Gas chromatography/ion trap tandem mass spectrometry for the analysis of halobenzenes in soils by solid-phase microextraction

Headspace solid-phase microextraction combined with gas chromatography/ion trap tandem mass spectrometry (HS-SPME/GC/ITMS/MS) was used for the analysis of 12 halobenzenes from soil samples. For MS/MS optimisation, the experiments were performed by precursor ion selection and software controlled operations. Collision-induced dissociation (CID) can be achieved by two different approaches, resonant and non-resonant excitation modes. Different results were obtained using the two approaches, and the resonant excitation mode was chosen as the best for all halobenzenes. Parameters such as the CID excitation amplitude, excitation RF storage level and CID bandwidth frequency were optimised to maximise the formation of halobenzene product ions. A 100-microm polydimethylsiloxane fibre was used for the isolation and preconcentration of the analytes. The HS-SPME/GC/ITMS/MS method was applied to the analysis of halobenzenes in an agricultural soil sample. The halobenzenes were quantified by standard addition, which led to good reproducibility (RSD between 4.7 and 9.2%) and detection limits in the low pg/g range. The method was validated by comparing the results with those obtained in a European inter-laboratory exercise.     

Comparative study on the determination of cephalexin in its dosage forms by spectrophotometry and HPLC with UV-vis detection

This paper discusses the spectrophotometric determination of cephalexin as the intact cephalexin or as its acid-induced degradation product. Cephalexin can be determined in the range 1 × 10^–5–18 × 10^–5 M with relative standard deviations of 5-1%. The limits of quantitation and detection were 10^–5 and 0.3 × 10^–5 M, respectively. These procedures were compared with reversed-phase HPLC determination. No interference was observed in the presence of common pharmaceutical adjuvants. The H-point standard additions method was applied in order to correct for the possible presence of the cephalexin precursor, 7-aminocephalosporanic acid; this improves the selectivity of the UV-vis spectrophotometric method.     

Modification of Amaya-Sugiura passive sampling spectrophotometric method of nitrogen dioxide determination in ambient air

Summary On the example of the previously tested method of nitrogen dioxide determination in ambient air two aspects of wind influence on the badge-type sampler performance were discussed: an appropriate design of the sampler eliminating any open recess over the face of the sampler and so called starvation effect i.e. decrease in the mass of analyte absorbed by the sampler at wind velocities below 20 cm/s. The wind effect on the performance of the passive sampler has been diminished from about 150% to maximum 20%.     

On Triazoles. XIII. The reaction of 5-benzalimino-1,2,4-triazoles with substituted acetyl chlorides

The reaction of Schiff bases prepared from 1- and 2-substituted-5-amino-1,2,4-triazoles with phenoxyacetyl chlorides in the presence of triethylamine and a mixture of phosphorus oxychloride and dichloroacetic acid in dimethylformamide to yield β-lactam 4 , a dihydro-1,2,4-triazolo[4,3-a]pyrimidine-5(1H)-one 5, a 1,2,4-triazolo[1,5-a]pyrimidin-5(3H)-one 9 and the corresponding 1,2,4-triazolo[4,3-a]pyrimidine-5(1H)-one 10 derivatives was studied.     

Design and Application of a Set of Vitreous Standards for EDS-SEM Microanalysis of Melting Shop Slags

Non-metallic inclusions in steel are formed due to interactions between liquid steel and its environment in the melting shop (refractories and slags). Particles not trapped in the slag remain in the cast steel, impairing steel properties in service. Inclusion composition varies and certified standards covering the whole compositional range are unavailable.The present study describes the preparation of a set of homogeneous, glassy and crystalline standards with a wide compositional range for use in analysing non-metallic steel inclusions. For this, materials were designed based on knowledge of the compositional range of interest in the Al₂O₃–SiO₂–CaO–MgO–CaF₂ system, which is the matrix of the most frequent steel inclusions. The composition and microstructural homogeneity of the reference materials was verified.     

