紫外水质在线分析仪校准方法的研究

紫外水质在线分析仪检测数据的准确性对环保计量影响很大,建立一套完善的校准方法,定期对紫外水质在线分析仪进行校准是环保计量工作的当务之急。通过长期的实践摸索,对各种紫外水质在线分析仪进行了系统的检测和论证,初步建立了一套可靠的校准方法。该方法科学合理,简便易行,各项指标评价结果符合仪器的设计性能及实际测试工作要求。     

寄生回路稳定性分析及制导控制相关设计方法研究

针对雷达制导系统由于隔离度及天线罩折射率导致的高空、低动压条件下寄生回路稳定性低的问题,提出了一种制导控制相关设计方法;首先建立了某型主动雷达制导地空导弹寄生回路线性化数学模型并分析了其稳定性;其次,提出了一种制导控制相关设计方法,即在法向过载控制系统设计时考虑寄生回路的影响;仿真结果表明基于制导控制相关设计方法得到法向过载控制系统可以大大提高寄生回路的稳定性,降低了制导系统对天线罩折射率的要求。     

Stabilization of Palladium Nanoparticles on Nanodiamond–Graphene Core–Shell Supports for CO Oxidation

Nanodiamond–graphene core–shell materials have several unique properties compared with purely sp²‐bonded nanocarbons and perform remarkably well as metal‐free catalysts. In this work, we report that palladium nanoparticles supported on nanodiamond–graphene core–shell materials (Pd/ND@G) exhibit superior catalytic activity in CO oxidation compared to Pd NPs supported on an sp²‐bonded onion‐like carbon (Pd/OLC) material. Characterization revealed that the Pd NPs in Pd/ND@G have a special morphology with reduced crystallinity and are more stable towards sintering at high temperature than the Pd NPs in Pd/OLC. The electronic structure of Pd is changed in Pd/ND@G, resulting in weak CO chemisorption on the Pd NPs. Our work indicates that strong metal–support interactions can be achieved on a non‐reducible support, as exemplified for nanocarbon, by carefully tuning the surface structure of the support, thus providing a good example for designing a high‐performance nanostructured catalyst.     

Effect of annealing temperature on photocatalytic activity of ZnO thin films prepared by sol-gel method

Zinc oxide thin films are deposited on Si and quartz substrates using the sol-gel method. The thin films, annealed at 400, 600 and 800 °C respectively, are characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), atomic force microscopy (AFM), ultraviolet-visible spectrophotometer (UV-Vis), fluorescence spectrometer (FL) and the photocatalytic activity is tested by the decomposition of methyl orange dye under UV illumination. The results show that the mean grain size, surface-to-volume ratio, rms roughness and degradation efficiency of the thin films increases with increasing annealing temperature. In particular, ZnO thin film annealed at 800 °C exhibits the highest photocatalytic activity, degrading methyl orange by almost 88% in 180 min. Photocatalytic reaction mechanism of the ZnO thin films is discussed in detail, and the oxygen defects are proposed to be the active sites of the ZnO photocatalyst.     

Unusual chromatographic enantioseparation behavior of naproxen on an immobilized polysaccharide-based chiral stationary phase

Enantioseparation of naproxen was performed on an immobilized polysaccharide-based chiral stationary phase (CSP), Chiralpak IA, in the normal-phase mode. The effects of polar alcohol modifier in mobile phase and column temperature on retention, enantioseparation, and elution order were investigated. Two unusual phenomena were observed. One was solvent-induced reversal of elution order for the two enantiomers. Not only the type but also the content of polar alcohol modifier could induce the reversal. Another uncommon phenomenon was peak deformation under some chromatographic conditions.     

Schlieren成像和声场可视化

Schlieren技术是利用声场引起透明媒质光折射率的变化而实现声场可视化的光学成像技术。它具有对声场无干扰、快速、瞬态成像的特点。本文利用二维光学Fourier变换分析了Schlieren技术的成像原理,在采用连续激光和高速ICCD的Schlieren成像系统中,实验研究了平面波声场和线聚焦声场中换能器光学校准方法和声压的定量检测技术。发展声场瞬态和动态成像技术,观测了声波的聚焦过程和固-液界面的声场分布和变化。这些结果表明Schlieren技术是一种有效的声场可视化和定量检测的光学成像技术。     

膜层厚度对金属薄膜光学常数的影响

从麦克斯韦方程出发,可以得到超薄金属膜层光学常数n、k与其厚度有关系的理论依据。采用电阻热蒸发和电子束热蒸发的方法在K9玻璃基底上分别沉积了不同厚度的Cu膜、Cr膜、Ag膜,由椭偏法检测、Drude模型拟合,获得了不同厚度Cu膜、Cr膜、Ag膜光学常数n、k随波长λ的变化规律。超薄金属薄膜与块状金属的光学常数相差较大,随着薄膜厚度的增加,n、k值趋近于块状金属。通过对样品膜层吸收、色散特性的分析,发现连续金属薄膜在可见光波段对长波的吸收较大,而且相比于介质薄膜平均色散率高10mn～102nm量级。     

浸渍法制备硅钨酸修饰的炭载钯催化剂电催化甲酸氧化

用浸渍的方法制备了硅钨酸（SiWA）修饰的炭载Pd(Pd/C-SiWA)催化剂。 计时电流曲线研究表明,在Pd/C和Pd/C-SiWA催化剂电极上,3000 s时的电流密度分别为0.013和0.082 A/mg,分别为10 s时电流密度的2.5%和14.1%。 结果表明,Pd/C-SiWA催化剂对甲酸氧化的电催化稳定性要远远优于Pd/C催化剂。 这是因为Pd/C催化剂上SiWA的修饰抑制了甲酸的自分解, 从而减小了CO的毒化作用,改进了Pd/C催化剂对甲酸氧化的电催化和稳定性。     

完备强对偶原子分配格上的不可约极小并分解及其应用

在完备强对偶原子分配格上引入了不可约极小并分解的概念,给出了元素存在不可约极小并分解的一些充要条件.证明了当元素恰有一个下邻时,该元索就足完全并既约元;有两个下邻时,元素的不可约极小并分解与不可约完全并既分解是等价的;下邻多于两个时,元素的不可约极小并分解不一定足不可约完全并既分解.最后证明了模糊关系方程有极小解的充要条件是方程左边有大于等于右手项的系数或右手项系数有不可约极小并分解.     

Effects of concentration of nonionic surfactant and molecular weight of polymers on the morphology of anisotropic polystyrene/poly(methyl methacrylate) composite particles prepared by solvent evaporation method

The effects of the concentration of polyoxyethylene octylphenyl ether (OP-10) as a nonionic surfactant and the molecular weight of polymers (polystyrene (PS) and poly(methyl methacrylate) (PMMA)) on the morphology of anisotropic PS/PMMA composite particles were investigated. In the case of polymers with lower molecular weight (M _w ≈ 6.0 × 10⁴ g/mol), the PS/PMMA composite particles have dimple, via acorn, to hemispherical shapes along with the increase of the OP-10 concentration. On the other hand, when the polymers have higher molecular weight (M _w ≈ 3.3 × 10⁵ g/mol), the morphology of PS/PMMA composite particles changed from dimple, via hemispherical, to snowman-like structure while the concentration of OP-10 was increased. Furthermore, thermodynamic analysis was first simply made by spreading coefficients, and the results indicated that both the concentration of OP-10 aqueous solution and the molecular weight of polymers were very important to the final morphology of anisotropic composite particles.