On-line coupling of sequential injection extraction with restricted-access materials for sample clean-up and analysis of drugs in biological matrix

In this contribution, the on-line coupling of solid phase extraction (SPE), based on a restricted-access material (RAM), with sequential injection technique (SIA) for the analysis of biological samples, is described. The SIA-RAM system was tested with a new potential antileucotrienic drug (VUFB-19363 (Quinlukast)) for serum analysis. The method is based on SPE with the novel internal-surface reversed-phase column packing material-alkyl-diol silica (ADS). The supports tolerate direct and repetitive injection of proteinaceous fluids (plasma, serum) and allow reversed-phase partitioning at the internal surface. A column packed with a 25 microm C18 alkyl-diol support was used for direct serum injection. Using a 6-port selection valve and the system of three mobile phases, the polar matrix compounds and metabolites are removed by sequentially aspirated mobile phases with lower content of the organic part (methanol-water (2:98) and following acetonitrile-water (20:80)) to the waste, and then, the analyte enriched on the column is eluted by a strong mobile phase (acetonitrile-methanol-water (40:20:40)) to the UV detector without transfer loss. With the fully automated SIA system, a total analysis time of less than 10 min was achieved. The only off-line sample pre-treatment step required to remove particulate matter was centrifugation. The studies showed a range of linearity (2-40 microg ml(-1)) and a high recovery (93.6-96.8%) of drug from the biological matrix with coefficients of variation (RSD) less than 5.0% (n = 6). This paper introduces a new, simple and robust analytical technique suitable for screening determination and direct analysis of drugs in biological materials.     

Solubility of Solid 2,3-Dimethylbutane and Cyclopentane in Liquid Argon and Nitrogen at the Standard Boiling Points of the Solvents

The solubilities of solid 2,3-dimethylbutane and cyclopentene in liquid argon at a temperature of 87.3 K and in liquid nitrogen at 77.4 K have been measured by the filtration method. The hydrocarbon contents in solutions were determined using gas chromatography. GC–MS was used to identify impurities in solutes. The experimental value of the mole fraction solubility of solid 2,3-dimethyl-butane in liquid argon at 87.3 K is (8.26 ± 1.60) × 10^–6 and (2.77 ± 0.94) × 10^–8 in liquid nitrogen at 77.4 K. The experimental value of the mole fraction solubility of solid cyclopentene in liquid argon at 87.3 K is (5.11 ± 0.44) × 10^–6 and (4.60 ± 0.76) × 10^–8 in liquid nitrogen at 77.4 K. The Preston–Prausnitz method was used for calculation of the solubilities of solid hydrocarbons in liquid argon in the temperature range 84.0–110.0 K and in liquid nitrogen from 64.0 to 90.0 K. The solvent–solute interaction parameters l ₁₂ were also calculated. At 90.0 K liquid argon is a better solvent for investigated solid hydrocarbons than is liquid nitrogen.     

Groups of paramagnetic centres in coal samples with different carbon contents

Complex systems of paramagnetic centres existing in demineralised flame coal (71.4 wt% C), medium-rank coal (85.6 wt% C) and anthracite (94.9 wt% C) were analysed by electron paramagnetic resonance spectroscopy (EPR). Different groups of paramagnetic centres were searched in macerals (exinite, vitrinite, inertinite) of coals with carbon contents of 73.8 wt% C and 85.6 wt% C. Experimental EPR spectra were fitted by different superposition of theoretical lines. Total concentration of paramagnetic centres both in coal and macerals increases with carbon content in the sample. Total concentration of paramagnetic centres in macerals increases from exinite to inertinite. Four groups of paramagnetic centres were found in medium-rank coal, and only two groups exist in flame coal and anthracite. The EPR spectrum of medium-rank coal is a superposition of two broad and two narrow lines. Both broad and narrow, and two narrow lines were measured in EPR spectra of flame coal and anthracite, respectively. Two types of paramagnetic centres with broad lines and one group with narrow lines exist in exinite and vitrinite from medium-rank coal. Two narrow components were observed in EPR spectra of its inertinite. Two different broad electron paramagnetic resonance signals were detected for macerals from low-coalificated coal. Paramagnetic centres systems of medium-rank coal samples reveal the most complex character. Broad EPR lines were not observed for the higher coalificated samples, i.e., anthracite and inertinite from medium-rank coal. Narrow lines do not occur in EPR spectra of low-coalificated macerals. Strong dipolar interactions and fast spin-lattice relaxation processes are characteristic for paramagnetic centres with broad lines. Strong exchange interactions and short spin-lattice relaxation time were measured for paramagnetic centres with the narrowest EPR signals.     

