343 nm飞秒激光制备微孔阵列以增强聚氨酯合成革透湿性

为了提高聚氨酯(PU)合成革透湿性,分别使用343 nm飞秒激光和作为对比的1030 nm飞秒激光及1064 nm纳秒激光制备微孔阵列。采用扫描电镜(SEM)和3D激光扫描显微镜对比研究了微孔形貌。结果表明,343 nm飞秒激光可以制备出效果最佳的微孔。此外,分析了3种激光与PU涂层的作用机理,揭示了343 nm飞秒激光合成革微钻孔过程仅表现为光化学烧蚀,光化学和光热烧蚀同时发生于1030 nm飞秒激光钻孔过程,而1064 nm纳秒激光只显示了光热烧蚀。激光合成革表面钻孔后,测量其透湿性和抗张力。结果显示: 微孔密度越大,皮革透湿性(WVP)越大而抗张力越低,脉冲重叠的增加会导致WVP的增加和抗张力的下降;同时,随着脉冲重叠从91.7%降到50%,微孔直径从45 μm降低到30 μm,而微孔锥度从0.7°增加到12.1°;当脉冲重叠率为91.7%,微孔密度为2550/cm²时,最大的WVP增长率为306%。     

对称平板传输线分布电容的计算

介绍了共形映射法及其在静电场中的应用.求出了对称平板传输线的分布电容.     

电力机车用高温超导变压器电流引线导热路径延伸方法的研究

按照车用高温超导变压器对电流引线的要求,以有限元体传热学为分析基础,对电流引线进行了传热计算,给出了初步设计方案。针对车载变压器的有限空间,提出了通过将引线绕制成螺线管状的方法来解决引线的导热路径长度较长与空间可用高度不够的矛盾,并通过热损耗分析得出下端绕制方式优于上端绕制方式的结论。     

Design of Enhanced Catalysts by Coupling of Noble Metals (Au,Ag) with Semiconductor SnO2 for Catalytic Reduction of 4‐Nitrophenol

The reduction of 4‐nitrophenol (Nip) into 4‐aminophenol (Amp) by NaBH₄, which is catalyzed by both binary and ternary yolk–shell noble‐metal/SnO₂ heterostructures, is reported. The binary heterostructures contain individual Au or Ag nanoparticles (NPs) and the ternary heterostructures contain both Au and Ag NPs. The Au@SnO₂ yolk–shell NPs are synthesized via a silica seeds‐mediated hydrothermal method. Subsequently, the Au@SnO₂@Ag and Au@SnO₂@Au yolk–shell–shell (YSS) NPs are synthesized, whereby SnO₂ is located between the Au and Ag NPs. The morphology, composition, and optical properties of the as‐prepared samples are analyzed. For the binary heterostructures, the rate of the reduction reaction increases with decreasing particle size. The catalytic results demonstrate the synergistic effect of Au and Ag in the ternary metal–semiconductor heterostructures, which is beneficial to the catalytic reduction of Nip into Amp. Both the binary and ternary heterostructures exhibit significantly better catalytic performances than the corresponding bare Au and Ag NPs. It is envisaged that the current synthesized strategy will promote further interest in the field of bimetal NP‐based catalysis.     

Influence of aramid fiber moisture regain during atmospheric plasma treatment on aging of treatment effects on surface wettability and bonding strength to epoxy

One of the main differences between a low-pressure plasma treatment and an atmospheric pressure plasma treatment is that in atmosphere, the substrate material may absorb significant amount of water which may potentially influence the plasma treatment effects. This paper investigates how the moisture absorbed by aramid fibers during the atmospheric pressure plasma treatment influences the aging behavior of the modified surfaces. Kevlar 49 fibers with different moisture regains (MR) (0.5, 3.5 and 5.5%, respectively) are treated with atmospheric pressure plasma jet (APPJ) with helium as the carrier gas and oxygen as the treatment gas. Surface wettability and chemical compositions, and interfacial shear strengths (IFSS) to epoxy for the aramid fibers in all groups are determined using water contact angle measurements, X-ray photoelectron spectroscopy (XPS), and micro-bond pull out tests, respectively. Immediately after the plasma treatment, the treated fibers have substantially lower water contact angles, higher surface oxygen and nitrogen contents, and larger IFSS to epoxy than those of the control group. At the end of 30 day aging period, the fibers treated with 5.5% moisture regain had a lower water contact angle and more polar groups on the fiber surface, leading to 75% improvement of IFSS over the control fibers, while those for the 0.5 and 3.5% moisture regain groups were only 30%.     

相变域硅薄膜材料的光稳定性

采用RF-PECVD技术，通过改变反应气体的硅烷浓度制备了一系列不同晶化率不掺杂的硅薄膜材料，研究了工艺变化对材料结构的影响及材料光电特性同微结构的关系.随后进行了光衰退试验，在分析光照前后光电特性变化规律的基础上，认为材料中的非晶成分是导致材料光电特性衰退的主要原因.在靠近过渡区非晶一侧的硅材料比普通非晶硅稳定，衰退率较少；高晶化率微晶硅材料性能稳定，基本不存在光衰退；在靠近过渡区微晶一侧的硅材料虽然不是完全不衰退，但相比高晶化率硅材料来说更适合制备高效微晶硅电池. 关键词： 射频等离子体增强化学气相沉积 硅薄膜 Staebler-Wronski(SW)效应 稳定性     

Second-harmonic generation in thermally poled chalcohalide glass

Second-harmonic generation in 60GeS(2)-20Ga(2)S(3)-20KBr chalcohalide glass was investigated by the thermal poling method. A large second-order nonlinear susceptibility, as high as 7.0 pm/V, was obtained in a poled sample by Maker fringe analysis. We believe this to be the first time that a clear second-harmonic wave was observed in chalcohalide glasses containing large amount of alkali ions (6.25 at. %). Such observation is of great potential use in all optical waveguide devices.     

微通道中气体流动的格子Boltzmann数值模拟

采用可压缩格子Boltzmann模型及非平衡外推边界条件,数值模拟微通道中的气体在滑移区域(Kn≤0.1)内的流动,计算结果包括出口速度剖面、通道中心压力分布以及质量流率等,与理论结果及其他实验结果符合得很好.还模拟了180°弯曲通道中的气体流动.结果表明,滑移速度的存在抑制了边界层的分离,因此在弯曲处不存在漩涡.计算结果还表明,弯道的存在显著影响了气体的质量流率.