The Antioxidant and Hypolipidemic Effects of Mesona Chinensis Benth Extracts

In this study, the antioxidant and hypolipidemic effects of Mesona Chinensis Benth (MCB) extracts were evaluated. Seven fractions (F0, F10, F20, F30, F40, F50 and MTF) were obtained from the MCB ethanol extracts. Compared to the commercial antioxidants (vitamin C), MTF and F30 exhibited higher antioxidant activities in the antiradical activity test and the FRAP assay. The half-inhibition concentration (IC50) for MTF and F30 were 5.323 µg/mL and 5.278 µg/mL, respectively. MTF at 200 µg/mL significantly decreased the accumulation of TG in oleic acid (OA)-induced HepG2 cells and reversed the inhibitory effect of Compound C on AMPK (MTF and F30 significantly increased the glucose utilization of insulin-induced HepG2 cells). In addition, the components of MTF were identified by HPLC-MS, which were caffeic acid, quercetin 3-O-galactoside, isoquercetin, astragalin, rosmarinic acid, aromadendrin-3-O-rutinoside, rosmarinic acid-3-O-glucoside and kaempferol-7-O-glucoside. Through statistical correlations by Simca P software, it was found that the main antioxidant and hypolipidemic components of MCB might be caffeic acid, kaempferol-7-O-glucoside, rosmarinic acid-3-O-glucoside and aromadendrin-3-O-rutinoside, which may play important roles in the AMPK pathway. MTF and F30 in MCB could be potential health products for the treatment of hyperlipidemia.     

H2SO4-H2O中硝酸铜对脱硫石膏晶须生长的影响

以处理后的脱硫石膏为原料,在H₂SO₄-H₂O体系中以Cu(NO₃)₂为晶形控制剂采用水热法制备脱硫石膏晶须,探讨了Cu(NO₃)₂对脱硫石膏晶须生长的影响机理。结果表明:Cu(NO₃)₂对脱硫石膏有明显促溶作用,其中Cu²⁺可减小溶液中各离子的活度系数,使溶液中的Ca²⁺浓度增大。NO^-₃通过静电作用在Ca²⁺周围聚集并对SO^2-₄产生屏蔽作用,导致脱硫石膏继续溶解并使Ca²⁺和SO^2-₄的浓度处于相对稳定状态,有利于半水脱硫石膏晶体的形核与生长。此外,Cu²⁺还可在晶须的生长过程中选择性吸附在晶须表面,生成CuSO₄,促进了脱硫石膏的结晶生长,最终在Cu(NO₃)₂用量为2.0%(质量分数)时制备的脱硫石膏晶须长径比约为73。     

Te溶剂Bridgman法CdMnTe晶体核辐射探测器的制备和表征

碲锰镉(CdMnTe)作为性能优异的室温核辐射探测器材料,可用于环境监测和工业无损检测领域。本文中采用Te溶剂Bridgman法生长In掺杂Cd_0.9Mn_0.1Te晶体,制备成10 mm×10 mm×2 mm大小的室温单平面探测器,研究了该探测器对²⁴¹Am@59.5 keV γ射线源的能谱响应。通过表征红外透过率、电阻率以及探测器能谱响应等参数,综合评定了探测器用CdMnTe晶体的质量、电学和探测器性能。结果表明,晶片的红外透过率均在55%以上,最好可达到60%。采用湿法钝化,100 V偏压下的漏电流由钝化前的9.48 nA降为钝化后的7.90 nA,钝化后的电阻率为2.832×10¹⁰ Ω·cm。在-400 V反向偏压下,CdMnTe探测器对²⁴¹Am@59.5 keV γ射线源的能量分辨率在钝化前后分别为13.53%和12.51%,钝化后的电子迁移率寿命积为1.049×10^-3 cm²/V。研究了探测器的能量分辨率随电压的变化特性,当偏压≤400 V时,探测器的能量分辨率主要由载流子的收集效率决定,而当偏压>400 V时,能量分辨率由漏电流决定。本文研究结果表明,Te溶剂Bridgman法生长的CdMnTe晶体质量较好,电阻率和电子迁移率寿命积满足探测器制备需求。     

