New indications of potential rat intestinal α-glucosidase inhibition by Syzygium zeylanicum (L.) and its hypoglycemic effect in mice

Research on Chemical Intermediates - Natural α-glucosidase inhibitors (aGIs) have been considered effective agents for type 2 diabetes management. In this study, Syzygium zeylanicum (L.)...     

Characterizing Plasma-exposed In0.52Al0.48As Surface Using Photoreflectance-, Raman-, and Photoluminescence Spectra Method

We have performed Photoreflectance (PR), Raman Scattering (RS), and Photoluminescence (PL) experiments to characterize the In_0.52Al_0.48As surface exposed to plasma by a gas mixture of CH₄/H₂/Ar, PR spectra indicate that RIE (plasma) causes defects such as nonradiative recombination centers, scattering centers, and defects leading to the decrease of signal intensity, broaden line width and red shift of the transitions by increasing the rf power. In the Raman scattering study, RIE causes defects against InAs-like and AlAs-like LO modes vibration. As the rf power increased, the maximum of two LO modes shifts towards lower frequency and the line shape becomes increasingly asymmetric. Also, the intensity degrades gradually by disorder and point defects with increasing rf power. The PL transition energies show a red-shift with increasing the rf power. In addition, the spectral feature broadens, and the intensity decreases with rf power higher than 200 w. The consistence of the PL, PR, and RS results indicate that these three methods can be used as sensitive probes to evaluate the near surface damage of the epilayer.     

Free energy spectra for inelastic deformation of five metallic glass alloys

The activation free energy spectra for isoconfigurational flow of Al₂₀Cu₂₅Zr₅₅,Cu₄₀Zr₆₀, Cu₅₆Zr₄₄, Cu₆₀Zr₄₀, and Pd₈₀Si₂₀ have been measured in experiments of recovery creep at stepwise increasing temperatures performed on structurally stabilized specimens that have been previously mechanically polarized by creep over a long period of time at T_g ? 150 K, followed by freezing under stress to 220 K and removal of stress. The spectra are continuous functions rising sharply from very low values at about 20 K cal mol^?1 to peak cut-off values at the activation energy for steady state isostructural viscous flow at about 45–55 K cal mol^?1. The shapes of these spectra resemble mirror images of the cavity size distributions computed for hard sphere models of glasses and the known free area distributions in glassy rafts of soap bubbles, and suggest the existence of a direct mapping between them. A small low temperature peak at about 22–25 K cal mol^?1 has been observed in Cu₅₆Zr₄₄ and Cu₆₀Zr₄₀.     

The Function of Self-Assembled Polyfluorene-Based π-Conjugated Supramolecular Structures Formed in Twisted Nematic Liquid Crystals

We demonstrate that the supramolecular structure can be formed through the fibrous self-assembly of the polyfluorene-based polymer F8BT in liquid crystal (LC) 5CB. With the utility of alignment layer, the F8BT molecules can be aligned and formed oriented polymer network. We found that the presence of oriented polymer network makes twisted nematic LC exhibit excellent electro-optical properties (EO) of driving voltage reduction and EO bump peak elimination. The polyfluorene-based supramolecular structure provides the function of stabilizing LC molecules. We consider this functional self-assembled network has potential to apply in various devices for the ability of improving performance in operating property.     

A facile sol–gel synthesis of crack-free photopolymerizable silica for holographic recording

A series of sol–gel based photopolymerizable silica glass for holographic storage has been synthesized via a facile chemical design in an effort to overcome the cracking problem incurred during the irradiation stage. The holographic composite material includes a low molecular weight polydimethylsiloxane (PDMS) with end-capped hydroxyl groups, an epoxide-containing coupling agent, a photopolymerizable acrylate monomer, and the sol–gel-derived silica matrix. Inclusion of PDMS provides improved compression stress and strain and toughness over the original unmodified samples, without deterioration on the diffraction efficiency (η). A plateau value of η ~ 40% can be found under a beam power of 5.02 mW. Correlation between the molecular weight of acrylate polymer and η of the holographic composite material is described and the discrepancies are analyzed. The premature saturation of polymerization in the holographic system is attributed to the retarded free radical polymerization within the silica matrix. Minor variation of η with photoinitiator concentration is observed, indicating that only moderate molecular weight is required for a reasonably high η. Based on the chemical and physical interactions within the material system, a crack-free mechanism is elucidated. Finally, the adverse effect of the residual photoinitiator on the holographic media is addressed.     

