衍射辐射及其在电子束诊断中的应用

衍射辐射是由于运动的带电粒子遇到随空间变化的电介质而由感应电流产生的一种辐射. 衍射辐射由于其非阻拦性, 多参数性, 可在线性, 非常适合下一代对撞机和第四代光源的电子束诊断. 简要介绍了其物理机制, 系统的讨论了其在电子束诊断中的应用.     

高能闪光照相对电子束参数的要求

对高能闪光机光源性能用Monte-Carlo方法模拟研究发现：并非击靶电子束半径越小、发射度越低, 闪光机的照相性能就会越好. 研究结果表明：为了使闪光照相图像视面上照射量分布比较均匀, 对束半径与电子束归一发射度有一个联合限制, 对于20MeV闪光机, 如果击靶电子束有效半径是0.12cm, 那么仅当束归一发射度≥550cm.mrad时,在2°内的照射量不均匀性才小于5%.     

SILEX-1装置上等离子体尾场加速电子初步实验

激光等离子体加速电子机制可以产生准单能的高能电子束, 近年来成为国际上的研究热点. 中国工程物理研究院激光装置已经能够达到286TW的输出功率, 为国内在该领域的研究提供了实验条件. 文章介绍了在SILEX-1装置上开展的激光等离子体加速电子的初步实验, 并对测得结果进行讨论, 为下一步实验的进行提供了准备条件.     

BEPCⅡ直线加速器重大改造和束流调试进展

BEPCⅡ直线加速器的重大改造旨在获得高流强、小发射度和小能散的正负电子束, 以满足对撞机亮度提高两个两级的要求. 这对直线加速器各系统和束流物理是一个挑战. 文章介绍了直接决定束流性能的新电子源、新正电子源、新微波功率源、相位控制系统和束流测量系统等的改造情况; 叙述了束流物理研究; 介绍了束流调试进展情况和进一步改进计划.     

Fast Theoretical Simulation for Design of Helical Flux Compression Generators

A theoretical scheme is derived to achieve the numerical simulation of helical flux compression generator （HFCG） design, by which not only any physical approximation is not made, but also numerical simulation can be fast obtained. In particular, an analytic formula to calculate the inductance is deduced, which is extremely close to the experimental results. The physical process of relevant interesting physical quantity, such as inductance, enlarging current, and magnetic flux density, can be calculated to compare with the experimentally quantitative results.     

Air-activated carbons from almond tree pruning: Preparation and characterization

In this work the results obtained in the preparation and characterization of carbons made from almond tree pruning by non-catalytic and catalytic gasification (using K and Co) with air are analyzed and discussed. The main aim was to obtain high quality activated carbons at the lowest possible cost. The variables studied have been the temperature (190-260 °C) and the time (1-10 h) in non-catalytic gasification and the influence of the catalyst type (K and Co, 1 wt.% referred to cation, at 190 °C and 1 h) and the time (1-4 h) in catalytic gasification with Co at 190 °C. The air flow rate used in all the series was 167 cm³ min⁻¹. In non-catalytic gasification the reaction normalized rate versus the conversion degree was maintained until a conversion value of 10% for the experiment made at 260 °C since, at lower temperatures, this rate drops quickly for low conversion values. The N₂ adsorption isotherms for the carbons of this series resemble type I, although there is an increase of N₂ adsorbed volume at relatively high pressures. A temperature rise produced an increase of the carbon porosity and BET specific surface (116-469 m² g⁻¹). The activation time has a positive effect on the N₂ volume adsorbed by the carbons. The isotherms shapes were similar to those previously commented. A concentration equal to 1 wt.% was used to study the influence of the catalyst type. Under the studied experimental conditions, Co drives to a bigger porosity development than K, although with both catalysts a very similar pore size distribution is obtained. The activation time, in the gasifications catalyzed with Co, gives rise to a very important porosity development in the carbons. This produces a strong increase of the carbon specific surface area with very high values in the 4 h experiment, in which a BET specific surface of 959 m² g⁻¹ was obtained.     

Evolution of Shower Parton Distributions in a Jet from Quark Recombination Model

The evolution of shower parton distributions in a jet is investigated in the framework of a quark recombination model. The distributions are parameterized and the Q^2 dependence of the parameters is given by polynomials of In Q^2 for a wide range of Q^2     

Modulation of Spin Distribution and Spin Transport by a Magnetic Field in a Quasi-One-Dimensional System with Spin--Orbit Coupling

The distributions of spin and currents modulated by magnetic field in a transverse parabolic confined two-dimensional electronic system with a Rashba spin--orbit coupling have been studied numerically. It is shown that the spin accumulation and the spin related current are generated by magnetic field if the spin--orbit coupling is presented. The distributions of charge and spin currents are antisymmetrical along the cross-section of confined system. A transversely applied electric field does not influence the characteristic behaviour of charge- and spin-dependent properties.     

Fast Optical Switching Using Oriented Cyanine Dye-Doped Nematic Liquid Crystal

A cyanine dye, 2-[7-（1,3-dihydro-1,3,3-trimethyl-2H-indol-2-ylidene）-1,3,5-heptatrienyl]-1,3,3-trimethyl-3H-indolium iodide （NK-125）, is doped in 4-cyano-4＇-pentylbiphenyl （5 CB）, and the mixture is sandwiched between two pieces of rubbed glass plates. The third-order nonlinear optical properties of the oriented NK-125-SCB layers are measured by the resonant femtosecond degenerate four-wave mixing （DFWM） technique at 760 nm. The third-order nonlinear optical susceptibility of one of the present samples is 5.5×10^-8 esu. The slow DFWM response of the NK-125-SCB layers due to a population grating is accelerated by the increasing laser power because of amplified spontaneous emission （ASE）. On the other hand, we do not observe a similar phenomenon for NK-125- polyethylene glycol （PEG-400）. Oriented NK-125 molecules in nematic liquid crystals must have very high ASE efficiency. Hence the population grating in a DFWM signal disappears within about 4 ps. It is expected that NK-125-SCB can be used as a material for very fast all-optical switching.     

基于2,5-二(4′-甲酰基苯基)苯乙烯的螺旋链光学活性聚合物的合成与表征

通过2,5-二溴苯乙烯与对甲酰基苯硼酸的Suzuki偶联反应得到2,5-二(4′-甲酰基苯基)苯乙烯.在催化剂量的冰乙酸存在下,与光学纯的(S)-(-)-α-甲基苄胺或(R)-(+)-α-甲基苄胺发生缩和反应,得到了一对手性非外消旋单体,(+)-2,5-二{4-′[(N-(S)-α-甲基苄亚胺基)次甲基]苯基}苯乙烯和(-)-2,5-二{4′-[(N-(R)-α-甲基苄亚胺基)次甲基]苯基}苯乙烯.以偶氮二异丁腈(AIBN)或过氧化苯甲酰(BPO)为引发剂,经自由基溶液聚合得到光学活性聚合物.比旋光度、紫外-可见吸收光谱以及圆二色光谱研究表明,聚合物主链可能形成了某一方向占优的稳定螺旋构象,且该螺旋构象的旋光方向与单体的旋光方向相反.聚合条件对聚合物的光学活性有很大影响,在极性较大的芳香族溶剂和较高温度下得到的聚合物具有和单体相差更大的比旋光度.侧基的手性基团脱除后,聚合物仍具有一定的旋光性,说明聚合过程中形成的螺旋手性具有一定的记忆效应.