基于连续量子级联激光器的1103.4cm–1处NH3混叠吸收光谱特性研究

由于NH3在大气气溶胶化学中具有重要作用,所以快速和精确反演NH3浓度对环境问题非常重要.本文以9.05μm的室温连续量子级联激光器(quantum cascade laser,QCL)作为光源,采用波长扫描直接吸收可调谐二极管激光吸收光谱(tunable diode laser absorption spectroscopy,TDLAS)技术,研究了QCL在1103.4 cm–1的光谱特性,获得了激光器控制的温度电流与波长的关系.设计了QCL二级温控的低压实验平台,测量氨气在1103.4 cm–1处的6条混叠吸收线,在降低压强的情况下谱线展宽变小,使混叠光谱分离,由此计算各条吸收线的线强,进一步对测量不确定度进行分析.针对混叠严重的光谱提出了低压分离单光谱精确反演气体浓度的方法,并进行了实验验证.通过与HITRAN数据库进行结果对比,得出氨气在1103.4 cm–1的实验测量线强值与数据库偏差为2.71%-4.71%,实验测量线强值的不确定度在2.42%-8.92%,极低压条件下反演浓度与实际值的偏差在1%-3%.     

Real-time phase measurement and correction of dynamic multimode beam using a single spatial light modulator

In this Letter,a novel system for adaptively correcting the phase of a dynamic multimode beam is proposed.While using merely one spatial light modulator,the phase measurement of the first-order diffraction pattern and the correction of the zeroth diffraction order are simultaneously realized.The real-time experimental result is obtained at a control rate of 10 Hz.The power-in-the-bucket value is improved from 38.5%to 61.8%,even with fundamental mode content that is consistently below 30%.To the best of our knowledge,this is the first implementation of real-time adaptive correction of the entire multimode beam.     

Multi-reference lens-less Fourier-transform holography with a Greek-ladder sieve array

Lens-less Fourier-transform holography has been actively studied because of its simple optical structure and its single-shot recording.However,a low-contrast interferogram between the reference and object waves limits its signal to noise ratio.Here,multi-reference lens-less Fourier-transform holography with a Greek-ladder sieve array is proposed in the experiment and demonstrated effectively to improve the signal to noise ratio.The key technique in our proposed method is a Greek-ladder sieve array,which acts as not only a wave-front modulator but also a beam splitter.With advantages of the common path,single shot,and no need for a lens,this system has enormous potential in imaging and especially in extreme ultraviolet and soft X-ray holography.     

Generation of 131 fs mode-locked pulses from 2.8μm Er:ZBLAN fiber laser

We demonstrated a femtosecond mode-locked Er:Zr F4-Ba F2-La F3-Al F3-Na F(Er:ZBLAN)fiber laser at 2.8μm based on the nonlinear polarization rotation technique.The laser generated an average output power of 317 m W with a repetition rate of 107 MHz and pulse duration as short as 131 fs.To the best of our knowledge,this is the shortest pulse generated directly from a mid-infrared mode-locked Er:ZBLAN fiber laser to date.Numerical simulation and experimental results confirm that reducing the gain fiber length is an effective way to shorten the mode-locked pulse duration in the Er:ZBLAN fiber laser.The work takes an important step towards sub-100-fs mid-infrared pulse generation from mode-locked Er:ZBLAN fiber lasers.     

介质材料二次电子发射特性对微波击穿的影响

以介质填充的平行板放电结构为例,本文主要研究了介质填充后微波低气压放电和微放电的物理过程.为了探究介质材料特性对微波低气压放电和微放电阈值的影响,本文采用自主研发的二次电子发射特性测量装置,测量了7种常见介质材料的二次电子发射系数和二次电子能谱.依据二次电子发射过程中介质表面正带电的稳定条件,计算了介质材料稳态表面电位与二次电子发射系数以及能谱参数的关系.在放电结构中引入与表面电位相应的等效直流电场后,依据电子扩散模型和微放电中电子谐振条件,分别探讨了介质表面稳态表面电位的大小对微波低气压放电和微放电阈值的影响.结果表明,介质材料的二次电子发射系数以及能谱参数越大,介质材料的稳态表面电位也越大,对应的微波低气压放电和微放电阈值也越大.所得结论对于填充介质的选择有一定的理论指导价值.     

