Bamboo-shaped Ag-doped TiO2 nanowires with heterojunctions

Bamboo-shaped Ag-doped TiO2 nanowires with heterojunctions were synthesized by a simple solvothermal method. The diameter of the nanowires was about 50-100 nm, and they had a length of up to a few millimeters. The detailed structure of the heterojunction in the nanowire was also characterized.     

Controlled growth of large-area, uniform, vertically aligned arrays of alpha-Fe2O3 nanobelts and nanowires

Vertically aligned iron oxide nanobelt and nanowire arrays have been synthesized on a large-area surface by direct thermal oxidation of iron substrates under the flow of O(2). The effects of reactive gas pressure, composition, and temperature have been systematically studied. It was found that nanobelts (width, tens of nanometers; thickness, a few nanometers) are produced in the low-temperature region (approximately 700 degrees C) whereas cylindrical nanowires tens of nanometers thick are formed at relatively higher temperatures (approximately 800 degrees C). Both nanobelts and nanowires are mostly bicrystallites with a length of tens of micrometers which grow uniquely along the [110] direction. The growth habits of the nanobelts and nanowires in the two temperature regions indicate the role of growth rate anisotropy and surface energy in dictating the ultimate nanomorphologies.     

1β—Methyl Carbapenem中间体的合成

综述了１β－Ｍｅｔｈｙｌ Ｃａｒｂａｐｅｎｅｍ中间体的合成方法，重点强调了如何构筑１位β构型的甲基。参考文献３７篇。     

Studies on synthesis and infrared and fluorescence spectra of new europium and terbium complexes with an amide-based open-chain crown ether

An amide-based open-chain crown ether ligand and its complexes with europium and terbium were synthesized. The complexes were characterized by elemental analysis, infrared spectra and conductivity. The europium and terbium ions were found to coordinate to the C=O oxygen atoms and pyridine nitrogen atoms. The fluorescence properties of these complexes in DMF and CH3OH/CHCl3 were studied. Under the excitation of UV light, these complexes exhibit characteristic fluorescence of europium and terbium ions. The solvent factors influencing the fluorescent intensity are discussed.     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Research on Crystal Structure of the Complex of 10－Hydroxy－10－（3－indolyl）－9－phenanthrenone with Tetrahydrofuran

ＲｅｓｅａｒｃｈｏｎＣｒｙｓｔａｌＳｔｒｕｃｔｕｒｅｏｆｔｈｅＣｏｍｐｌｅｘｏｆ１０－Ｈｙｄｒｏｘｙ－１０－（３－ｉｎｄｏｌｙｌ）－９－ｐｈｅｎａｎｔｈｒｅｎｏｎｅｗｉｔｈＴｅｔｒａｈｙｄｒｏｆｕｒａｎＭｅｎｇＪｉ－Ｂｅｎ；ＷｅｎＺｈｏｎｇ；Ｗａｎｇ...     

聚（3—丁基噻吩）电导的热稳定性

研究了导电聚合物聚（３－丁基噻吩）（ＰＢＴ）在大气环境下的导电热稳定性。在室温至２２０℃范围内，测试电导率随时间及温度的变化。ＴＧＡ分析以及化学分析的结果表明：掺杂态的ＰＢＴ大约在１４０℃附近有一转化温度，低于或高于这一转化温度，电导率下降的决定因素各不相同。高于转化温度时，电导率下降的主要原因是反离子和高分子主链的解离，进而发生化学反应，影响了高分子主链的结构。ＸＰＳ测试结果表明：经热处理后的Ｐ     

Topology evolution and gelation mechanism of agarose gel

Kinetics as well as the evolution of the agarose gel topology is discussed, and the agarose gelation mechanism is identified. Aqueous high melting (HM) agarose solution (0.5% w/v) is used as the model system. It is found that the gelation process can be clearly divided into three stages: induction stage, gelation stage, and pseudoequilibrium stage. The induction stage of the gelation mechanism is identified using an advanced rheological expansion system (ARES, Rheometric Scientific). When a quench rate as large as 30 deg C/min is applied, gelation seems to occur through a nucleation and growth mechanism with a well-defined induction time (time required for the formation of the critical nuclei which enable further growth). The relationship between the induction time and the driving force which is determined by the final setting temperature follows the 3D nucleation model. A schematic representation of the three stages of the gelation mechanism is given based on turbidity and rheological measurements. Aggregation of agarose chains is promoted in the polymer-rich phase and this effect is evident from the increasing mass/length ratio of the fiber bundles upon gelation. Continuously increasing pore size during gelation may be attributed to the coagulation of the local polymer-rich phase in order to achieve the global minimum of the free energy of the gelling system. The gel pore size determined using turbidity measurements has been verified by electrophoretic mobility measurements.     

C9‐Iridoids from Scrophularia buergeriana

Four new iridoids, buergerinins B–E ( 1 – 4 ), along with three known iridoids, were isolated from the roots of Scrophularia buergeriana. Their structures were identified on the basis of spectroscopic analysis.