Continuous flow hydroformylation of alkenes in supercritical fluid-ionic liquid biphasic systems

A process for the hydroformylation of relatively low volatility alkenes (demonstrated for 1-dodecene) in a continuous flow system is described. The catalyst is dissolved in an ionic liquid while the substrate and gaseous reagents are transported into the reactor dissolved in supercritical CO(2), which simultaneously acts as a transport vector for aldehyde products. Decompression of the fluid mixture downstream yields products which are free of both reaction solvent and catalyst. The use of rhodium complexes of triaryl phosphites leads to ligand degradation through reaction of the ionic liquid with water and subsequent attack of the released HF on the phosphite. Sodium salts of sulfonated phosphines are insufficiently soluble in the ionic liquids to obtain acceptable rates, but replacing the sodium by a cation similar to that derived from the ionic liquid, allows good solubility and activity to be obtained. The nature of the ionic liquid is very important in achieving high rates, with 1-alkyl-3-methylimidazolium bis(trifluoromethanesulfonyl)amides giving the best activity if the alkyl chain is at least C(8). Catalyst turnover frequencies as high as 500 h(-1) have been observed, with the better rates at higher substrate flow rates. Rhodium leaching into the product stream can be as low as 0.012 ppm, except at low partial pressures of CO/H(2), when it is significantly higher. Oxygen impurities in the CO(2) feed can lead to oxidation of the phosphine giving higher rates, lower selectivities to the linear aldehyde, increased alkene isomerization and greater leaching of rhodium. However, it is found that under certain process conditions, the supercritical fluid-ionic liquid (SCF-IL) system can be operated continuously for several weeks without any visible sign of catalyst degradation. Comparisons with commercial hydroformylation processes are provided.     

磁化作用对汽油动态挥发性影响的研究

用热重（TG）分析和自行设计的原位动态挥发实验，研究了在不同条件下汽油的挥发性，结果表明，磁化空气或磁化汽油都可提高汽油的挥发性，而汽油和空气共同磁化，可更大幅度地提高汽油的挥发性。     

超临界NaCl水溶液的分子动力学模拟

采用分子动力学模拟的方法对超临界NaCl水溶液的微观结构进行了研究.模拟发现在所研究超临界条件下,密度的变化比温度的变化对超临界NaCl水溶液的微观结构影响更大.温度及密度对Cl－ H2O径向分布函数的影响比对Na＋ H2O径向分布函数的影响要大.超临界条件下,各gNa＋－Cl－在0.261 nm处出现峰值,表明Na＋、Cl－之间发生了离子的缔合.超临界条件下,随温度增加,缔合作用增强；随密度增加,缔合作用减弱.本文工作为建立可适用于超临界条件下的电解质热力学模型提供了依据.     

微波作用下2,5-二取代-1,3,4-噁二唑的合成

2 ,5 二取代 1 ,3 ,4 二唑可用作药品 ,光敏物质 ,闪烁体 ,激光材料 ,高分子液晶单体等[1- 5] 。一种是以芳香酸与水合肼作为原料用多聚磷酸作为脱水环合剂来合成此类化合物[6 ] ,另一种是由芳香酸转变为芳香酰氯或酯 ,再与水合肼反应得到单酰肼或二酰肼 ,最后用三氯氧磷[7] ,五氧化二磷和五氯化磷[8] ,一氯三甲硅[9] 脱水环合 ;此外 ,用水合肼和尿素合成得到的氨基脲代替水合肼 ,与芳香酸缩合合成二唑[10 ] ,这些方法共同的缺陷是 :环合时间较长 ,少者 4～ 5ｈ ,多则 8ｈ。近年来 ,微波技术在有机合成及其杂环化合物的合成中得到了广…     

Immunoaffinity isolation of CEACAM1 on hydrazide-derivatized cellulose with immobilized monoclonal anti-CEA antibody

Carcinoembryonic cell adhesion molecule 1 (CEACAM1) is a human membrane glycoprotein belonging to the carcinoembryonic antigen (CEA) family and to the immunoglobulin superfamily. It is expressed in apical membranes of many epithelial cells in gastrointestinal and urogenital tract and also in granulocytes and lymphocytes, and its biological effect in human tissues has recently been discussed in literature. The purpose of this study was to isolate CEACAM1 glycoprotein from bile and characterize its purity and recovery which has not been described before. Affinity chromatography of CEACAM1 on hydrazide-activated cellulose with immobilized monoclonal anti-CEA F34-187 antibody is described. The immunoglobulin carbohydrate moiety was oxidized by periodate and then bound to hydrazide-activated matrix. Crude protein fraction from bile was applied on the affinity column and after extensive washing of non-bound proteins CEACAM1 was eluted with 6 M guanidine-HCl. A single immunopositive 85 kDa band was detected on Western blots with anti-CEA antibody after SDS-PAGE. We found out that CEACAM1 was not stainable with any common method of protein staining and the only non-specific method which could detect the 85 kDa band was a lectin staining.     

