陈化温度和Fe/Zr配比对SO42-/Fe2O3-ZrO2固体超强酸结构与性能的影响

用低温陈化法制备了SO42 -/Fe2 O3 ZrO2 (简称SFZ)固体超强酸催化剂 ,用红外光谱 (IR)和X光衍射(XRD)对其结构进行了表征 ,并考察了它对合成癸二酸二正丁酯的催化性能 .IR谱显示 ,低温陈化的SFZ样品在10 70cm-1处吸收峰远强于常温陈化样品 .XRD分析则显示 ,在焙烧温度为 6 5 0℃、Fe/Zr为 2∶1时 ,低温陈化的样品出现了亚稳态的ZrO2 四方晶相 .该样品在催化酯化反应中使产率达 90 %以上 ,高于常温陈化样品的 30 % .研究结果表明 :在其他条件不变时 ,低温陈化所出现的亚稳态的ZrO2 四方晶相是表面酸性和催化活性增加的微观原因     

Composites of nanotubular polyaniline containing Fe3O4 nanoparticles

Results of charge-transport and magnetic measurements of nanotubular polyaniline (PANI) composites containing Fe_3O_4 nanoparticles (～10nm) synthesized by a "template-free" method are reported. The T^{-1/2} resistivity has been observed, and dc magnetic susceptibility data are fitted to an equation χ=χ^*_P+C/T. With increasing weight ratio of Fe_3O_4, the electrical conductivity and temperature- independent susceptibility χ^*_P increase, and the Curie-type susceptibility is suppressed at low temperatures. Further discussions have been given. The PANI-H_3PO_4/Fe_3O_4 composite containing 27wt% of Fe_3O_4 nanoparticles is superparamagnetic, exhibiting very little hysteresis even at 5K.     

利用透射电镜衬度像变化判定位错环类型及注氢纯铁中形成的位错环分析

本文分两部分,第一部分研究了利用透射电镜衬度像变化判定材料中位错环类型的方法,即采用所谓inside-outside方法来判断位错环为空位型位错环或间隙型位错环. 第二部分讨论了加速器注氢纯铁在673—773 K时效后形成的位错环的类型. 关键词： 透射电镜 空位型位错环 间隙型位错环 氢     

石墨烯量子点的磁性及激发态性质

利用密度泛函理论在B3LYP/6-31G(d)基组水平上研究了具有zigzag边界的石墨烯量子点,结果表明不同大小的石墨烯量子点的基态都是具有磁性的自旋三重态.其磁性一方面来源于zigzag边界上占有凸出位置的碳原子,另一方面来源于带有孤对电子的碳原子.从整体上看,除6b结构外,其他结构的能隙随着苯环数量的增加逐渐减小,而附加电荷却使体系能隙明显减小.用含时密度泛函理论(TD-DFT)对能隙为3.83 eV的由六个苯环排列成的三角形结构进行了激发态的计算,发现第十七激发态强度最大,能量为3.93 eV,对 关键词： 石墨烯量子点 磁性 能隙 激发态     

基于驻留时间补偿的抛光误差控制方法

 针对计算机控制光学表面成形中光学表面存在中高频误差的问题,提出了一种基于驻留时间补偿的有效控制方法。分析了抛光误差的形成机理和影响因素,对系统的误差影响因素进行分类和定量描述,构建了抛光过程中磨损影响因子、浓度变化影响因子和系统影响因子。基于各影响因素的影响因子对抛光驻留时间的求解函数进行了修正,提出采用离散最小二乘法对修正的函数求解驻留时间。研究表明：这种补偿方法能提高计算机控制光学表面成形技术中加工模型的精度,减小光学表面的残余误差。     

Purification of the recombinant hepatitis B virus core antigen (rHBcAg) produced in the yeast Saccharomyces cerevisiae and comparative observation of its particles by transmission electron microscopy (TEM) and atomic force microscopy (AFM)

