植物胞外钙调素与拮抗剂W7-Agarose结合作用的荧光光谱法研究

W 7-agarose是常用的细胞外CaM功能的拮抗剂,本实验采用荧光光谱法研究了水溶液中钙调素拮抗剂W 7-agarose与植物胞外钙调素的相互结合反应。W 7-agarose是一种将W 7-共价连接到颗粒型agarose(琼脂糖)的粒子。W 7-agarose颗粒较大且容易沉淀,静置5m in后,溶液中的荧光强度完全由游离的CaM产生。在溶液中加入W 7-agarose后,溶液中一部分CaM与其结合后沉降至荧光比色皿底部,导致溶液中CaM的荧光强度下降。由此可以确定溶液中游离CaM的浓度。根据公式lg{[Q]t(F0-F)/F0}=nlg{[Q]tF/F0} lgnK[B]t,从而计算出配位体系的结合常数和配比。研究表明:二者以摩尔比1∶1结合,其平衡常数为4.9×105。由此进一步计算了W 7-agarose对胞外钙调素的拮抗率,在拮抗剂W 7-agarose浓度达到15~20μmol/L时,拮抗率可达到90%以上,与文献报道的生物学体内实验结果一致,从分子水平上解释了W 7-agarose与CaM的结合作用。     

Mixed ligand system of cysteine and thioglycolic acid assisting in the synthesis of highly luminescent water-soluble CdTe nanorods

Highly luminescent water-soluble CdTe nanorods were prepared with the assistance of the mixed ligand system of cysteine and thioglycolic acid; the aspect ratio and photoluminescence of the CdTe nanorods could be controlled by the refluxing time.     

有机硅耐磨透明涂层的固化分析

ＦＴＩＲ、ＴＧ、ＴＢＡ等对有机硅耐磨涂料（有机硅溶胶）的热固化过程研究表明有机硅胶体中缔合羟基间的脱水缩合速率很高；羟基脱水程度与固化温度有关，温度越高，达平衡时羟基的浓度越低，在１０５～１３０℃间羟基的浓度变化最大，加入适当的固化剂，对羟基的脱水交联有促进作用，在较高的固化温度下，反应体系中出现了环氧环异构化产生的酮羰基的吸收峰     

Analysis of acyclovir by high performance capillary electrophoresis with on-column amperometric detection

The separation of acyclovir (ACV) by high performance capillary electrophoresis (HPCE) with on-column amperometric detection using alpha-amino-5-mercapto-3,4-dithiazole (AMD) as internal standard is described. The calibration line was linear in the range of 0.5-20 mg/L of ACV. The detection limit was 0.15 mg/L of ACV. Its recovery ranged from 98 to 101% with relative standard deviations (RSDs) from 1.9 to 3.2% (n = 5). This method was successfully used for determining ACV in some pharmaceuticals and human urine. Comparable results with HPCE with ultraviolet (UV) detection and amperometric detection were obtained.     

Topology evolution and gelation mechanism of agarose gel

Kinetics as well as the evolution of the agarose gel topology is discussed, and the agarose gelation mechanism is identified. Aqueous high melting (HM) agarose solution (0.5% w/v) is used as the model system. It is found that the gelation process can be clearly divided into three stages: induction stage, gelation stage, and pseudoequilibrium stage. The induction stage of the gelation mechanism is identified using an advanced rheological expansion system (ARES, Rheometric Scientific). When a quench rate as large as 30 deg C/min is applied, gelation seems to occur through a nucleation and growth mechanism with a well-defined induction time (time required for the formation of the critical nuclei which enable further growth). The relationship between the induction time and the driving force which is determined by the final setting temperature follows the 3D nucleation model. A schematic representation of the three stages of the gelation mechanism is given based on turbidity and rheological measurements. Aggregation of agarose chains is promoted in the polymer-rich phase and this effect is evident from the increasing mass/length ratio of the fiber bundles upon gelation. Continuously increasing pore size during gelation may be attributed to the coagulation of the local polymer-rich phase in order to achieve the global minimum of the free energy of the gelling system. The gel pore size determined using turbidity measurements has been verified by electrophoretic mobility measurements.     

Study on analysis of153Sm-EDTMP stability in vitro and vivo by HPLC

The behavior of¹⁵³Sm-EDTMP in vitro and vivo is analyzed by the size exclusion HPLC. The experimental results show that EDTMP amounts have an obvious effect on the stability in vitro and uptake of¹⁵³Sm-EDTMP in the liver. HPLC analysis of urine sample indicates that¹⁵³Sm-EDTMP es excreted in the original form. The behavior in vivo of¹⁵³Sm-EDTMP containing 4 μg is similar to that of¹⁵³Sm-EDTMP containing 50 μg EDTMP at 1 h post-injection.     

Geometry,stability and aromaticity of β-diketiminate-coordinated alkaline-earth compounds

Alkaline-earth (Ae) metals have attracted a wealth of interdependent research from synthetic chemists. In Ae-catalyzed organometallic reactions, β-diketiminate is a typical ligand used to stabilize Ae catalysts by forming six-membered rings comprising Ae metals. Herein, studies focusing on the configuration of β-diketiminate-coordinated Ae compounds observed that the CC and CN bonds are homogeneous and unchanged. Furthermore, energetic studies observed that the formation of the Ae-incorporated six-membered rings results in enhanced stability of >20 kcal/mol. The nucleus-independent chemical shifts, anisotropy of the induced current density, and molecular orbital analyses demonstrated the non-aromaticity of the β-diketiminate-coordinated Ae compounds. The improved stability of these compounds can be explained by the delocalization of the π electrons derived from the β-diketiminate moiety.     

六甲基环三硅氧烷非平衡聚合的研究

六甲基环三硅氧烷(D_3)在为催化剂,二甲亚砜为促进剂的情况下聚合,得到了分子量分布窄且没有大环体的聚二甲基硅氧烷。本文指出了反应溶液中溶解的氧会降低催化剂的活性。在除去了溶液中的氧以后,聚合反应速度大为加快,D_3转化率几乎达100％,而且得到的聚合物是活性高分子,可以继续进行聚合。同时还研究了在除氧以后D_3非平衡聚合反应的特点。     

Improved hygrothermal durability of flax/polypropylene composites after chemical treatments through a hybrid approach

There are growing research interests in flax fibers due to their renewable ‘green’ origin and high strength. However, these natural fibers easily absorb moisture and have poor adhesion with polymer matrix leading to low interfacial strength for the composites. A hybrid chemical treatment technique combining alkali (sodium hydroxide) and silane treatments is adopted in the current study to modify flax fibers for improved performances of flax/polypropylene composites. Changes in chemical composition, microstructure, wettability, surface morphology, crystallinity and tensile properties of single flax fiber before and after chemical treatments were comprehensively characterized using techniques including SEM, FTIR, AFM, XRD, micro-fiber tester, etc. It was found that hemicellulose and lignin at the fiber surface were removed due to alkali treatment, which helped to reduce moisture absorption of the composites. Alkali-treated flax fibers were later subjected to silane treatment, which helped to improve the compatibility between flax fiber and polypropylene matrix. After alkali-silane hybrid chemical treatment, moisture absorption of the composites was further decreased. At the same time, the interfacial bonding strength between flax and polypropylene is significantly enhanced. All these results validate the great advantage of the hybrid chemical treatment approach for flax/polypropylene composites, which has the potential to promote the application of chemical treatment techniques in the plant fiber composite industry.

Graphic abstract