Transient and Stationary Simulations for a Quantum Hydrodynamic Model

The transient and stationary characteristics of a one-dimensional quantum hydrodynamic model are comparatively studied for semiconductor charge transport in a resonant tunnelling diode. When the bias is not small, our numerical results show a deviation of the asymptotic transient solutions from the stationary ones. A dynamic instability accounts for such deviation. The stationary quantum hydrodynamic model is therefore unsuitable in general for simulating quantum devices.     

An All-Solid-State Tunable Dual-Wavelength Ti：Sapphire Laser with Quasi-Continuous-Wave Outputs

A high power dual-wavelength Ti：sapphire laser system with wide turning range and high efficiency is described, which consists of two prism-dispersed resonators pumped by an a11-solid-state frequency-doubled Nd：YAG laser. Tunable dual-wavelength outputs, with one wavelength range from 750nm to 795nm and the other from 80Ohm to 850nm, have been demonstrated. With a pump power of 23 W at 532nm, a repetition rate of 6.5kHz and a pulse width of 67.6ns, the maximum dual-wavelength output power of 5.6 W at 785.3nm and 812.1 run, with a pulse width of 17.2ns and a line width of 2nm, has been achieved, leading to an optical-to-optical conversion efficiency of 24.4%.     

Atomic coherence in nondegenerate four-wave mixing

Two-photon resonant nondegenerate four-wave mixing (NFWM) with the addition of a coupling field in Ba atomic vapour has been studied. We find that coherence of the atomic level transitions leads to suppression of the NFWM signal, giving rise to a dip with a linewidth that is linearly proportional to the intensity of the coupling field.     

Impulsive control of chaotic systems with exogenous perturbations

The impulsive control of chaotic systems, which are subjected to unbounded exogenous perturbations, is considered. By using the theory of impulsive differential equation together with the fuzzy control technique, the authors propose an impulsive robust chaos controlling criterion expressed as linear matrix inequalities (LMIs). Based on the proposed control criterion, the procedure for designing impulsive controllers of common (perturbed) chaotic systems is provided. Finally, a numerical example is given to demonstrate the obtained theoretical result.     

Influence of remaining C on hardness and emissivity of SiC/SiO2 nanocomposite coating

SiC/SiO₂ nanocomposite coating was deposited by electron beam-physical vapor deposition (EB-PVD) through depositing SiC target on pre-oxidized 316 stainless steel (SS) substrate. High melting point component C remained and covered on the surface of ingot after evaporation. When SiC ingot was reused, remaining C had an effect on the composition, hardness and emissivity of SiC/SiO₂ nanocomposite coating. The composition of ingot and coating was studied by X-ray photoelectron spectroscopy (XPS). The influence of remaining C on hardness and spectral normal emissivity of SiC/SiO₂ nanocomposite coating was investigated by nanoindentation and Fourier transform infrared spectrum (FTIR), respectively. The results show that remaining C has a large effect on hardness and a minor effect on spectral normal emissivity of SiC/SiO₂ nanocomposite coating.     

有序排列PMMA 模板法合成三维有序纳米孔道MgO

"利用由无乳化剂的乳液聚合法和水浮法联用技术合成得到的有序排列的聚甲基丙烯酸甲酯(PMMA)微球为硬模板,以硝酸镁为镁源,并采用硝酸镁-柠檬酸-乙醇混合溶液浸渍PMMA微球后经干燥以及先后在300 ℃恒温灼烧3 h和500 ℃恒温灼烧5 h,制备出具有有序纳米孔道结构的MgO粒子．应用X射线衍射、高分辨扫描电子显微镜、透射电子显微镜/选区电子衍射以及N2吸附-脱附法等技术表征了PMMA和MgO样品的物理化学性质．结果表明,所得PMMA微球颗粒较为均匀,粒径约为284 nm,且排列规整有序．由PMMA硬模板     

液芯光纤光谱仪

液芯光纤可以使拉曼光谱强度提高103倍。将液芯光纤既作为样品池又作为前置放大系统,研制成功了体积小、重量轻、成本低、灵敏度高的小型拉曼光谱仪。结果表明:通过对液体及溶在液体中的样品进行自发拉曼光谱、共振拉曼光谱的测量,获得了理想的拉曼光谱。     

大视场多CCD拼接相机标定方法研究

介绍了一种多CCD拼接弹道相机的标定方法和步骤,以及标定系统的原理及组成。对相机的光学畸变和大视场拼接物像几何投影关系进行了分析,建立了相机数学模型,并采用最小二乘多元回归分析方法,通过测量相机的内方位元素计算畸变系数,确定了最佳条件下相机数学模型中的各个参数。实验表明利用该方法标定出相机精度方位角测角误差小于10″,高低角测角误差小于15″。     

浅议"对称"

世界是丰富多彩、千差万别的．但众多的物理大师们却说：一切事物规律都是“对称的”．在物理思想中，对称性像基石似的重要．各种事物都具有对称性，它常表现在两个方面，一是体现在物理规律中的对称性；如伽利略相对原理；爱因斯坦相对论；宇称原理等．另一个是体现在数学形态上的对称性．如镜像对称；旋转对称等．本文将浅议一下物理学中的对称．     

矩量法研究平面波导点缺陷引起的散射损耗

对平面波导工艺过程里出现的点缺陷,如气泡、灰尘颗粒等对平面波导内光场造成的散射提供了一种简单而又实用的计算方法。计算基于格林函数方法,并利用矩量法求解积分方程,采用分块矩阵优化算法,使得算法的计算时间直接与点缺陷大小相关,提高了效率。证明了一定大小的点缺陷在特定的波长处会产生很大的散射损耗,证明点缺陷的散射损耗依赖于缺陷大小和光学性质而与其在波导中的位置无直接关系。以二氧化硅平面波导为例,分析了对中心波长1．55μm的入射光场,分别存在气泡和灰尘颗粒两种点缺陷时,散射损耗随点缺陷大小的关系特性,指出工艺过程特别应该避免某些孔径的点缺陷。