Transition-metal-free synthesis of 1,4-benzoxazepines via [4+3]-cycloaddition of para-quinone methides with azaoxyallyl cations

A formal[4+3]-cycloaddition reaction of ortho-hydroxyphenyl-substituted para-quinone methides(p-QMs)with in-situ generated azaoxyallyl cations is reported.The reaction occurs under very mild reaction conditions(transition-metal free,room temperature,cheap inorganic base)and provides a very efficient route to a series of biologically important 1,4-benzoxazepine derivatives in good to excellent yields.     

Racemic Norlignans as Diastereoisomers from Ferula sinkiangensis Resins with Antitumor and Wound-Healing Promotion Activities

Ferulasinkins A–D (1–4), four new norlignans, were isolated from the resins of Ferula sinkiangensis, a medicinal plant of the Apiaceae family. All of them were obtained as racemic mixtures, chiral HPLC was used to produce their (+)- and (−)-antipodes. The structures of these new compounds, including their absolute configurations, were elucidated by spectroscopic and computational methods. This isolation provides new insight into the chemical profiling of F. sinkiangensis resins beyond the well-investigated structure types such as sesquiterpene coumarins and disulfides. Compounds 2a and 3a were found to significantly inhibit the invasion and migration of triple-negative breast cancer (TNBC) cell lines via CCK-8 assay. On the other hand, the wound-healing assay also demonstrated that compounds 4a and 4b could promote the proliferation of human umbilical vein endothelial cells (HUVECs). Notably, the promoting effects of 4a and 4b were observed as more significant versus a positive control using basic fibroblast growth factor (bFGF).     

Rapid Identification for the Pterocarpus Bracelet by Three-Step Infrared Spectrum Method

In order to explore a rapid identification method for the anti-counterfeit of commercial high value collections, a three-step infrared spectrum method was used for the pterocarpus collection identification to confirm whether a commercial pterocarpus bracelet (PB) was made from the precious species of Pterocarpus santalinus (P. santalinus). In the first step, undertaken by Fourier transform infrared spectroscopy (FTIR) spectrum, the absorption peaks intensity of PB was slightly higher than that of P. santalinus only at 1594 cm⁻¹, 1205 cm⁻¹, 1155 cm⁻¹ and 836 cm⁻¹. In the next step of second derivative IR spectra (SDIR), the FTIR features of the tested samples were further amplified, and the peaks at 1600 cm⁻¹, 1171 cm⁻¹ and 1152 cm⁻¹ become clearly defined in PB. Finally, by means of two-dimensional correlation infrared (2DIR) spectrum, it revealed that the response of holocellulose to thermal perturbation was stronger in P. santalinus than that in PB mainly at 977 cm⁻¹, 1008 cm⁻¹, 1100 cm⁻¹, 1057 cm⁻¹, 1190 cm⁻¹ and 1214 cm⁻¹, while the aromatic functional groups of PB were much more sensitive to the thermal perturbation than those of P. santalinus mainly at 1456 cm⁻¹, 1467 cm⁻¹, 1518 cm⁻¹, 1558 cm⁻¹, 1576 cm⁻¹ and 1605 cm⁻¹. In addition, fluorescence microscopy was used to verify the effectiveness of the above method for wood identification and the results showed good consistency. This study demonstrated that the three-step IR method could provide a rapid and effective way for the anti-counterfeit of pterocarpus collections.     