Microcalorimetric studies on the non-competitive inhibition of bovine liver arginase

Two methods, e.g. initial rate method and thermokinetic reduced extent method were presented for studies on non-competitive inhibition. Arginase-catalyzed the hydrolysis of L-arginine toL-ornithine and urea and the inhibition of this reaction by sodium fluoride were studied in the absence and presence of exogenous of Mn²⁺at 37°C in 40 mM sodium barbiturate-hydrochloric acid buffer solution (pH 7.4). Both methods were successively used to determine the values of K₁. The advances and disadvantages of each method were compared in this paper. Exogenous Mn²⁺ could result in more sensitivity of arginase to F^-1. Since the inhibition of arginase by F^-1 depends on the pH values of the reaction system and behave as a non-competitive inhibition, it probably due to its small volume and high electronic density allow it access to the activity site of the enzyme and replaces of μ-OH₂ (or μ-OH) as the bridge ligand with Mn(II, II) cluster. However, further studies are necessary to determine the modes of interaction of F^-1 with bovine liver arginase. This revised version was published online in August 2006 with corrections to the Cover Date.     

Cadinene Derivatives from Eupatorium adenophorum

A new norsesquiterpene named eupatorone (= (4S,4aR,6R)‐1‐acetyl‐6‐(acetyloxy)‐4,4a,5,6‐tetrahydro‐4,7‐dimethylnaphthalen‐2(3H)‐one; 1 ) and a new sesquiterpene derivative named 2‐deoxo‐2‐(acetyloxy)‐9‐oxoageraphorone (= (1R,4S,4aR,6R,8aS)‐6‐(acetyloxy)‐3,4,4a,5,6,8a‐hexahydro‐4,7‐dimethyl‐1‐(1‐methylethyl)naphthalen‐2(1H)‐one; 2 ), together with the five known cadinene derivatives 3 – 7 were isolated from the flower of Eupatorium adenophorum (Spreng. ). Their structures were established by extensive NMR experiments, including 1D and 2D NMR.     

Thermodynamic properties of lattice hard-sphere models

Thermodynamic properties of several lattice hard-sphere models were obtained from grand canonical histogram- reweighting Monte Carlo simulations. Sphere centers occupy positions on a simple cubic lattice of unit spacing and exclude neighboring sites up to a distance sigma. The nearestneighbor exclusion model, sigma = radical2, was previously found to have a second-order transition. Models with integer values of sigma = 1 or 2 do not have any transitions. Models with sigma = radical3 and sigma = 3 have weak first-order fluid-solid transitions while those with sigma = 2 radical2, 2 radical3, and 3 radical2 have strong fluid-solid transitions. Pressure, chemical potential, and density are reported for all models and compared to the results for the continuum, theoretical predictions, and prior simulations when available.     

Film stripping voltammetry

Film stripping voltammetry is a new electrochemical analytical method consisting in concentrating the test substance in the form of a metal or a sparingly soluble compound on the electrode surface and subsequently recording the current for electrodissolution of the deposit. The method has been worked out for determination of metal ions, anions and variable valence ions, with sensitivities as low as 10(-9)M. As indicator electrodes, solid, usually graphite, electrodes and stationary mercury electrodes are used.     

Synthesis and Characterization of Novel Polyimides Based on Pyridine-containing Diamine

A new aromatic diamine monomer containing pyridine unit, 2,6-bis （4-aminophenoxy- 4＇-benzoyl）pyridine（BABP）, was synthesized in three steps, starting from 2,6-pyridinedicarboxyl chloride. A series of novel pyridine-containing polyimides were prepared v/a the polycondensation of BABP with various aromatic dianhydrides through poly（amic acid） precursors, and thermal or chemical imidization of the precursors. The polyimides exhibit desirable properties, e.g., good solubility in N-methyl-2-pyrrolidone and m-cresol, excellent thermal stability and film-forming capability, as well as high inherent viscosity, indicating high molecular weight.