金属与金刚石薄膜接触的电学特性研究

用热丝辅助化学汽相沉积技术在Si衬底上合成了含少量受主型杂质的近于本征的金刚石薄膜，并研究了三种金属（Cu，Ag和Al）与它接触的电学特性，以及退火对接触特性的影响．结果表明Cu，Ag与金刚石薄膜接触的电学特性比较类似，而Al则明显不同；而且退火对它们的接触特性影响很大 关键词：     

Studies on basicity of alkali metal catron exchanged β and X zeolites by pyrrole-IR spectroscopy

The strength of basic sites has been measured by pyrrole-IR on alkali metal cation exchanged β and X zeolites, as well as NaOH loaded Naβ. The influence of cation type and the structure of zeolites on their basicity has been studied. The acidic and basic properties of the samples were investigated by NH3-TPD and isopropanol reaction. It was shown that the strength of basic sites on samples could be characterized by the shift of vNH band in the pyrrole-IR spectra. The framework oxygen charges were calculated from the Sanderson electronegativity. The changes in basic properties with various alkali metal cation are consistent with the changes of local oxygen charges of the zeolite framework.     

Ni(111)表面一氧化碳和氢共吸附的密度泛函理论研究

本文用密度泛函理论(DFT)的总能计算研究了一氧化碳和氢原子在Ni(111)表面上p(2×2)共吸附系统的原子结构和电子态，结果表明CO和H原子分别被吸附于两个对角p(1×1)元胞的hcp和fcc位置.以氢分子和CO分子作为能量参考点，总吸附能为2.81 eV，相应的共吸附表面功函数φ为6.28 eV.计算得到的C—O，C—Ni和H—Ni的键长分别是1.19?, 1.96?和 1.71?，并且CO分子以C原子处于hcp的谷位与金属衬底原子结合.衬底Ni(111)的最外两层的晶面间距在吸附后的相对变化分别是 关键词： Fisher-Tropsch反应 催化作用 Ni(111) p(2×2)/(CO+H) 共吸附     

介质折射率对一维三元光子晶体带隙的影响

利用光学传输矩阵法,数值模拟了一维二元、三元光子晶体的带隙结构,得出:三元光子晶体的主带隙略宽于二元光子晶体的主带隙;三元光子晶体的主带隙主要取决于最高折射率的介质和最低折射率的介质,而与居于两者之间的介质关系不大,并作出了相应的关系曲线。最后推导了三元光子晶体的色散关系。     

Isometries of the Dirichlet space among the composition operators

We show that every composition operator which is an isometry of the Dirichlet space is induced by a univalent full map of the disk into itself that fixes the origin. This is an analogue of the Hardy space result for inner functions due to Nordgren. The proof relies on the Stone-Weierstrass theorem and the Riesz representation theorem.

     

O′-β′复相Sialon陶瓷中相组成的控制

用Si₃N₄,SiO₂和Al₂O_?作原料,以Y₂O_?为添加剂,研究了O’-β’所在的四个相容性区中组成,于1400—1800℃之间,O’和β’的形成动力学。O’于1400℃开始生成,1600℃达到最大形成量。高于1600℃,O’减少乃至消失。研究发现,O’的这种不稳定性,并非自身热分解的结果。Al含量的增加,液相出现和β’的形成,才是导致O’-Sialon溶解而消失的原因。 此外,认为Si₃N₄-O’(x=0.3)-Y₂Si₂O₇-YAG相容性区,是在制备具有合理的O’-β’平衡相组成的复相陶瓷时,可供实际选用的组成区。     

The effects of doubly excited states on ionization balance

The effects of highly doubly excited states on ionization balance are investigated. In the calculation, A Collisional-Radiative model in Detailed-Configuration-Accounting (DCA) is applied to population calculations for NLTE plasmas. Configuration-averaged rate coefficients that needed in the rate equations are obtained based on the first order perturbation theory. The Hatree-Fock-Slater self-consistent-field method is used to calculate the electron wave functions. The mean ionization stage of high-Z plasma Lu is presented. The comparison shows that the mean ionization stage increases more than 3 stages when doubly excited states 5l6l' and 5l5l' are not included in the population calculations.     

NiTi合金中马氏体相的低频力学谱研究

我们用最近研制成功的LMA型低频力学谱测试系统对NiTi合金马氏体相进行了在很大频率范围内（0．003～1Hz）的低频等温力学谱和温度谱的测量．我们研究的形状记忆合金NiTi（Ni50．2at％）试样长34mm，直径1mm细丝．经一定热处理，分别在333K．343K和353K做了内耗随频率的变化的测量。实验表明：频率越小，内耗越大，也就是内耗随频率减少而增大。同时我们采用阶梯升温的方法在八个温度下每个温度测量三种频率（1Hz，0．1Hz，0．01Hz）的内耗，结果清楚地表明：不同频率下，内耗峰都出现在372K（99℃）。而且频率越低，峰高越高。这是具有相变峰的特点：相变峰的峰温不随测量频率不同而变化，相变峰高度随频率减少而增大。我们还测量了在1Hz与0．5Hz频率下内耗随温度的变化。本文用马氏体相的位错理论初步讨论了上述实验结果。     

Remote stereocontrol by the sulfinyl group: Mukaiyama aldol reactions of (S)-2-[2-(p-tolylsulfinyl)phenyl]acetaldehyde in the asymmetric synthesis of β-hydroxyacids and 1,3-diols

(S)-2-[2-(p-Tolylsulfinyl)phenyl]acetaldehyde reacts with different O-silylated ketenethioacetals in the presence of Yb(OTf)₃ yielding β-hydroxythioesters in high yields and diastereoselectivities. The obtained compounds were readily transformed into β-hydroxyacids and their corresponding diols. These Mukaiyama aldol reactions are a direct evidence of the ability of the sulfinyl group to control 1,5- and 1,6-asymmetric induction processes.     

A new rule of vibration sampling for predicting acoustical radiation from rectangular plates

Structural surface velocity distribution is often used to predict structural borne sound radiation. However the sampling interval of velocity should be chosen carefully to increase the prediction accuracy and to reduce the system cost. In this paper, several factors affecting the sampling interval are theoretically analyzed and discussed for a vibrating baffled rectangular plate. A new rule for the determination of the sampling interval is formulated. Using this rule, the results from both numerical simulations and experiments may be explained well.