Crossover from high-temperature vortex-liquid to low-temperature vortex-glass behavior in single phase HgBa2Ca2Cu3O8+δ superconductor

The ρ-T curves in our single phase HgBa₂Ca₂Cu₃O_8+δ superconductor were measured as a function of temperature and magnetic field, ρ=ρ₀exp(−U_eff/κ_BT). It can be transformed to another form d(lnρ)/d(1/T)=−U_eff+TdU_eff/dT, then this becomes a plot of the activation energy U_eff as a function of temperature. Our data plotted in these ways show a clear crossover from high-temperature two-dimensional vortex-liquid to a critical region associated with the low-temperature three-dimensional vortex-glass phase transition. The critical exponents v(z−1)=3.9±1.9 in this system are little different with previous measurements in BSCCO and YBCO systems.     

Interfacial structure and electrical properties of LaAlO3 gate dielectric films on Si by metalorganic chemical vapor deposition

LaAlO₃ (LAO) gate dielectric films were deposited on Si substrates by low-pressure metalorganic chemical vapor deposition. The interfacial structure and composition distribution were investigated by high-resolution transmission electron microscopy (HRTEM), X-ray photoelectron spectroscopy (XPS), secondary-ion mass spectroscopy (SIMS), and Auger-electron spectroscopy (AES). HRTEM confirms that there exists an interfacial layer between LAO and Si in most samples. AES, SIMS, and XPS analyses indicate that the interfacial layer is compositionally graded La–Al silicate and the Al element is severely deficient close to the Si surface. Electrical properties of LAO films were evaluated. No evident difference in electrical properties between samples with and without native SiO₂ layers was observed. The electrical properties are discussed in terms of LAO growth mechanisms, in relation to the interfacial structure. PACS 73.40.Qv; 81.15.Gh; 77.55.+f; 68.35.-p     

Facile preparation of new unsymmetrical curcumin derivatives by solid-phase synthesis strategy

Seventeen unsymmetrical curcumin derivatives were synthesized in good yield and purity by a facile solid phase synthesis strategy.     

Sn-C60薄膜的紫外吸收光谱和X-射线衍射谱分析

对Sn-C60薄膜进行紫外可见光吸收，X-射线衍射和扫描电镜的测定结果显示，薄膜样品紫外可见光吸收的两个短波段吸收峰比纯C60薄膜的吸收峰显著下降，说明Sn-C60薄膜的电子光吸收跃迁为间接跃迁，能带中有杂质能级的存在；样品的X射线衍射峰则对应于面心立方结构；扫描电镜结果显示薄膜为纳米级颗粒组成。     

Annealing behavior of gel‐spun polyethylene fibers at temperatures lower than needed for significant shrinkage

The annealing at 373 K of ultrastrong, gel‐spun polyethylene (PE) has been studied. At this temperature, the fibers show no significant shrinkage. Still, a significant decrease in the mechanical properties is observed. The fibers have been analyzed with differential scanning calorimetry (DSC), temperature‐modulated differential scanning calorimetry (TMDSC), atomic force microscopy (AFM), and small‐angle X‐ray scattering (SAXS). During the annealing, the glass transition of the intermediate phase is exceeded, as shown by DSC. When split for structure analysis by AFM, the annealed fibers undergo plastic deformation around the base fibrils instead of brittle fracture. The quasi‐isothermal TMDSC experiments are compared to the minor structural changes seen with SAXS and AFM. The loss of performance of the PE fibers at 373 K is suggested to be caused by the oriented intermediate phase, and not by major changes in the structure or morphology. The overall metastable, semicrystalline structure is shown by TMDSC to posses local regions that can melt reversibly. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 41: 403–417, 2003     

Repetition rate multipliers for efficient implementation of multiphoton and pump-probe fluorescence microscopy

With the advances in pulsed laser systems, microscopic imaging techniques such as multiphoton and pump-probe fluorescence microscopy have developed into effective tools for investigating intensity and time-resolved phenomena inside biological systems. However, pulsed lasers used in these techniques usually are commercial systems with repetition frequencies of around 80 MHz. While these systems have proven to be adequate for multiphoton and pump-probe microscopic imaging applications, the temporal separation of the laser pulse train (around 12.5 ns) is long compared to the fluorescence lifetimes of many common fluorescence species. In this work, we present the designs of repetition rate multipliers based on passive optical components that can be used to increase the efficiency in multiphoton and pump-probe fluorescence microscopy. Depending on the lifetime of fluorescence molecules under investigation, the passive repetition rate multiplier can increase the duty cycle of multiphoton or pump-probe microscopy up to fourfold.     

A diode-pumped passively Q-switched Nd:GdVO4 laser with a GaAs saturable absorption

We have demonstrated a passively Q-switched operation of Nd:GdVO₄ laser in which a GaAs crystal is used as the saturable absorber for the first time as far as we know. A maximum average output power of 1.64 W was obtained at an incident pump power of 12 W, the corresponding optical conversion efficiency and peak power were 13.7% and 116.8 W, respectively. The maximum peak energy obtained in the experiment by 50% transmission couple was 19 μJ.     

有限长FGM圆筒的热/机应力的解析解

利用微分方程的级数求解方法,分析了两端简支的有限长功能梯度圆筒的轴对称稳态热弹性问题,推导出了稳态温度场与应力场的解析解。分析中采用指数函数模型来描述FGM圆筒中材料性能在厚度方向的连续变化,同时忽略温度对材料性能的影响。另外,论文以金属钼和多铝红柱石制成的功能梯度圆筒为例,给出了稳态温度场和应力场的数值结果。     

论浮力的计算

通过讨论物体下表面不与液体接触时浮力的计算,总结浮力计算的一般方法.