Hepatitis B virus core antigen (HBcAg) gene (C gene) was expressed in Saccharomyces cerevisiae and the products (rHBcAg or core particles) were purified from a crude lysate of the yeast by three steps: Sephrose CL-4B chromatography, Sucrose step-gradient ultracentrifugation and CsCl-isopycnic ultracentrifugation. It has been observed that HBcAg was synthesized in yeast cells as a particle consisting of polypeptides with a molecular weight of 21.5 kDa (p21.5). Results of ELISA test and density analysis of CsCl-isopycnic ultracentrifugation indicated that the purified products (rHBcAg particles) with HBcAg antigenicity mainly located at the densities of 1.27 and 1.40 g ml(-1), respectively. Observation and analysis of the purified rHBcAg products by TEM indicated that rHBcAg peptides could mainly self-assemble into two size classes of core particles. The larger particles were approximately 30.1 nm and the smaller were approximately 21.5 nm in mean diameter. Further observation and analysis of the same rHBcAg (core) particles by AFM also indicated that rHBcAg (core) particles were similar to the native HBcAg (core) particles from infected human hepatocytes and mainly composed of two size classes of partides core. The larger particles were approximately 31.3 nm and the smaller were approximately 22.5 nm in mean diameter which was similar to the results obtained by TEM. All results from both TEM and AFM suggested that core particles (capsids) produced in S. cerevisiae possessed dimorphism.     

A Novel UWB Antenna with Small Side-Leakage

A successful design for a UWB (ultra-wideband antennas) antenna based on NRD-guide (nonradiative dielectric waveguide) with small side-leakage is presented. The rule of the theoretical selection of its parameters, if NRD-guide is used as the UWB antennas, is studied firstly, then the temporal propagation characteristics of the NRD-guide and the radiation characteristics for an tapered open-ended NRD-guide are calculated by FDTD (finite-difference time-domain) method.     

新型结构超宽带LiNbO3电光调制器的优化设计

采用有限元软件对新型结构的铌酸锂电光调制器进行了优化设计.分析表明,采用脊波导和T型电极相结合的方式,能在保持高的特征阻抗的同时有效的实现相速匹配和有效降低电极损耗,从而较好的提高器件性能,是一种比较有潜力的调制器.利用优化结果,给出一种带宽达153 GHz,半波电压为8.55 V,特征阻抗为44 Ω的调制器的设计例子.     

激光二极管侧面抽运Nd:YAG锁模激光器的研究

利用谐振腔的稳定条件对激光二极管侧面抽运的Nd：YAG锁模直腔的稳区特性和谐振腔内的光斑分布进行了分析。根据对腔参量的分析，选取合适的腔参量设计了一个简单的侧面抽运直腔，该谐振腔腔形简单，没有像散，振荡光模式好，有利于激光器的锁模运转。实验中采用国内自行研制的半导体可饱和吸收镜，实现了激光二极管侧面抽运半导体可饱和吸收镜锁模Nd：YAG激光器的连续锁模运转，平均输出功率为2W，锁模脉冲宽度为10ps，重复频率为100MHz。结合实验结果进一步讨论了半导体可饱和吸收镜的一些参量如饱和恢复时间、调制深度等对实现稳定连续锁模的影响。     

Preparation of GaN-based cross-sectional TEM specimens by laser lift-off

Laser lift-off (LLO) technology is successfully used to prepare GaN-based TEM cross-sectional specimens. Detailed procedures of the method to prepare the specimens are demonstrated. Large thin areas suitable for TEM analysis were obtained. TEM images of the resulting GaN interface are studied, and the changes in structural quality are confined to approximately the first 250 nm of the epilayer. Clear TEM images of the whole epilayer and the InGaN quantum wells and the HRTEM images of the superlattice layer are demonstrated, showing that LLO is a quick and ideal method to study the crystal structure of the epilayer, especially if only the upper layers are of interest.