Effect of nanocrystalline cellulose on the curing characteristics and aging resistance properties of carbon black reinforced natural rubber

This work focused on the effect of nanocrystalline cellulose (NCC) on the curing characteristics, aging resistance and thermal stability of natural rubber (NR) reinforced with carbon black (CB). Sharing the same fillers loading of 45 parts per hundred rubber (phr), NR/NCC/CB composites with different NCC/CB ratios (i.e. 0/45, 5/40, 10/35, 15/30, 20/25 phr) were prepared and analyzed. Resorcinol and hexamethylene tetramine (RH), acting as the modifier in NR/NCC interface, was also discussed for its influence. The result showed that an relatively higher ratio of NCC/CB led to a lower torque, a shorter cure time (T ₉₀), a slightly longer scorch time (T ₁₀) and a bigger vulcanization rate constant (K). This tendency suggested that the existence of NCC accelerated the vulcanization process. Additionally, modified by RH, NR/NCC/CB compounds exhibited a short T ₁₀ and a elevated torque. And a moderate RH content would lower the E _a of vulcanization. A 10 phr substitute of CB by NCC can help to improve aging resistance in terms of mechanical properties. In a high temperature aging condition, composites with 10 phr NCC also performed the highest storage modulus (G′) among composites tested. A moderate NCC content contributed to the best retention of G′ after high temperature aging, so did the incorporation of RH. With the partial replacement of CB by NCC, the temperature of 5% weight-lose had a slight drop and the apparent crosslink density showed a decrease. Thanks to the interaction of RH with both NR and NCC, composites showed an improvement in apparent crosslink density after modified by RH.     

Bistable stochastic biochemical networks: highly specific systems with few chemicals

In this paper we describe a class of stochastic biochemical systems exhibiting bistable behavior, in the sense that the invariant measure associated to the system is concentrated near two different classes of states of the system. We develop methods that allow us to describe the behavior of the invariant measure in some suitable asymptotic limits, as well as the switching times for the transitions between the states close to each of the states with high probability. Due to the discrete character of the problem, switching times cannot be computed using the classical Kramers’ formula, and alternative methods are required.     

新型磺酸盐型Gemini表面活性剂的合成及其与聚合物相互作用

以溴代正烷烃、乙二胺、1,3-丙磺内酯合成了一系列新型磺酸盐型Gemini表面活性剂(SGS-8、SGS-10、SGS-12、SGS-14);采用IR、1H NMR及元素分析等手段对合成产物进行结构表征,并研究了其表面活性,采用等温滴定微量热技术、表面张力法和稳态荧光光谱法研究了SGS-12与聚丙烯酰胺(PAM)的相互作用规律及热力学参数。结果表明,合成的产物纯度较高,具有较低的cmc值和较好的表面活性;SGS-12/PAM混合体系的表面张力曲线和芘探针在体系中微极性的变化表明,二者发生相互作用且形成混合胶束;SGS-12与PAM结合是一个由焓驱动的自发过程,△H和△S均小于0,表明相互作用力以氢键和范德华力为主,合成产物在聚丙烯酰胺分子上的平均结合数为287。     

Short time deposition of TiO2 nanoparticles on SiC as photocatalysts for the degradation of organic dyes

The deposition of TiO₂ nanoparticles on SiC was carried out by mechanical milling under different conditions. SiC–TiO₂ samples were used as photocatalysts for the degradation of organic dyes such as methylene blue and rhodamine B. A short time deposition of TiO₂ nanoparticles was observed during mechanical milling (2 min at 200 rpm) to cover the SiC particles. The presence of SiC and TiO₂ (anatase and rutile) was confirmed by means of X-ray diffraction after thermal treatment at 450 °C. The deposition of TiO₂ on SiC was corroborated by scanning electron microscopy analysis; the thickness of the thin layer of TiO₂ deposited on SiC increases as the proportion of TiO₂ increases. The energy band gap values obtained for these compounds were around 3.0 eV. SiC–TiO₂ photocatalysts prepared by mechanical milling exhibited better activity under UV-light irradiation for the degradation of methylene blue and rhodamine B than commercial TiO₂ powder (titania P25).     