Rapid and flexible synthesis of 1-deoxy-D-xylulose-5-phosphate, the substrate for 1-deoxy-D-xylulose-5-phosphate reductoisomerase

1-Deoxy-D-xylulose-5-phosphate (DXP) is a key intermediate in the non-mevalonate pathway to terpenoids in bacteria, and it is the substrate for the enzyme 1-deoxy-D-xylulose-5-phosphate reductoisomerase (DXP-R). In order to study the mechanism of DXP-R, we required a flexible synthesis of the substrate which would allow the incorporation of isotopic labels, and the variation of the two stereocentres. Thus 1,4-dihydroxypent-2-yne was selectively reduced to give the E-olefin, and selective phosphorylation of the primary alcohol followed by oxidation of the secondary alcohol gave a substrate suitable for dihydroxylation. Dihydroxylation using stoichiometric OsO4 in the presence of chiral ligands gave protected DXP in high ee. Final hydrogenolysis gave DXP in quantitative yield and high purity. DXP-R was produced by rapid cloning of the dxr gene from Escherichia coli through controlled expression and ion exchange chromatography. The synthetic DXP was fully active in enzyme assays catalysed by recombinant DXP-R.     

Palladium-catalyzed cascade reaction of alpha,beta-unsaturated sulfones with aryl iodides

Unlike traditionally used acyclic 1,2-disubstituted alkenes, the reaction of alpha,beta-unsaturated phenyl sulfones with aryl iodides under Heck reaction conditions (Pd(OAc)(2) as catalyst, Ag(2)CO(3) as base in DMF at 120 (0)C) takes place mainly by a cascade process, involving one unit of the alkene and three units of the aryl iodide, to afford a substituted 9-phenylsulfonyl-9,10-dihydrophenanthrene. The dominant formation of this 3:1 coupling product, instead of the Heck trisubstituted olefin, shows that aromatic C-H bond activation processes can compete with the usually fast syn beta-hydrogen elimination step in the Heck arylation of an acyclic olefin. The structural scope of this palladium-catalyzed cascade arylation of alpha,beta-unsaturated sulfones has proved to be wide with regard to substitution at the beta-position (alkyl, aryl, or alkenyl substitution), substitution at the sulfone unit (alkyl or phenyl sulfones), and configuration at the CdoublebondC bond (trans or cis). Moreover, although less favored than in the case of the arylation of alpha,beta-unsaturated sulfones, similarly substituted 9,10-dihydrophenanthrenes have also been obtained in the case of alpha,beta-unsaturated phosphine oxides and alpha,beta-unsaturated phosphonate esters. A Pd(0)-Pd(II)-Pd(IV) mechanistic pathway involving the successive formation of highly electrophilic sigma-alkylpalladium intermediates and palladacycles is proposed for this multicomponent arylation.     

Liquid chromatographic determination of aliphatic amines in water using solid support assisted derivatization with 9-fluorenylmethyl chloroformate

Summary A simple and sensitive method has been developed for the liquid chromatographic determination of short-chain aliphatic amines in water. Analytes are retained in solid-phase extraction (SPE) cartridges, and then derivatized by drawing an aliquot of the fluorogeneic reagent 9-fluorenylmethyl chloroformate (FMOC) through the cartridges. After a certain reaction time the derivatives formed are desorbed with acetonitrile. The collected extracts are then chromatographed on a LiChrospher 100 RP₁₈ 125 mm×4 mm i.d., 5 μm, column using an acetonitrile-water gradient. The influence of experimental conditions (SPE material, volume of sample, concentration of FMOC, time of reaction and pH) has been investigated. Optimal results have been obtained with C₁₈ SPE cartridges using a sample volume of 5.0 mL. For derivatization, 0.25 mL aliquots of 25 mM FMOC have been used, the reaction time being only 2 min. The method has been applied to the quantification of several aliphatic amines: methylamine, ethylamine, dimethylamine,n-butylamine,n-pentylamine andn-hexylamine. Under the proposed conditions the percentages of analytes retained plus derivatized were of about 54–107% compared to those obtained with direct solution derivatization. The method provided good reproducibility, linearity and accuracy within the 0.050–1.0 mg L⁻¹ concentration range. The limits of detection were in the 0.25–5.0 μg L⁻¹ range. The utility of the described approach has been tested by analysing tap water, river water and industrial waste water.     

