Power scaling of blue and red light based on frequency mixing inside adhesive-free bond composite Nd:YAG laser cavity

We report our results on effective third-harmonic generation (THG) by cascading quasi-phase-matched second-harmonic and sum-frequency generation in a dual-period-periodically-poled KTP crystal. Significant improvement of the output powers were achieved for the 440 nm blue light and 660 nm red light based on Q-switched frequency-tripling and frequency-doubling 1319-nm radiation inside an adhesive-free bond composite Nd:YAG laser. The highest output powers of 197 mW and 1.19 W were achieved for the blue and red light at the corresponding input powers of 12.9 and 17.1 W for the diode laser.     

Coherent Beam Combination of Eight Watt-Level Polarization-Maintained Fiber Amplifiers

We demonstrate the coherent beam combination of eight Watt-level polarization-maintained fiber amplifiers. The phase control signal of each amplifier is generated by running a stochastic parallel gradient descent algorithm on a digital signal processor （DSP）. The experimental result shows that the whole system in close-loop performs well for long-time observation. Energy encircled in the target pinhole is 6.68 times more than that in open-loop. The combination efficiency is as high as 84.5%.     

Addition reaction and characterization of chlorotris(triphenylphosphine)iridium(I) on silicon(1 1 1) surfaces

Studies were performed to determine the chemical addition of a metal complex molecule, chlorotris(triphenylphosphine)iridium(I), on hydrogen passivated Si(1 1 1) surfaces to form a self-assembled monolayer (SAM). The iridium complex was synthesized prior to chemical addition, for which modified reaction conditions were chosen. Following addition, the silicon surfaces were characterized with X-ray photoelectron spectroscopy (XPS) and cyclic voltammetry (CV). The XPS results revealed that the surfaces consisted of the expected elemental percentages and that the iridium has a slightly higher success rate at attaching to oxide-free surfaces. XPS data also strongly indicate that the iridium complex remained intact upon chemisorption and did not decompose during the addition reaction. CV data show a difference between iridium treated surfaces and control samples. Hydrogen passivated wafers with iridium complex were much more conductive than those which were terminated with just an oxide or with an oxide and iridium complex. Furthermore, no free iridium reagent was detected as an additional feature in the current profile, indicating there was no physisorbed layer.     

Formation and tribological properties of two‐component ultrathin ionic liquid films on Si

Several single‐component and two‐component imidazolium ionic liquids (ILs) ultrathin films were formed on Si substrates by a dip‐coating and heat treatment process. The formation and surface properties of the films were analyzed by means of ellipsometric thickness measurement, X‐ray photoelectron spectra and atomic force microscope. The adhesive and nanotribological behaviors of the films were evaluated by a homemade colloidal probe. A ball‐on‐plate tribometer was used to test the microtribological performances of these films. As a result, the two‐component ILs ultrathin film containing 80% solid‐like ILs phase shows more homogenous surface morphologies and optimal micro/nano‐tribological properties as compared to single‐component ILs films, which is ascribed to a synergic effect between the steady solid‐like ILs phase as the backbone and the proper amount of flowable liquid‐like ILs phase. By studying the influence of various solid/liquid ILs ratios on tribological properties of the two‐component ILs films, we might find the way to design ILs films with excellent comprehensive tribological properties. Copyright © 2010 John Wiley & Sons, Ltd.     

Metal-free synthesis of (E)-vinyl sulfones via denitrative coupling reactions of β-nitrostyrenes with sodium sulfinates

Abstract

A practical metal-free procedure for the synthesis of (E)-vinyl sulfones has been developed through the coupling of β-nitrostyrenes with sodium sulfinates under microwave irradiation. This methodology provides a convenient and efficient approach to various (E)-vinyl sulfones from readily available starting materials with excellent regioselectivity. The present oxidative reaction involves an efficient denitrative radical cross-coupling of β-nitrostyrenes with sodium sulfinates via using AcOH as an additive.     