Dielectric studies of two liquid crystalline benzoates with coupled and decoupled CN groups

The results of dielectric studies performed in a broad frequency range for two compounds, 4-cyanophenyl 4-n-heptylbenzoate (7BBCN) and 4-(4-cyanobutyloxy)phenyl 4- n-heptylbenzoate (7BB4CN), are compared. They have the same molecular core whereas the strongly polar CN group is attached to the benzene ring in 7BBCN or is separated from it by the butyloxy chain in 7BB4CN. 7BBCN has a nematic phase, whereas 7BB4CN exhibits a monotropic nematic and smectic A₂ polymorphism. Large differences in the dielectric properties of the two substances were found. The analysis of the results led to the conclusion that the antiparallel dipole-dipole associations are considerably stronger in the substance with a decoupled CN group.     

Effect of temperature on the equilibrium and kinetics of galactose,glucose, and lactose adsorption on a cation exchanger

Galacto-oligosaccharides are typically produced by an enzymatic reaction when the post-reaction mixture contains considerable amounts of lactose and glucose and a smaller amount of galactose. In order to develop a process of chromatographic removal of saccharide impurities, adsorption equilibria and kinetics of these di- and monosaccharides were investigated for Diaion UBK 530, an industrialgrade strong cation-exchanger in the Na⁺ form. Frontal chromatographic experiments were carried out in the temperature range of 30–70°C and a broad interval of saccharide concentrations up to 350 g L^?1. Breakthrough curves were described using the equilibrium-dispersive model with the linear adsorption isotherm. Both the distribution and the axial dispersion coefficient values depended on the saccharide molecule type and size. No significant effect of temperature or concentration on the distribution coefficient was observed. The apparent dispersion coefficients of all saccharides exhibited some decrease with the temperature, which was caused by the decrease of the intraparticle mass transfer resistance. An analysis showed that both the intraparticle mass transfer and the axial dispersion had a significant influence on the front dispersion.     

Silver(I) complex with 2-amino-4,4α-dihydro-4α,7-dimethyl-3H-phenoxazin-3-one (Phx-1) ligand: crystal structure,vibrational spectra and biological studies

The first metal complex of Phx-1 ligand, bis(2-amino-4,4α-dihydro-4α,7-dimethyl-3H-phenoxazin-3-one)nitratosilver(I), [Ag(Phx-1)₂NO₃], has been obtained and investigated by single crystal X-ray diffraction and vibrational spectroscopy methods. The Ag⁺ is bonded to heterocyclic nitrogen atoms of two organic ligands and one oxygen atom of a nitrate anion. The Phx-1 ligand coordination mode is supported by IR and Raman spectra, interpreted with the help of theoretical DFT studies. The antibacterial activity of the ligand and its Ag(I) complex as well as some reference compounds were screened against Gram-positive and Gram-negative bacteria, applying microdilution procedures. High sensitivity to the studied complex was found for Rhodococcus erythropolis and Bacillus licheniformis strains. Modified Phx-1 ligand preparation procedures are also presented.     

