Preparation and characterization of ZnO nanorods from NaOH solutions with assisted electrical field

ZnO naorods on ZnO-coated seed substrates were fabricated by solution chemical method from Zn(NO₃)₂/NaOH under assisted electrical field. The working mechanism of electrical field was analyzed and the factors affecting the rod growth such as potential, precursor concentration and growth temperature were elucidated. The structural and optical properties are characterized by SEM, TEM, XRD, HRTEM and UV-vis. The results indicated that the nanorods have wurtzite structure without electrical field and are primarily of zincite structure under electrical field; when the electrical field is 1.1-1.3 V, not only the elevation of ion diffusion and adsorption lower the crystallite/solution interfacial energy and then the crystal nucleation barrier by increasing charge intensity, but also the production of H⁺ through oxidation of OH⁻ increases properly the degree of solution supersaturation near the substrate, and thus lowers the activation energy. Both the two processes do favor to rod growth. With increasing precursor concentration in this system, the average diameter and length of ZnO nanorods increase, leading to decreasing of optical transmittance. The maximum rod growth rate at given concentration of Zn²⁺ occurs at a specific temperature.     

Interference of circularly polarized light: contrast and application in fabrication of three-dimensional periodic microstructures

The contrast of interference pattern formed by two circularly polarized waves and by a linearly polarized wave and a circularly polarized one is discussed. The results are compared with that by two linear beams. It shows that the use of circular light in holographic fabrication of three-dimensional periodic microstructures may remove the necessity of beam ratio and polarization optimization needed in the interference of three linear noncoplanar beams and improve the uniform contrast of resultant pattern simultaneously.     

Optical spectroscopy of Yb/Er codoped NaY(WO4)2 crystal

Erbium and ytterbium codoped double tungstates NaY(WO₄)₂ crystals were prepared by using Czochralski (CZ) pulling method. The absorption spectra in the region 290-2000 nm have been recorded at room temperature. The Judd-Ofelt theory was applied to the measured values of absorption line strengths to evaluate the spontaneous emission probabilities and stimulated emission cross sections of Er³⁺ ions in NaY(WO₄)₂ crystals. Intensive green and red lights were measured when the sample were pumped by a 974 nm laser diode (LD), especially, the intensities of green upconversion luminescence are very strong. The mechanism of energy transfer from Yb³⁺ to Er³⁺ ions was analyzed. Energy transfer and nonradiative relaxation played an important role in the upconversion process. Photoexcited luminescence experiments are also fulfilled to help analyzing the transit processes of the energy levels.     

Quantification of stable minor species in confined flames by cavity ring-down spectroscopy: application to NO

Cavity ring-down spectroscopy (CRDS) is used to measure the NO mole fraction formed in the burnt gases of low-pressure premixed flames. It is shown that the line-of-sight absorption is greatly increased by the contribution of the NO molecules surrounding the burner. This contribution has been quantified by developing a mathematical procedure taking into account the spatial and spectral features of the CRDS measurement. Calculations have been undertaken in the general case of a stable species not consumed in the flame. The most sensitive parameter is the temperature both in the flame and outside the flame. Simulations allow the selection of the best spectroscopic transitions for a given flame (i.e. a given temperature profile), ensuring the weakest influence of the inaccuracy affecting the temperature determination. High quantum states belonging to the A–X (0–1) band of NO have been found to be the most valuable and have led to a NO mole fraction determination with an accuracy of ±13%. NO absorption in the flame was completely masked using the A–X (0–0) band. Finally, the prompt-NO mole fraction formed in a methane/air flame stabilized at 33 Torr is obtained by combining CRDS and laser induced fluorescence techniques. Received: 12 October / Revised version: 1 February 2002 / Published online: 14 March 2002     

CO-laser photoacoustic detection of phosgene (COCl2)

Detection of COCl₂, a highly toxic gas in chemical industry, using laser photoacoustic spectroscopy is presented. The spectrophone system used has a broad band LN₂ cooled CW CO laser as a source of radiation, which operates from 4.8–8.4 um in the mid-infrared. Using an extracavity open longitudinal resonant cell, absorption signals to about 30 CO laser lines in the 5.45 um region could be observed. detection sensitivity has been estimated to be ppb order.This work has been supported by the NSFC     

THE BLOW-UP PROPERTIES OF SOLUTIONS TO A PARABOLIC SYSTEM WITH LOCALIZED NONLINEAR REACTIONS

1IntroductionThispaperisconcernedwithpositivesolutionOfthesemilinearheatequationswithlocalizedreactionssubjecttoeitherinitialconditions(Cauchyproblem)ortheinitialandboundary-value(DirichletorNeumanntype)conditionswherenisaboundeddomaininRe,icEO.Equations(1.1)canbethoughtofasamodeltodescribesomephysicalphenomena(heatpropagation,chemicalreaction)inwhichthenonlinearreactionsinadynndcalsystemtakesplaceonlyatasinglesite.InthesequelforconvenienceweshallsamplycalltheCauchy,initial-Direchlet,orini…     

Mössbauer study of small amounts of iron in graphite,around the diamond-graphite pressure-temperature stability region

An exploratory Mössbauer spectroscopy study of the Fe-C system in the C rich region, prepared by high pressure-high temperature treatment near the graphite-diamond stability line, was made. The results obtained for the different processing conditions give no evidence of Fe intercalation in graphite. The presence of some water in the cell produced hydrated Fe complexes, which can explain the deleterious effect of water or hydrogen in the high pressure diamond synthesis.     

The magnetic properties of Be-codoped GaMnN grown via molecular beam epitaxy

GaMnN and Be-codoped GaMnN were grown via molecular beam epitaxy using a single GaN precursor and their structural and magnetic properties were examined. X-ray diffraction and superconducting quantum interference device (SQUID) measurements revealed that the grown layers are homogeneous without precipitates. The saturation magnetization of GaMnN has increased from ∼4 to ∼16 emu/cm³ via codoping of Be. The d–d exchange interaction between Mn atoms was discussed for the ferromagnetism of GaMnN.     

Working Methods Paper: Critical considerations with respect to the identification of tin species in the environment

Biogeochemical pathways of tin species in the environment are still controversial, e.g. with regard to methylation and transmethylation phenomena, owing to the fact that the identification of methylated tin-compounds is often difficult. The previous tentative identification of a mixed methylbutyltin compound in sediment and biological samples by GC/AAS after hydride generation gave an illustration of this problem. This compound was previously identified in sediments by other authors and also suspected to occur in a contaminated sediment sample from the Boyardville Marina, France. The retention time obtained by GC/AAS corresponded to the actual retention time of a mixed methylbutyltin calibrant. However, additional checks demonstrated that the compound detected was actually monophenyltin. This evidence was produced by a thorough analysis of a selected sediment sample by alternative techniques such as GC/AAS and GC/AES after pentylation, GC/FPD and GC/MS. The results presented highlight the need for a full identification of compounds to avoid mis-interpretation.