Direct electrochemistry of hemoglobin on graphene/Fe3O4 nanocomposite-modified glass carbon electrode and its sensitive detection for hydrogen peroxide

Graphene/Fe₃O₄ nanocomposite was prepared for the immobilization of hemoglobin (Hb) to improve the electron transfer between Hb and glass carbon electrode (GCE). The characterization of nanocomposites was described by transmission electron microscopy, Fourier transform infrared, Raman spectroscopy, and X-ray photoelectron spectroscopy, respectively. The electrochemistry of Hb on the graphene/Fe₃O₄-based GCE was investigated by cyclic voltammetry and amperometric measurement. The modified electrode showed a wide linear range from 0.25 μmol/L to 1.7 mmol/L with a correlation coefficient of 0.9967. The detection limit of the H₂O₂ biosensor was estimated at 6.0?×?10^?6?mol/L at a signal-to-noise ratio of 3.     

Relation between morphology and conductivity in TiO2 nanotube arrays: an electrochemical impedance spectrometric investigation

Two types of TiO₂ nanotubular arrays were obtained by anodisation of a titanium foil, in two different solutions containing fluoride ions. For the first type which has rough tube walls, impedance measurements in the dark showed the presence of a localised surface state which was related to adsorbed molecular water. Under UV illumination, this adsorbed molecular water was photo-dissociated. Moreover, an increase of 2 orders of magnitude for the limiting capacitance of the space charge layer was observed, simultaneously with the disappearance of the localised state and with a 100-time increase of the carrier density associated with hydrogen insertion. The second type of layer was characterised by smoother tube walls, a high doping level (10²⁰?cm^?3) in the dark, a lack of localised states and no long-lasting photo-induced effect. In this case, the width of the space charge layer became rapidly higher than the half-thickness of the tube walls, when the applied potential increased. Therefore, the walls were progressively depleted under anodic polarisation, passing from a situation where the tubes were totally active in the cathodic range towards a situation where the contribution of the tube walls could be neglected.     

Supramolecular organogelators based on Janus type AT nucleosides

J-AT nucleoside-based organogelators 1a and 1b were designed and synthesized. They were endowed with unparalleled superiority to natural nucleobase analogues 2–6 to gelate aromatic solvents due to their excellent self-assembly properties. The J-AT nucleoside-based organogelators showed a specific self-complementary base pair recognition characteristic. The gel stabilities of 1a and 1b were drastically influenced by adenine analogue 2, hardly affected by thymine analogue 3, uracil analogue 4, cytosine analogue 5, and mildly interrupted by guanine analogue 6.     

Plutonium-239 sorption and transport on/in unsaturated sediments: comparison of batch and column experiments for determining sorption coefficients

Sorption (distribution) coefficients of plutonium were most often derived by static batch experiments. However, it is not clear how unsaturated flow conditions including moisture content and pore water velocity change the sorption coefficients. Transport experiments of plutonium through the unsaturated sediments packed into the columns were then performed in order to determine the sorption coefficients (column-K _ds). Static batch experiments were also conducted to obtain batch-K _ds and then compare the differences between batch-K _ds and column-K _ds. The results show that unsaturated flow conditions had no significant effect on column-K _ds, and the average column-K _d value was 1.74 ± 0.02 m³/kg. By comparison, batch-K _d values spanned several orders of magnitude, regardless of the specified liquid–solid conditions. Moreover, the batch-K _d (22.7 m³/kg) at the standard L/S (4 mL/g) recommended by ASTM D 4319 was over an order of magnitude larger than the average column-K _d.     

Highly Stereoselective Conjugate Addition and α‐Alkynylation Reaction with Electron‐Deficient Alkynes Catalyzed by Chiral Scandium(III) Complexes

The highly Z‐selective asymmetric conjugate addition of 3‐substituted oxindoles to alkynyl carbonyl compounds has been developed by using scandium complexes of chiral N,N′‐dioxides under mild conditions. The thermodynamically unstable Z‐olefin derivatives were obtained in excellent yields and high enantiomeric and geometric control. The catalyst was also found to be effective in the asymmetric acetylenic substitution reaction of 3‐substituted oxindoles, giving excellent enantioselectivities.