Thermal and mechanical properties of chitosan nanocomposites with cellulose modified in ionic liquids

In this paper, ionic liquid treatment was applied to produce nanometric cellulose particles of two polymorphic forms. A complex characterization of nanofillers including wide-angle X-ray scattering, Fourier transform infrared spectroscopy, and particle size determination was performed. The evaluated ionic liquid treatment was effective in terms of nanocrystalline cellulose production, leaving chemical and supermolecular structure of the materials intact. However, nanocrystalline cellulose II was found to be more prone to ionic liquid hydrolysis leading to formation larger amount of small particles. Each nanocrystalline cellulose was subsequently mixed with a solution of chitosan, so that composite films containing 1, 3, and 5% mass/mass of nanometric filler were obtained. Reference samples of chitosan and chitosan with micrometric celluloses were also solvent casted. Thermal, mechanical, and morphological properties of films were tested and correlated with properties of filler used. The results of both, tensile tests and thermogravimetric analysis showed a significant discrepancy between composites filled with nanocrystalline cellulose I and nanocrystalline cellulose II.     

Hydrotalcite-derived Co-containing mixed metal oxide catalysts for methanol incineration

The Co–Mg–Al mixed metal oxides were prepared by calcination of co-precipitated hydrotalcite-like precursors at various temperatures (600–800 °C), characterised with respect to chemical (AAS) and phase (XRD) composition, textural parameters (BET), form and aggregation of cobalt species (UV–vis-DRS) and their redox properties (H₂-TPR, cyclic voltammetry). Moreover, the process of thermal decomposition of hydrotalcite-like materials to mixed metal oxide systems was studied by thermogravimetric method combined with the analysis of gaseous decomposition products by mass spectrometry. Calcined hydrotalcite-like materials were tested as catalysts for methanol incineration. Catalytic performance of the oxides depended on cobalt content, Mg/Al ratio and calcination temperature. The catalysts with lower cobalt content, higher Mg/Al ratio and calcined at lower temperatures (600 or 700 °C) were less effective in the process of methanol incineration. In a series of the studied catalysts, the best results, with respect to high catalytic activity and selectivity to CO₂, were obtained for the mixed oxide with Co:Mg:Al molar ratio of 10:57:33 calcined at 800 °C. High activity of this catalyst was likely connected with the presence of a Co–Mg–Al spinel-type phases, containing easy reducible Co³⁺ cations, formed during high-temperature treatment of the hydrotalcite-like precursor.     

Reintroducing anisotropic interactions in magic-angle-spinning NMR of half-integer quadrupolar nuclei: 3D MQMAS

Selective reintroduction of anisotropic interactions such as the chemical shift anisotropy (CSA) and homonucler dipolar (HMD) coupling were implemented in a high-resolution NMR spectroscopy for half-integer quadrupolar nuclei. Rotary resonance recoupling (R(3)) combined with the multiple-quantum magic-angle spinning (MQMAS) in a three-dimensional (3D) experiment provides not only site-specific high-resolution spectra to yield the quadrupolar interaction parameters but also the CSA or HMD interaction parameters. This 3D experiment provides an avenue for the complete local structural information of half-integer quadrupolar nuclei. Three-dimensional MQMAS experiments incorporating R(3) of HMD and CSA interactions were demonstrated on model compounds containing (11)B, (23)Na, and (87)Rb nuclei.     

Investigation of the alumina properties with adsorbed polyvinyl alcohol

The influence of solution pH on the structure of polyvinyl alcohol adsorption layer on the alumina surface was investigated. The spectrophotometry, viscosimetry, thermogravimetry, potentiometric titration and microelectrophoresis were applied in experiments. These methods enable determination of the following parameters: adsorbed amount of PVA, stability of suspension without and with polymer, thickness of its adsorption layers, changes in thermal characteristics of Al₂O₃ surface with the adsorbed polymer, surface charge density and zeta potential of solid particles in the presence and absence of PVA, respectively. All measurements were carried out in the pH range 3–9. The obtained results indicate that pH has a great influence on the conformation of PVA chains adsorbed on the alumina surface. It is due to incomplete hydrolysis of acetate groups of polyvinyl alcohol macromolecules (degree of hydrolysis 97.5%), which dissociate with the increasing pH. Moreover, the polymer adsorption on the alumina surface causes changes in the course of thermogravimetric curves. The effect of weight loss for Al₂O₃–PVA systems is smaller than that of Al₂O₃ without polymer. It is due to elimination of water molecules from the solid surface by adsorbed polymer.