Growth and characterization of c-plane AlGaN on γ-LiAlO2

This study demonstrates a pure c-plane AlGaN epilayer grown on a γ-LiAlO₂ (1 0 0) (LAO) substrate with an AlN nucleation layer grown at a relatively low temperature (LT-AlN) by metal-organic chemical vapor deposition (MOCVD). The AlGaN film forms polycrystalline film with m- and c-plane when the nucleation layer grows at a temperature ranging from 660 to 680 °C. However, a pure c-plane AlGaN film with an Al content of approximately 20% can be obtained by increasing the LT-AlN nucleation layer growth temperature to 700 °C. This is because the nuclei density of AlN increases as the growth temperature increases, and a higher nuclei density of AlN deposited on LAO substrate helps prevent the deposition of m-plane AlGaN. Therefore, high-quality and crack-free AlGaN films can be obtained with a (0 0 0 2) ω-rocking curve FWHM of 547 arcsec and surface roughness of 0.79 nm (root-mean-square) using a 700-°C-grown LT-AlN nucleation layer.     

Hydrogen Bonding in the Water Stabilized Structure of the Modified Unsymmetrically Substituted Viologen Chromophore, <Emphasis Type="Italic">N</Emphasis>-ethyl-<Emphasis Type="Italic">N</Emphasis>′-(2-phosphonoethyl)-4,4′-bipyridylium Dichloride

Abstract  

The crystal structure of the modified unsymmetrically N,N′-substituted viologen chromophore, N-ethyl-N′-(2-phosphonoethyl)-4,4′-bipyridinium dichloride 0.75 hydrate (1) has been determined. Crystals are triclinic, space group P−1 with Z = 2 in a cell with a = 7.2550(1), b = 13.2038(5), c = 18.5752(7) Å, α = 86.495(3), β = 83.527(2), γ = 88.921(2)°. The two independent but pseudo-symmetrically related cations in the asymmetric unit form one-dimensional hydrogen-bonded chains through short homomeric phosphonic acid O–H···O links [2.455(4), 2.464(4) Å] while two of the chloride anions are similarly strongly linked to phosphonic acid groups [O–H···Cl, 2.889(4), 2.896(4) Å]. The other two chloride anions together with the two water molecules of solvation (one with partial occupancy) form unusual cyclic hydrogen-bonded bis(Cl···water) dianion units which lie between the layers of bipyridylium rings of the cation chain structures with which they are weakly associated.     

Study on optimal growth conditions of a-plane GaN grown on r-plane sapphire by metal-organic chemical vapor deposition

Non-polar a-plane GaN thin films were grown on r-plane sapphire substrates by metal-organic chemical vapor deposition. In order to obtain a-plane GaN films with better crystal quality and surface morphology, detailed comparisons between different growth conditions were investigated. The results showed that high-temperature and low-pressure conditions facilitating two-dimensional growth could lead to a fully coalesced a-plane GaN layer with a very smooth surface. The best mean roughness of the surface morphology was 10.5 Å. Various thickness values of AlN nucleation layers and the V/III ratios for growth of the a-plane GaN bulk were also studied to determine the best condition for obtaining a smooth surface morphology of the a-plane GaN layer.     

Nonsteroidal Constituents from Solanum Incanum L.

Sixteen compounds were isolated from the aerial parts of Solanum incanum L. These compounds included ten flavonoids ( 1‐10 ), chlorogenic acid ( 11 ), adenosine ( 12 ), benzyl‐O‐β‐D‐xylopyranosyl(1→2)‐β‐D‐glucopyranoside ( 13 ), and three phenylalkanoic acids ( 14‐16 ). The structures were determined from their physical and spectral data. Among these compounds, kaempferol 3‐O‐(6″′‐O‐2,5‐dihydroxycinnamoyl)‐β‐D‐glucopyranosyl (1→2) β‐D‐glucopyranoside ( 10 ) was identified as a new compound.