A study on structure-performance relationship of overcharged 18650-size Li4Ti5O12/LiMn2O4 battery

The electrochemical properties and thermal generation behavior of 18650 Li₄Ti₅O₁₂/LiMn₂O₄ batteries were tested before and after overcharge. The experimental results showed that after overcharge, the specific capacity decreased obviously. The higher the current density was, the more obvious the capacity decreased. For instance, the overcharged battery had almost no capacity when the current density increased to 5C. At the same time, the overcharged battery presented a much more apparent thermal runaway trend compared to the normal battery. After measuring the electrochemical impedance spectroscopy of the batteries and characterizing the crystal structure/nanostructure of the electrode materials, these phenomena could be attributed to the following two reasons: (1) the decomposition of the electrolyte arisen from the overcharge process resulted in increased internal resistance; (2) the thermal runaway due to the increased internal resistance resulted in the damage to crystal structure/nanostructure and aggregation of the electrode materials, thus leading to the secondary decrease in capacity.     

Chiral Bifunctional Phosphine‐Carboxylate Ligands for Palladium(0)‐Catalyzed Enantioselective C−H Arylation

Previous enantioselective Pd⁰‐catalyzed C?H activation reactions proceeding via the concerted metalation‐deprotonation mechanism employed either a chiral ancillary ligand, a chiral base, or a bimolecular mixture thereof. This study describes the development of new chiral bifunctional ligands based on a binaphthyl scaffold which incorporates both a phosphine and a carboxylic acid moiety. The optimal ligand provided high yields and enantioselectivities for a desymmetrizing C(sp²)?H arylation leading to 5,6‐dihydrophenanthridines, whereas the corresponding monofunctional ligands showed low enantioselectivities. The bifunctional system proved applicable to a range of substituted dihydrophenanthridines, and allowed the parallel kinetic resolution of racemic substrates.     

Physicochemical properties of sodium succinate sulfate and effects on BaSO4 suspension

Sodium succinate sulfate (MAPEG1500-OSO₃Na) was prepared using maleic anhydride (MA) and polyethylene glycols (PEG1500) as raw materials. The structure was characterized by Fourier transform infrared spectrometry (FTIR) and ¹H-nuclear magnetic resonance (¹H NMR). Its physicochemical properties, such as surface activity, adsorption behavior, spreading performance, and rheological property, were investigated by static/dynamic surface tension (DST) measurements, contact angle techniques, and rheological techniques at 25°C. Surface tension measurement for this surfactant is about 17?mN/m. The DST results indicated that the adsorption process is mixed diffusion-kinetic adsorption mechanism. The spreading measurement demonstrated that MAPEG1500-OSO₃Na possessed an excellent spreading ability. Besides, the dispersion performances of MAPEG1500-OSO₃Na on barium sulfate (BaSO₄) particles under different conditions have been studied by the weighing method and transmission electron microscope (TEM). These results showed that there exist optimum pH value and added amount of MAPEG1500-OSO₃Na corresponding to the highest dispersion rate.     

The influence of nanoparticle shape on bilateral exocytosis from Caco-2 cells

Nanoparticles are able to be excreted from both apical and basolateral sides after taken up by cells. Compared to nanospheres, nanorods preferred basolateral exocytosis to apical exocytosis.     

Silver-catalyzed decarboxylative cross-coupling of α-keto acids with alkenes giving approach to chalcones

A silver-catalyzed decarboxylative cross-coupling of α-keto acids with alkenes is reported. The method, with a wide range of substrate tolerance and mild operational conditions, can produce various chalcone derivatives in moderate to high yields from easily available starting materials.     

Design and synthesis of chitin synthase inhibitors as potent fungicides

Chitin is a structural component of fungal cell walls but is absent in vertebrates,mammals,and humans.Chitin synthase is thus an attractive molecular target for developing fungicides.Based on the structure of its donor substrate,UDP-N-acetyl-glucosamine,as well as the modelled structure of the bacterial chitin synthase NodC,we designed a novel scaffold which was then further optimized into a series of chitin synthase inhibitors.The most potent inhibitor,compound 13,exhibited high chitin synthase inhibitory activity with an IC_(50) value of 64.5 μmol/L All of the inhibitors exhibited antifungal activities against the growth of agriculturally-destructive fungi,Fusarium graminearum,Botrytis cinerea.and Colletotrichum lagenarium.This work presents a new scaffold which can be used for the development of novel fungicides.     