大规模合成具有氧空位的多孔Bi2O3用于有效降解亚甲基蓝

光催化降解有机污染物由于其具有低能耗和绿色环保的特点,已经成为研究的热点. 氧化铋纳米晶体的带隙在2.0∽2.8 eV之间,利用它催化可见光降解有机污染物具有较高的活性,从而引起了越来越多的关注. 尽管近年来已经开发了几种制备Bi₂O₃基半导体材料的方法,但是仍然难以用简单的方法大规模地制备高活性的Bi₂O₃催化剂. 因此,开发简单可行的大规模制备Bi₂O₃纳米晶体的方法对于工业废水处理的潜在应用具有重要意义. 本文通过蚀刻商用BiSn粉末,然后进行热处理,成功地大规模制备了多孔Bi₂O₃. 获得的多孔Bi₂O₃在亚甲基蓝(MB)的光催化降解中表现出优异的活性和稳定性. 对该机理的进一步研究表明,多孔Bi₂O₃合适的能带结构允许生成活性氧物种,例如O₂^-·和·OH,可有效降解MB.     

OCS经由F 31Π里德堡态生成CO(X1Σ+)+S(1D2)产物的波长相关性光解离

本文利用时间切片离子速度成像技术在134∽140 nm波段研究了OCS分子经由F 3¹Π里德堡态的真空紫外光解离动力学. 在选取的5个分别对应OCS(F 3¹Π, v₁=0∽4)的伸缩振动激发的光解波长,实验测得了来自CO(X¹Σ⁺)+S(¹D₂)产物通道的SS(¹D₂))实验影像,并获得了总平动能谱和CO(X¹Σ⁺, v)共生产物的振动布居及角分布. 结果分析表明OCS分子解离生成CO(X¹Σ⁺)+S(¹D₂)产物的过程经历了上态F 3¹Π 与C_?v和C_s构型的下电子态间非绝热耦合过程. 实验结果显示了很强的波长相关性：OCS (F 3¹Π, v₁)的较低转动激发态(v₁=0∽2)和较高转动激发态(v₁=3, 4)的CO(X¹Σ⁺)产物的振动布居和角分布具有显著差异,表明该解离过程中具有不同的解离机理. 本结果提供了振动耦合可能对真空紫外光解离动力学产生关键作用的相关证据.     

第三族金属氧化物离子对二氧化碳转化的红外光谱研究

本文利用红外光解离光谱研究了第三族金属氧化物离子对二氧化碳分子的转化机制. 研究表明,对于[ScO(CO₂)_n]⁺体系,在n≤4时,形成了溶剂化结构;在n=5时,形成了碳酸盐结构,实现了二氧化碳的转化. 对于[YO(CO₂)_n]⁺体系,需要4个二氧化碳分子就可以实现二氧化碳的转化. 而在[YO(CO₂)_n]⁺体系中,只发现了溶剂化结构,没有观察到碳酸盐结构. 理论计算表明,[YO(CO₂)_n]⁺体系拥有最小的溶剂化结构向碳酸盐结构转化能垒,[LaO(CO₂)_n]⁺体系拥有最大的溶剂化结构向碳酸盐结构转化能垒. 本文从分子水平揭示了不同金属氧化物离子对二氧化碳分子转化的影响规律.     

PERTURBATION FINITE ELEMENT METHOD FOR SOLVING GEOMETRICALLY NONLINEAR PROBLEMS OF AXISYMMETRICAL SHELL

In analysing the geometrically nonlinear problem of an axisymmetrical thin-walled shell, the paper combines the perturbation method with the finite element method by introducing the former into the variational equation to obtain a series of linear equations of different orders and then solving the equations with the latter. It is well-known that the finite element method can be used to deal with difficult problems as in the case of structures with complicated shapes or boundary conditions, and the perturbation method can change the nonlinear problems into linear ones. Evidently the combination of the two methods will give an efficient solution to many difficult nonlinear problems and clear away some obstacles resulted from using any of the two methods solely. The paper derives all the formulas concerning an axisym-metric shell of large deformation by means of the perturbation finite element method and gives two numerical examples,the results of which show good convergence characteristics.     

高双折射微结构光纤特性的研究

采用基于单轴各向异性完美匹配层吸收边界的频域有限差分方法研究一种椭圆芯高双折射微结构光纤的特性.通过计算,分析了空气孔尺寸和孔距对模式双折射、泄漏损耗以及模式截止波长的影响;综合研究了双折射微结构光纤的几种特性及其相互之间的影响和制约关系;并首次采用有效面积的方法研究高双折射微结构光纤的模式截止特性,分析单模传输条件;从而为高双折射微结构光纤的设计提供了一定的理论依据.