金刚石窗口冷却Yb3+∶YAG DPSSL设计

针对高功率二极管重复率抽运的V型非稳腔Yb3+∶YAG激光头，提出了利用金刚石窗口冷却和直接水冷相结合的复合冷却设计.在YAG片的抽运面进行直接水冷，同时在激光提取面利用金刚石窗口冷却介质.金刚石优异的导热性能不仅能够有效地冷却激光介质，还能消除横向的温度梯度，解决了高功率激光器冷却和高功率抽运的矛盾.模拟结果表明对掺杂10 at %厚度为1.6 mm的Yb3+∶YAG片在抽运功率密度为20 kW/cm2，重复频率为10 Hz的条件下，要将最高温度控制在可接受的范围内（比如320 K），周围冷却水的对流换热系数约为4000 W/m2K.     

扫描隧道显微镜研究石墨表面的莫尔图

利用扫描隧道显微镜研究石墨表面的大尺度周期性图样．研究结果表明,莫尔图起源于石墨深层的缺陷,实验结果与理论完全吻合,并且第一次在实验上证明了纳米波可以穿透多层石墨而没有明显衰减．     

Construction of the refractive index profiles for few-mode planar optical waveguides

We present a nondestructive technique to predict the refractive index profiles of isotropic planar waveguides, on which a thin gold film is deposited to as the cladding. The negative dielectric constant of the metal results in significant differences of effective indices between TE and TM modes. The two polarized modes and a surface plasmon resonance (SPR) with abundant information of the surface index can be used to construct the refractive index profiles of single-mode and two-mode waveguides at a fixed wavelength.     

SiO2脊形条波导热极化引起的电光效应

通过理论模拟对具有上覆盖层的SiO2脊形条波导结构进行了优化,在此基础上利用微电子工艺制作了SiO2脊形波导Mach-Zehnder 型电光调制器,并进行热极化引起的电光和非线性效应的研究.热极化过程大幅增强了样品的电光及非线性效应,二次电光系数由热极化前的1.56×10-22(m/V)2提高到热极化后的8.50×10-22(m/V)2,极化后得到了0.093pm/V的线性电光系数,对热极化的物理机理进行了理论分析.     

Distributed optical fiber surface plasmon resonance sensors

The relationships of the resonant wavelength of optical fiber surface plasmon resonance (SPR) sensors to the modulation layer refractive index, thickness and the refractive index of the bulk medium are obtained by using theoretical calculation model of optical fiber SPR sensors under certain conditions, which indicates that resonant wavelength of the sensors is approximately linear with modulation layer thickness. Based on the linear relationship, multiple SPR sensors with different resonant wavelengths can be fabricated in a single optical fiber named as distributed optical fiber surface plasmon resonance sensors (DOFSPRSs).Experimental results are presented, showing that it is practical to fabricate more than one SPR sensors in a single optical fiber.     

灰气体加权和辐射模型综合评估及分析

在O_2/CO_2气氛下,参与性介质的非灰气体辐射特性表现出不同于空气气氛下的特性,因此,非灰气体辐射模型的选择和应用在换热过程中将变得十分重要.基于统计窄谱带模型,本文综合评估近年发展应用较广的灰气体加权和(WSGG)模型.结果表明,几种WSGG模型的预测值总体趋势正确,但仍存在着一定的差别.对于发射率,Dorigon等(2013 Int.J.Heat Mass Transfer 64 863)和Bordbar等(2014 Combust.Flame 161 2435)的WSGG模型与基准模型符合较好,相对误差小于20%.与离散坐标法结合,本文求解了PH_2O/PCO_2=1,2时的一维平行平板间辐射换热问题.结果显示,由Dorigon等和Bordbar等的WSGG模型得到的辐射热源和热流密度分布的相对误差均较小(10%左右).Johansson等(2011 Combust.Flame 158893)和Bordbar等的WSGG模型具有更广的适用范围.     

Effect of bromine substituent on optical properties of aryl compounds

Substituents significantly affect optical properties of organic compounds. In this study, a series of organic compounds were synthesized. Ultraviolet‐visible and cyclic voltammetry spectra were determined. The relationships between the number of π electron in an aryl ring and the redshift (and molecular orbital energy levels) were studied. To investigate mechanisms of the bromine substituent effects, theoretical calculations were carried out. Ultraviolet‐visible spectra of bromine‐containing compounds exhibit obvious redshifts (0.04‐0.17 eV) of the maximal absorption wavelengths and enhanced absorbance (11%‐57%) compared with corresponding reference compounds. The lowest unoccupied and highest occupied molecular orbital energy levels of compounds containing bromine substituents are 0.05 to 0.60 and 0.02 to 0.40 eV lower than that of corresponding reference compounds. On the whole, the redshifts and the reduced molecular orbital energy levels caused by bromine substituent decrease with the increase in the number of π electron in an aryl ring. The effects would be attributed to strong p‐π conjugation between p electron in the bromine substituent and π electrons in aryl rings. Therefore, this paper suggests a useful way for tuning optical absorption and molecular orbital energy levels of aryl compounds.     

A three‐crystal spectrometer for high‐energy resolution fluorescence‐detected X‐ray absorption spectroscopy and X‐ray emission spectroscopy at SSRF

A Johann‐type spectrometer for the study of high‐energy resolution fluorescence‐detected X‐ray absorption spectroscopy, X‐ray emission spectroscopy and resonant inelastic X‐ray scattering has been developed at BL14W1 X‐ray absorption fine structure spectroscopy beamline of Shanghai Synchrotron Radiation Facility. The spectrometer consists of three crystal analyzers mounted on a vertical motion stage. The instrument is scanned vertically and covers the Bragg angle range of 71.5–88°. The energy resolution of the spectrometer ranges from sub‐eV to a few eV. The spectrometer has a solid angle of about 1.87 × 0^?3 of 4π sr, and the overall photons acquired by the detector could be 10⁵ counts per second for the standard sample. The performances of the spectrometer are illustrated by the three experiments that are difficult to perform with the conventional absorption or emission spectroscopy. Copyright © 2016 John Wiley & Sons, Ltd.     

Synthesis of hierarchical Na<Subscript>2</Subscript>FeP<Subscript>2</Subscript>O<Subscript>7</Subscript> spheres with high electrochemical performance via spray drying

Hierarchical Na₂FeP₂O₇ spheres with nanoparticles were successfully fabricated by a facile spray drying method. A relatively low drying temperature was introduced in order to form a carbon layer on the surface. As a cathode material for sodium-ion batteries, it delivered a reversible capacity of 84.4 mAh g^?1 at 0.1 C and showed excellent cycling and rate performance (64.7 mAh g^?1 at 5 C). Furthermore, a full sodium battery was fabricated using SP-Na₂FeP₂O₇ as the cathode and hard carbon as the anode, suffering almost no capacity loss after 400 cycles at 1 C. Due to its superior electrochemical property and the low materials cost, Na₂FeP₂O₇ is becoming a promising cathode material for large-scale energy storage systems.