Determination and Characterization of the Uptake of Voriconazole in Human Lung Epithelial Cells by High-Performance Liquid Chromatography–Tandem Mass Spectrometry

Voriconazole is used to prevent invasive pulmonary aspergillosis. However, little is known about the concentrations of voriconazole in human lung epithelial cells (A549), which is the target for preventing invasive pulmonary aspergillosis. The goal of this study was to develop a high-performance liquid chromatography–tandem mass spectrometry method to quantify voriconazole in A549 cells. A triple-quadrupole mass spectrometer in selected reaction monitoring mode was used with positive electrospray ionization. The total duration of each run was 5?min. The calibration curves fit a least squares model for the voriconazole concentration ranging from 0.625 to 160?ng/mL. Intraday and interday coefficients of variation were less than 10%. Recoveries at the concentrations of the quality control samples where greater than 85%, and the matrix effects showed that the ratios of the peak response exhibited a 15% suppression of the signal in the matrix compared to water. Voriconazole may penetrate A549 cells. However, the voriconazole uptake was slow in A549 cells, reaching a plateau at 2?h, where the dose-dependent intracellular voriconazole concentrations were 1.98?±?0.38, 4.43?±?0.54, and 8.14?±?0.52?ng/mg protein for extracellular voriconazole concentrations of 5, 10, and 20?µg/mL, respectively. The uptake of voriconazole by A549 cells was linear at extracellular concentrations from 0 to 20?µg/mL. This study established a rapid and sensitive method suitable for determining voriconazole in A549 cells and described the kinetic properties of the absorption of voriconazole by A549 cells.     

NMR and theoretical study on the linking properties of peroxovanadium(V) complexes with the 3-aminomethyl-pyridine derivatives

To understand the substitution effects of 3-aminomethyl-pyridine on the reaction equilibrium, the interactions between a series of 3-aminomethyl-pyridine derivatives and peroxovanadium(V) complex [OV(O₂)₂(D₂O)]^?/[OV(O₂)₂(HOD)]^? in solution were explored by the combined use of multinuclear (¹H, ¹³C, and ⁵¹V) magnetic resonance spectroscopy together with HSQC in 0.15 M NaCl ionic medium for mimicking the physiological conditions. Some direct NMR data are given for the first time. The relative reactivity among the 3-aminomethyl-pyridine derivative ligands are N-(pyridin-3-ylmethyl)acetamide (1) ≈ N-(pyridin-3-ylmethyl)propionamide (2) > N-(pyridin-3-ylmethyl)pivalamide (3) > t-butyl(pyridin-3-ylmethyl)carbamate (4). The competitive coordination results in the formation of a series of new six-coordinate peroxovanadium species [OV(O₂)₂L]^? (L = 1–4). The results of density functional calculations indicated that the solvation effects play an important role in these reactions, providing a reasonable explanation on the relative reactivity of the 3-aminomethyl-pyridine derivatives.     

Biosynthetic approach to modeling and understanding metalloproteins using unnatural amino acids

Metalloproteins have inspired chemists for many years to synthesize artificial catalysts that mimic native enzymes.As a complementary approach to studying native enzymes or making synthetic models,biosynthetic approach using small and stable proteins to model native enzymes has offered advantages of incorporating non-covalent secondary sphere interactions under physiological conditions.However,most biosynthetic models are restricted to natural amino acids.To overcome this limitation,incorporating unnatural amino acids into the biosynthetic models has shown promises.In this review,we summarize first synthetic,semisynthetic and biological methods of incorporates unnatural amino acids(UAAs)into proteins,followed by progress made in incorporating UAAs into both native metalloproteins and their biosynthetic models to fine-tune functional properties beyond native enzymes or their variants containing natural amino acids,such as reduction potentials of azurin,O_2 reduction rates and percentages of product formation of HCO models in Mb,the rate of radical transport in ribonucleotide reductase(RNR)and the proton and electron transfer pathways in photosystemⅡ(PSⅡ).We also discuss how this endeavour has allowed systematic investigations of precise roles of conserved residues in metalloproteins,such as Metl21 in azurin,Tyr244 that is cross-linked to one of the three His ligands to CuB in HCO,Tyr122,356,730 and 731 in RNR and TyrZ in PSⅡ.These examples have demonstrated that incorporating UAAs has provided a new dimension in our efforts to mimic native enzymes and in providing deeper insights into structural features responsible high enzymatic activity and reaction mechanisms,making it possible to design highly efficient artificial catalysts with similar or even higher activity than native enzymes.     

Improved synthesis and low-temperature performance of a series of saturated α-branched fatty acids

Five saturated α-branched fatty acids, also known as Guerbet acids, including α-propylhexyl acid (G ₁ ), α-butylhexyl acid (G ₂ ), α-propyloctyl acid (G ₃ ), α-butyloctyl acid (G ₄ ), and α-hexyloctyl acid (G ₅ ), were synthesized in high yields by four-step reaction. Colorless, almost odorless, and oily products were obtained with high purity, whose structures were confirmed by GC, ¹H/¹³C NMR, and ESI–MS characterization. G ₁ , G ₃ , and G ₄ had pour points lower than ?60 °C, while G ₂ and G ₅ showed higher pour points (?42 °C and 6 °C, respectively) because of their molecular symmetry. Considering the low-temperature properties, G ₁ , G ₃ , G ₄ , and even G ₂ held great potential applications in the lubricant and oilfield.