Electrical properties of neodymium doped CaBi4Ti4O15 ceramics

Neodymium doped bismuth layer structure ferroelectrics (BLSFs) ceramics CaBi_4−xNd_xTi₄O₁₅ (x=0, 0.25, 0.50, 0.75) were prepared by solid-state reaction method. X-ray diffraction pattern showed that single phase was formed when x=0-0.75. The refined lattice parameters showed that a (b) axes decrease at x=0.25 and increase with more Nd³⁺ dopant. The effects of Nd³⁺ doping on the dielectric and ferroelectric properties of CaBi₄Ti₄O₁₅ ceramics are studied. Nd³⁺ dopant decreased the Curie temperature linearly, and the dielectric loss, tan δ, as well. The remnant polarization of Nd³⁺ doped CaBi₄Ti₄O₁₅ ceramics was increased by 80% at x=0.25, while more Nd³⁺ dopant decreased the remnant polarization. CaBi_3.75Nd_0.25Ti₄O₁₅ ceramics had the largest piezoelectric constant d₃₃. The structure and properties of CaBi_4−xNd_xTi₄O₁₅ ceramics showed that Nd³⁺ may occupy different crystal locations when Nd³⁺ content x is less than 0.25 and more than 0.50.     

Development of Vacuum Monitoring System in the HL-2A tokamak

HL-2A is the first divertor tokamak in China. The vacuum system is one of the important parts of the HL-2A tokamak, which has to be work well during the physics campaign in 2004. As the tokamak machine is separated from the operation staff during discharges, to guarantee the safe and reliable operation of the vacuum system, it is necessary to watch the vacuum system outside the machine hall with an automatic monitoring system. The paper describes the design and manufacture of the monitoring system.     

Vacuum System for HL-2A Tokamak

The vacuum system of today＇s tokamak devices is designed to meet the operational requirements of the experiments. The operation can be divided into five modes, （1） pumping down and leak detecting of the vacuum vessel, （2） baking, （3） plasma-facing component （PFC） conditioning, （4）evacuating and controlling of the particles at plasma edge, （5） plasma discharge experiments.     

Li3N、Mg3N2、Ca3N2催化作用的比较和分析

 Li₃N、Mg₃N₂和Ca₃N₂是高温高压下以hBN为原料合成cBN的催化剂。在实验中发现它们对常压高温下生成hBN的反应也表现出催化作用。对比了三种氮化物催化效果的差异，发现三种氮化物都只有在熔融状态下才能表现出催化效果，以及三种氮化物对生成hBN反应的催化效果与它们在高温高压下合成cBN反应的催化效果次序相似。提出了对合成hBN有催化作用的化合物也将对合成cBN表现出催化作用的观点。     

波片复合旋光器研究

利用矩阵光学方法，分析了波片复合旋光器的理论基础，给出了二元和三元复合波片旋光器的条件及其旋光角的大小的数学表达式，并根据此理论作了典型设计。结果表明，旋光角的大小与各波片的延迟量和它们的快轴同X轴的夹角有关。     

Deposition of Hydrogen-Free Silicon Nitride Thin Films by Microwave ECR plasma Enhanced Magnetron Sputtering at Room Temperature

Hydrogen-free silicon nitride （SiNx） films were deposited at room temperature by microwave electron cyclotron resonance （MW-ECR） plasma enhanced unbalance magnetron sputtering system. Both Fourier-transform infrared spectroscopy and x-ray photoelectron spectroscopy are used to study the bonding type and the change of bonding structures of the silicon nitride films. The results indicate that the chemical structure and composition of SiNx films deposited by this technique depend strongly on the N2 flow rates, the stoichiometric SiNx film, which has the highest hardness of 22.9 GPa, could be obtained at lower N2 flow rate of 4 sccm.     

“神龙一号”注入器研制

“神龙一号”注入器是直线感应加速器的束流源，它采用了感应叠加的高压加载方式，包括脉冲功率系统、感应腔、阴阳极杆、绝缘支撑、二极管和束流传输系统等子系统. 在研制中采用了径向绝缘支撑、对中支撑调节系统、类Pierce阴极等先进技术，以及二极管线圈内置和外径为800mm的铁氧体大环等创新. 参数测试显示，3.5MeV注入器达到了世界先进水平.     

四阶非线性边值问题解的存在性与上下解方法

该文讨论四阶常微分方程边值问题u^(4)(t)=f(t,u,u″), t∈［0,1］,u(0)=u(1)=u″(0)=u″(1)=0解的存在性, 其中f(t,u,v):［0,1］×R×R→R为Carathéodory函数. 在不限制f关于u,v的增长阶, 不假定f关于u,v的单调性的一般情形下, 用上下解方法获得了解的存在性结果,并讨论了单调迭代求解的有效性.     

对求解非线性方程方法的探索

BaiCL在2001年提出了双曲函数法，并把解设成具体的双曲函数，即sinhw和coshw的线性组合．本文把解设成是由2个函数f(ξ)和g(ξ)组成的线性组合，它们可以有多种取法，从而使方程更直接、更有效．借助数学软件Maple，用改进后的方法和吴文俊消元法，求解Bai C L文中的一个例子，获得了包含Bai文结果在内的更为丰富、精确的行波解．     

相对论平均场理论中各种有效相互作用对中子星性质的影响

基于相对论平均场理论，研究了各种相互作用参数组(NL1、NL3、NLSH、TM1和GL-97)对中子星物质的性质和中子星整体结构的影响．发现参数组NL1、NL3和NLSH所给出的中子星内部的介子场强度、物质的组成比例、物态方程和中子星的整体特点基本相同，但与TM1和GL-97之间有较大的差别．相对于其他参数组，GL-97给出的介子场强度最弱，中子星的相对数密度最大，物态方程也最软，同时采用GL-97参数组计算的中子星的最大质量也最小．