新型4-羟色胺类化合物的合成及生物活性

以4-羟基吲哚为原料,经吲哚环4位乙酰基化、3位亲电取代、酰胺化和还原加氢等反应合成目标化合物7.通过核磁共振氢谱及碳谱对化合物进行结构表征,并对目标化合物进行体外抗氧化生物活性测试.初步生物活性测试结果表明,化合物7a,7b,7c和7d对DPPH·均有很强的清除作用(清除率为85.25%~90.73%),7e,7f,7g,7h作用较差;目标化合物与Vc相比,对·OH的清除作用稍差,最高清除率25.66%(Vc的最高清除率为34.67),但各化合物整体水平相当;在清除O-2·能力上化合物7a,7d,7g,7h最大清除率(分别为19.34,35.35,27.93和31.74)均强于同等浓度的Vc(17.58).     

煤直接液化油中混合酚的分离研究

利用分子筛择形特点，对煤直接液化油中的混合酚实施高效分离。本研究选取间甲酚和对甲酚作为分离煤直接液化油馏分段混合酚的模型化合物，采用化学液相沉积法对HZSM-5吸附剂的孔口结构进行改变，分析分子筛硅铝比及颗粒粒径对模型化合物间甲酚和对甲酚吸附分离性能的影响，以获得高性能固相吸附剂，并将其应用于180-190℃馏分段混合酚分离。结果表明，当分子筛硅铝比为25、粒径为3-5 μm时，分子筛的孔口结构调节效果最优；当正硅酸乙酯的最小用量为0.2 mL/g时，固相吸附剂的吸附量为0.03 g/g，对甲酚选择性高于95%。由于外表面沉积物对吸附剂的孔口结构变化，导致对甲酚选择性的提高。进一步采用HZSM-5（1）吸附剂对真实煤直接液化油混合酚的分离中发现，苯酚和对甲酚的选择性均达到100%。     

Polypyrrole Shell@3D‐Ni Metal Core Structured Electrodes for High‐Performance Supercapacitors

Three‐dimensional (3D) nanometal films serving as current collectors have attracted much interest recently owing to their promising application in high‐performance supercapacitors. In the process of the electrochemical reaction, the 3D structure can provide a short diffusion path for fast ion transport, and the highly conductive nanometal may serve as a backbone for facile electron transfer. In this work, a novel polypyrrole (PPy) shell@3D‐Ni‐core composite is developed to enhance the electrochemical performance of conventional PPy. With the introduction of a Ni metal core, the as‐prepared material exhibits a high specific capacitance (726 F g^?1 at a charge/discharge rate of 1 A g^?1), good rate capability (a decay of 33 % in C_sp with charge/discharge rates increasing from 1 to 20 A g^?1), and high cycle stability (only a small decrease of 4.2 % in C_sp after 1000 cycles at a scan rate of 100 mV s^?1). Furthermore, an aqueous symmetric supercapacitor device is fabricated by using the as‐prepared composite as electrodes; the device demonstrates a high energy density (≈21.2 Wh kg^?1) and superior long‐term cycle ability (only 4.4 % and 18.6 % loss in C_sp after 2000 and 5000 cycles, respectively).     

pH-Sensitive Oscillatory Motion of a Urease Motor on the Urea Aqueous Phase

A self-propelled object coupled with an enzyme reaction between urease and urea was investigated at the air/aqueous interface. A plastic object that was fixed to a urease-immobilized filter paper was used as a self-propelled object, termed a urease motor, placed on an aqueous urea solution. The driving force of the urease motor is the difference in the surface tension around the object. Oscillatory motion or no motion was triggered depending on the initial pH of the urea solution. Both the frequency and maximum speed of the oscillatory motion varied depending on the initial pH of the water phase. The mechanisms underlying the oscillatory motion and no motion were discussed in relation to the bell-shaped enzyme activity of urease in the enzyme reaction and the surface tension around the urease motor.     

Selective Catalytic Isomerization of β-Pinene Oxide to Perillyl Alcohol Enhanced by Protic Tetraimidazolium Nitrate

A series of tetraimidazolium salts with different anions was prepared and applied in the isomerization of β-pinene oxide. After examining the activity of different catalysts, a remarkable enhancement of the selectivity of perillyl alcohol (47 %) was obtained over [PEimi][HNO₃]₄ under mild reaction conditions and using DMSO as the solvent. Furthermore, noncovalent interactions between solvent molecules and the catalyst were found by FT-IR spectroscopy and confirmed by computational chemistry. The homogeneous catalyst showed excellent stability and was reused up to six times without significant loss.     

单晶硅晶格间距的测量技术进展及应用

单晶硅晶格间距是许多重要物理常数测量的基础。本文介绍了硅晶格间距测量技术的发展历程,包括X射线干涉仪直接测量和晶格比较仪间接测量两种方法,以及影响测量结果不确定度的关键因素。得益于晶格间距测量的进展,在纳米尺度,硅晶格间距被国际计量局(BIPM)批准成为新的米定义复现形式。最后介绍了硅晶格在计量学中的应用,以及基于硅晶格实现纳米几何量测量的溯源体系的研究趋势。