Four-wave mixing based 10-Gb/s tunable wavelength conversion in dispersion-flattened microstructure fibers

All-optical wavelength conversion of 10-Gb/s signal based on four-wave mixing is experimentally demonstrated in a 30-m-long dispersion-flattened microstructure fiber with small positive dispersion. For an average pump power of 26 dBm, the conversion efficiency was around -19.5 dB with the fluctuation less than ±1.4 dB, covering a conversion bandwidth of 20 nm. The eye diagram of the converted signal shows good eye opening.     

Annealing and measurement temperature dependence of W2B5-based rectifying contacts to n-GaN

The thermal stability and measurement temperature dependence of Schottky contact characteristics on n-GaN using a W₂B₅/Ti/Au metallization scheme was studied using current-voltage (I-V), scanning electron microscopy (SEM) and Auger electron spectroscopy (AES) measurements. The elemental profile obtained from samples annealed at 350 °C showed some titanium diffusion into the gold layer but little other difference from the as-deposited wafer. Annealing at 700 °C produced significant diffusion of titanium. The Schottky barrier height increased with anneal temperature up to 200 °C, reaching a maximum value of 0.65 eV, but decreased at higher annealing temperatures. The reverse breakdown voltage from diodes fabricated using the W₂B₅-based contacts showed a similar dependence. The reverse current magnitude was larger than predicted by thermionic emission alone. The barrier height showed only minor changes with measurement temperature up to 150 °C.     

300kVA高温超导变压器电流引线漏热损耗的测量

电流引线是高温超导变压器的主要外部漏热来源,它的漏热量直接影响了超导变压器的经济性能,因此,引线的设计与漏热测量一直备受关注。文中构建了一个实验方案,运用量热法测量低压引线的漏热,并将试验结果与仿真预期值进行了对比和分析,从而验证了仿真设计的正确性。     

Study on anti-emission materials for non-emitting grid applications in microwave power tubes

Hafnium and platinum were deposited onto molybdenum grids by ion-beam assisted deposition method. Electron-emission characteristics from molybdenum grids with Hf and Pt films, which were contaminated by active electron-emission substances (Ba, BaO) of the cathode, were measured using analogous diode method. The surfaces of grids were analyzed by X-ray diffraction. The results revealed that the reaction between BaO and Hf formed BaHfO₃ compound, which greatly reduced the accumulation of BaO on the surface and accordingly decreased grid emission. In contrast, Ba were formed by the decomposition of BaO on the surface of Pt film under high temperature and re-evaporated from its surface, which reduced the active electron-emission substances on the surface of the grid and effectively restrained grid emission. Their mechanisms for grid-emission suppression are discussed and a good method to develop new grid-coating materials is suggested.     

F+H2→HF+H反应的全量子态分辨的散射动力学研究

利用高灵敏度的氢原子里德堡飞渡时间谱方法研究了 F H_2→HF H 反应碰撞能在5.02kJ/mol 下的交叉分子束反应态态散射动力学.所有在时间飞渡谱中被观测到的谱峰可以归属为 HF 产物的振转态结构.还观测到了明显的 HF(v’=3)前向散射,以及少许的 HF(v’=2)前向散射.     

随机动力系统的进展和问题

本文主要介绍随机动力系统的主要成果和进一步研究的问题。     

Lenglart不等式与特殊半鞅的收敛集

本文讨论局部鞅和特殊半鞅的收敛集。我们给出Ｌｅｎｇｌａｒｔ不等式的一个推广形式，利用这一不等式对一些定理给出了简单证明，对一些结果作了改进和推广。     

Melt rheology of polylactide/montmorillonite nanocomposites

In this article, the linear and nonlinear shear rheological behaviors of polylactide (PLA)/clay (organophilic‐montmorillonite) nanocomposites (PLACNs) were investigated by an Advanced Rheology Expanded System rheometer. The nanocomposites were prepared by master batch method using a twin‐screw extruder with poly(ε‐caprolactone) (PCL) as a compatibilizer. The presence of org‐MMT leads to obvious pseudo‐solid‐like behaviors of nanocomposite melts. The behaviors caused by the formation of a “percolating network” derived from the reciprocity among the strong related sheet particles. Therefore, the storage moduli, loss moduli, and dynamic viscosities of PLACNs show a monotonic increase with MMT content. Nonterminal behaviors exists in PLACNs nanocomposites. Besides the PLACNs melts show a greater shear thinning tendency than pure PLA melt because of the preferential orientation of the MMT layers. Therefore, PLACNs have higher moduli but better processibility compared with pure PLA. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3189–3196, 2007     

Crystallographic report: Crystal structure of tetra(4‐methyl‐5‐imidazole‐carboxyaldehyde)zinc(II) diperchlorate

The central zinc(II) atom in the title complex is tetrahedrally coordinated by four nitrogen atoms derived from 4‐methyl‐5‐imidazolecarboxyaldehyde ligands with Zn? N in the range 2.007(3) to 2.026(4) Å. Copyright © 2003 John Wiley & Sons, Ltd.