关于不含k-C-圈的n阶r-一致超图的若干结果

主要讨论了不含k-C-圈的n阶r-一致超图,对不同的k,分别得出了它的极大边数的一个下界,并且得出在有些情况下它的下界是最大的.另外,我们得到了Krn含k-C-圈的一个充分必要条件.     

Isolation and Characterization of Proteins Interacting with Activin Type Ⅱ Receptors

Introduction Activinisamemberofthetransforminggrowth factor(TGF)βsuperfamilyofextracellularsignaling proteins.Themembersofthisfamilyplayacriticalrole duringembryogenesisandinmaintainingtissuehomeo stasisinadultlife[1—3].DeregulatedTGFfamilysigna lingisi…     

Measurement of surface topography by RGB Shadow-Moiré with direct phase demodulation

In this paper we present the application of a direct demodulation method for the measurement of surface topography by means of Shadow-Moiré. In our set-up, we use three LEDs (with green, red and blue peak wavelengths) to illuminate the grating. Due to the different position of these light sources, a polychromatic Shadow-Moiré fringe pattern is produced, which can be described as the superposition of three monochromatic (red, green and blue) fringe patterns. Taking the image of this polychromatic fringe pattern with a RGB CCD camera, we get a monochromatic fringe pattern stored at each RGB channel of the CCD. The direct demodulation algorithm employed uses these fringe patterns to calculate the wrapped phase map. After unwrapping the phase map using a standard multi-grid technique, we implemented an automatic procedure to detect the area of interest of the phase map by removing low modulation zones and to calculate the absolute value of the phase. In this way it is possible to determine the topography of a surface with a single RGB snapshot maintaining a simple experimental set-up, which is an important feature, especially for the study of dynamic phenomena such as deformations. We present the experimental results obtained after measuring different objects with both smooth and rough surface textures.     

Monitoring the Aggregation of Dansyl Chloride in Acetone through Fluorescence Measurements

The aggregation of dansyl chloride (DNS-Cl) in acetone has been studied in detail by steady-state fluorescence techniques.It has been demonstrated that DNS-Cl is stable in acetone during purification and aggregation study processes.The aggregates are not solvolyzed in acetone,and do not take part n any chemical reactions either.It has been found that DNS-Cl tends to aggregate even when its concentration is much lower than its solubility in acetone.The aggregation is reversible,and both the aggregation and the deaggregation are very slow processes.Introduction of SDS has a positive effect upon the formation and stabilization of the aggregates.     

高强混凝土弯压极限应变试验研究与计算

由于混凝土材料理化特性的差异,高强混凝土的弯压极限应变明显地小于普通混凝土,依据试验结果分析了高强混凝土的弯压极限应变变化规律,并给出了它的计算公式.     

The electrochemical reduction of perezone in the presence of benzoic acid in acetonitrile

An electrochemical study using transient techniques of a quinone-type natural product, perezone, has been performed in acetonitrile and in the presence of benzoic acid. Using linear sweep voltametry and single potential step chronoamperometry, it was possible to establish that the reduction mechanism of perezone involves a monoelectronic charge-transfer step, followed by a protonation step and homogeneous charge transfer due to disproportionation of the protonated intermediate. The mechanism for the homogeneous charge-transfer step was found to be of the type DISP1 (disproportionation order one) from the results of double potential step chronoamperometry experiments. The occurrence of the DISP1 mechanism was provoked by the mildly acidic medium used in this study.     

Pattern时延差编码四信道水声通信技术研究

本文所研究的是基于Pattern时延差编码（PDS）体制下的水声通信技术.PDS水声编码体制利用Pattern码片出现在码元窗的时延差值进行时延编码,通过码元分割,有效的降低了水声信道的多途干扰;通过频率分割划分四个通信信道,增加通信速率至1000bit/s.在接收端利用带通滤波器来实现通信信道分割,每个信道再应用拷贝相关器实现码元分割并估计出时延差值,完成译码.仿真实验表明,该系统适合于大量不同水声信道高可靠性工作,为水声通信网络化打下坚实基础.     

Controllable Magnetic Focusing of Cold Atoms on a Chip

We propose a new lens scheme to focus cold atoms by using a controllable inhomogeneous magnetic field from a square current-carrying wire fabricated on a chip. The spatial distributions of the magnetic field are calculated, and the results show that the generated magnetic field is a two-dimensional （2D） quadrupole one and can be used to focus cold atoms or a cold atomic beam. The dynamic processes of cold atoms passing through our square wire layout and its focusing properties are studied by using Monte Carlo simulations. Our study shows that the atomic clouds can be focused effectively by our magnetic lens scheme, and the focal length of the atomic lens and its radius of focused spot can be continuously changed by adjusting the current in the wires.     

Improvement of the properties of polyarylate reinforced with liquid crystalline polymers

Blends of polyarylate of bisphenol A, PAr, with two commercial main chain liquid crystalline polymers, Vectra A950 and Vectra B950, are studied. From dynamic viscoelastic measurements it is deduced that both systems (PAr/Vectra A950 and PAr/Vectra B950) are immiscible and scanning electron microscopy (SEM) micrographs show the presence of spherical domains of the liquid crystalline polymer when PAr constitutes the matrix. Extrusion capillary measurements reveal that, under conditions of temperature and shear rate similar to those of processing, the viscosity is reduced to approximately 10% of its value when the content of liquid crystalline polymer is only 20%. This great improvement of the rheological properties is observed in both PAr/Vectra A950 and PAr/Vectra B950 blends. The effect of draw ratio on Young's modulus for different compositions is also analyzed, pointing out the reinforcing action of both liquid crystalline polymers on polyarylate: for instance, 20% of Vectra B950 in the blend gives rise to a 700% increase of the modulus of fibres prepared at a draw ratio of 50. SEM of the extrudates reveals that the spherical domains are elongated at the entrance of the capillary giving rise to a microfibrillar morphology which is related to the excellent rheological and mechanical properties of the blends.     

采用热处理方法提高MEH-PPV单层聚合物有机发光二极管发光性能的研究

对以MEH－PPV为发光层的单层聚合物有机发光二极管（OLED）器件在最佳条件下进行真空热处理，并用金相显微镜观察施加电压后器件的阴极表面形貌。发现处理后的器件阴极表面的气泡及黑斑明显减少。器件的发光性能显著提高。与未经处理的器件相比，最大相对发光强度提高了一个数量级、启亮电压降低了2．0V，半寿命提高了12．7倍。初步分析表明热处理方法提高器件发光性能的主要原因在于有效地减少了器件在工作过程中由于焦耳热产生的某些气体，从而减少阴极表面气泡及黑斑的出现，另一方面，热处理方法也增强了有机发光层与阴极接触界面的结合力，提高电子注入水平。