Molecular Simulation to Explore the Dissolution Behavior of Sulfur in Carbon Disulfide

Soluble sulfur (S₈) and insoluble sulfur (IS) have different application fields, and molecular dynamics simulation can reveal their differences in solubility in solvents. It is found that in the simulated carbon disulfide (CS₂) solvent, soluble sulfur in the form of clusters mainly promotes the dissolution of clusters through van der Waals interaction between solvent molecules (CS₂) and S₈, and the solubility gradually increases with the increase in temperature. However, the strong interaction between polymer chains of insoluble sulfur in the form of polymer hinders the diffusion of IS into CS₂ solvent, which is not conducive to high-temperature dissolution. The simulated solubility parameter shows that the solubility parameter of soluble sulfur is closer to that of the solvent, which is consistent with the above explanation that soluble sulfur is easy to dissolve.     

Electrochemical Immunoassay for Tumor Marker CA19-9 Detection Based on Self-Assembled Monolayer

A CA19-9 electrochemical immunosensor was constructed using a hybrid self-assembled membrane modified with a gold electrode and applied to detect real samples. Hybrid self-assembled membranes were selected for electrode modification and used to detect antigens. First, the pretreated working electrodes were placed in a 3-mercaptopropionic acid (MPA)/β-mercaptoethanol (ME) mixture for 24 h for self-assembly. The electrodes were then placed in an EDC/NHS mixture for 1 h. Layer modification was performed by stepwise dropwise addition of CA19-9 antibody, BSA, and antigen. Differential pulse voltammetry was used to characterize this immunosensor preparation process. The assembled electrochemical immunosensor enables linear detection in the concentration range of 0.05–500 U/mL of CA19-9, and the detection limit was calculated as 0.01 U/mL. The results of the specificity measurement test showed that the signal change of the interfering substance was much lower than the response value of the detected antigen, indicating that the sensor has good specificity and strong anti-interference ability. The repeatability test results showed that the relative standard deviations were less than 5%, showing good accuracy and precision. The CA19-9 electrochemical immunosensor was used for the actual sample detection, and the experimental results of the standard serum addition method showed that the RSD values of the test concentrations were all less than 10%. The recoveries were 102.4–115.0%, indicating that the assay has high precision, good accuracy, and high potential application value.     

First Organic–Inorganic Hybrid Compounds Formed by Ge-V-O Clusters and Transition Metal Complexes of Aromatic Organic Ligands

Three compounds based on Ge-V-O clusters were hydrothermally synthesized and characterized by IR, UV-Vis, XRD, ESR, elemental analysis and X-ray crystal structural analysis. Both [Cd(phen)(en)]₂[Cd₂(phen)₂V₁₂O₄₀Ge₈(OH)₈(H₂O)]∙12.5H₂O (1) and [Cd(DETA)]₂[Cd(DETA)₂]_0.5[Cd₂(phen)₂V₁₂O₄₁Ge₈(OH)₇(0.5H₂O)]∙7.5H₂O (2) (1,10-phen = 1,10-phenanthroline, en = ethylenediamine, DETA = diethylenetriamine) are the first Ge-V-O cluster compounds containing aromatic organic ligands. Compound 1 is the first dimer of Ge-V-O clusters, which is linked by a double bridge of two [Cd(phen)(en)]²⁺. Compound 2 exhibits an unprecedented 1-D chain structure formed by Ge-V-O clusters and [Cd₂(DETA)₂]⁴⁺ transition metal complexes (TMCs). [Cd(en)₃]{[Cd(η₂-en)₂]₃[Cd(η₂-en)(η₂-μ₂-en)(η₂-en)Cd][Ge₆V₁₅O₄₈(H₂O)]}∙5.5H₂O (3) is a novel 3-D structure which is constructed from [Ge₆V₁₅O₄₈(H₂O)]¹²⁻ and four different types of TMCs. We also synthesized [Zn₂(enMe)₃][Zn(enMe)]₂[Zn(enMe)₂(H₂O)]₂[Ge₆V₁₅O₄₈(H₂O)]∙3H₂O (4) and [Cd(en)₂]₂{H₈[Cd(en)]₂Ge₈V₁₂O₄₈(H₂O)}∙6H₂O (5) (enMe = 1,2-propanediamine), which have been reported previously. In addition, the catalytic properties of these five compounds for styrene epoxidation have been assessed.