Synthesis of β-cyclodextrin-calix[4]arene coupling product and its adsorption of basic fuchsin and methylene blue from water

Two new β-CD-calix[4]arene coupling products 3,4 which contained one or two β-CD units in molecules were synthesized by ammonolysis of p-tert-butyl-25,27-dihydroxyl-26,28-di (ethoxy carbonyl methoxyl) calix[4]arene 1 and mono-6-ethylenediamino-6-deoxy-β-CD 2, and their structures were confirmed by ¹H NMR, IR and MS (Maldi-Tof). The probable mechanism for forming 3 was discussed also. Using water-insoluble coupling product 3 as an adsorbent, the influences of the adsorption capacities of 3 including initial concentration, temperature and pH onto basic fuchsin (BF) and methylene blue (MB) from aqueous solution were investigated. Results showed that the adsorption capability of 3 to BF was obviously higher than that to MB at similar adsorption conditions. The values of %sorption to BF were over 90 % in range of initial concentrations from 20 to 140 mg L^?1 whenas those to MB dropped rapidly from 92 to 58 %. The adsorptions of 3 to both BF and MB obeyed Freundlich adsorption isotherm well.     

Production from ilmenite of TiO2-supported catalysts for selective catalytic reduction of NO with NH3

Economic production of titanium dioxide (yield >98 %) from ilmenite has been achieved by use of a modified sulfate reduction process. A series of samples were prepared by varying the concentration of titanium dioxide nuclei (0.2, 0.3, and 0.6 %) and further impregnation with antimony and vanadia. The structural and acidic properties of the samples were comprehensively studied by X-ray diffraction (XRD), transmission electron microscopy, BJH pore size distribution, and temperature-programmed desorption of NH₃. The XRD results revealed the presence of intense peaks from anatase titanium dioxide. Enhancement of surface area was observed for second-time filtered samples, possibly because of loss of iron from the bulk. As a result, formation of additional micropores was apparent from N₂ adsorption and desorption isotherms. Among all the antimony and vanadia-doped samples, the first-time filtered sample with the low concentration of nuclei (0.2 %) had the highest catalytic activity at low temperatures, owing to its larger pore size and abundant acidic species.     

Dynamic output feedback consensus of continuous‐time networked multiagent systems

This article addresses the dynamic output feedback consensus problem of continuous‐time networked multiagent systems. Both a fixed topology and Markovian switching topologies are considered. The consensus algorithms are on the base of the output information of each agent's itself and its neighbors. Some sufficient conditions for consensus of multiagent systems are obtained in forms of bilinear matrix inequalities. The algorithm based on the homotopy continuation method is given to compute the feasible controller gains. Numerical simulations are given to show the effectiveness of the proposed results. © 2014 Wiley Periodicals, Inc. Complexity 20: 35–42, 2015     

Preparation of 2,2-difluoro-1-trialkylsilylethenylstannanes and their cross-coupling reactions

Reaction of 2 with bis(tributyltin) in the presence of 3 mol % Pd₂(dba)₃, 6 mol % XPhos, and 30 equiv of LiBr in wet and air bubbled THF at reflux for 8 h afforded the desired products 3 in 73–74% yields. The cross-coupling reaction of 3a with aryl iodides in the presence of 10 mol % Pd(PPh₃)₄ and 10 mol % CuI afforded the coupled products 4a–p in 47–90% yields. The coupling reaction of 3b with various alkynyl bromides having aryl-, alkyl, or trialkylsilyl group also afforded the corresponding 1,3-enynes 5a–g in 61–77% yields.     

Simultaneous determination of nine lignans from Schisandra chinensis extract using ultra‐performance liquid chromatography with tandem mass spectrometry in rat plasma,urine, and gastrointestinal tract samples: Application to the pharmacokinetic study of Schisandra chinensis

The fruit of Schisandra chinensis is a well‐known herbal medicine and dietary supplement due to a variety of biological activities including antihepatotoxic and antihyperlipidemic activities. However, the simultaneous validation methodology and pharmacokinetic investigation of nine lignans of S. chinensis extract in biological samples have not been proved yet. Thus, the present study was undertaken to develop the proper sample preparation method and simultaneous analytical method of schisandrol A, gomisin J, schisandrol B, tigloylgomisin H, angeloylgomisin H, schisandrin A, schisandrin B, gomisin N, and schisandrin C in the hexane‐soluble extract of S. chinensis to apply for the pharmacokinetic study in rats. All intra‐ and interprecisions of nine lignans were below 13.7% and accuracies were 85.1–115% and it is enough to evaluate the pharmacokinetic parameters after both intravenous and oral administration of hexane‐soluble extract of S. chinensis to rats.     

Cyclized oligomer of tetracyanoquinodimethane-tetrathiafulvalene (TCNQ-TTF): a versatile macrocyclic molecule by DFT calculations

Journal of Inclusion Phenomena and Macrocyclic Chemistry - The combination of the electron donor and acceptor into a donor–acceptor system can transform the intermolecular charge transfer...