrophobic/hydrophilic solvation: inferences from Monte Carlo simulations and experiments

In this study Monte Carlo simulations are used to determine the solvation properties of model hydrophobic (xenon and hard sphere) and hydrophilic (dimethyl ether) solutes in SPC/E water. Various contributions to the experimental solvation entropy, including the solvent reorganization entropy, have been determined. The main conclusion drawn, which is in accord with solubility data, is that poor solubility correlates with poor solute-water interaction. At room temperature, energy dominates the aqueous solubility of both hydrophobic and hydrophilic solutes, rather than entropy. However, at higher temperatures the solubility can pass through a minimum, and then entropy becomes dominant. Another interesting finding is the presence of larger than expected cavities in water. Two different simulation results support this finding. This unexpected hollow structure in water explains why a hard sphere solute is more soluble in water than in a comparable hard sphere or Lennard-Jones solvent. Hydrogen bonding causes water to aggregate into clusters that produce a few large cavities rather than many smaller cavities. The propensity for clustering also explains why water gives the illusion of being a low density liquid. Sufficient theoretical apparatus is developed to connect theoretical solvation properties to those measured by simulation and experiment. Finally, based on gas solubility, an intuitive hydrophobic/hydrophilic scale is developed.