Surface-functionalized latex particles as controlling agents for the mineralization of zinc oxide in aqueous medium

Polystyrene latex particles modified at the surface with different hydrophilic functional groups were prepared by miniemulsion polymerization and used as controlling agents in the crystallization of zinc oxide from aqueous medium. The effects of the chemical nature of the surface functionalization and the latex concentration on the crystal growth, morphology, and crystalline structure of the resulting zinc oxide were analyzed. Micro- and submicrosized crystals with a broad variety of morphologies depending on the functionalization were obtained. Among the different latexes studied, the acrylic-acid-derived particles were shown to be a convenient system for further quantitative investigations. In this case, as the additive concentration increases, the length-to-width ratio (aspect ratio) of the crystals decreases systematically. Preferential adsorption of the latex particles onto the fast-growing faces {001} of ZnO is assumed to follow a Langmuir-type isotherm, and interaction of the adsorbed particles with the growth centers will reduce the growth rate in [001]. This leads to a quantitative relationship linking the aspect ratio to the latex concentration at constant diameter and surface chemistry of the latex. The dependence of the aspect ratio on charge density of the latex can also be modeled by an algorithm in which attractive forces between the latex particle and the ZnO surface are balanced against repulsive forces of an osmotic nature. The latter are associated with the confined volume between the crystal and latex particle surfaces.     

First investigation of non-classical dihydrogen bonding between an early transition-metal hydride and alcohols: IR, NMR, and DFT approach

The interaction of [NbCp(2)H(3)] with fluorinated alcohols to give dihydrogen-bonded complexes was studied by a combination of IR, NMR and DFT methods. IR spectra were examined in the range from 200-295 K, affording a clear picture of dihydrogen-bond formation when [NbCp(2)H(3)]/HOR(f) mixtures (HOR(f) = hexafluoroisopropanol (HFIP) or perfluoro-tert-butanol (PFTB)) were quickly cooled to 200 K. Through examination of the OH region, the dihydrogen-bond energetics were determined to be 4.5+/-0.3 kcal mol(-1) for TFE (TFE = trifluoroethanol) and 5.7+/-0.3 kcal mol(-1) for HFIP. (1)H NMR studies of solutions of [NbCp(2)H(2)(B)H(A)] and HFIP in [D(8)]toluene revealed high-field shifts of the hydrides H(A) and H(B), characteristic of dihydrogen-bond formation, upon addition of alcohol. The magnitude of signal shifts and T(1) relaxation time measurements show preferential coordination of the alcohol to the central hydride H(A), but are also consistent with a bifurcated character of the dihydrogen bonding. Estimations of hydride-proton distances based on T(1) data are in good accord with the results of DFT calculations. DFT calculations for the interaction of [NbCp(2)H(3)] with a series of non-fluorinated (MeOH, CH(3)COOH) and fluorinated (CF(3)OH, TFE, HFIP, PFTB and CF(3)COOH) proton donors of different strengths showed dihydrogen-bond formation, with binding energies ranging from -5.7 to -12.3 kcal mol(-1), depending on the proton donor strength. Coordination of proton donors occurs both to the central and to the lateral hydrides of [NbCp(2)H(3)], the former interaction being of bifurcated type and energetically slightly more favourable. In the case of the strong acid H(3)O(+), the proton transfer occurs without any barrier, and no dihydrogen-bonded intermediates are found. Proton transfer to [NbCp(2)H(3)] gives bis(dihydrogen) [NbCp(2)(eta(2)-H(2))(2)](+) and dihydride(dihydrogen) complexes [NbCp(2)(H)(2)(eta(2)-H(2))](+) (with lateral hydrides and central dihydrogen), the former product being slightly more stable. When two molecules of TFA were included in the calculations, in addition to the dihydrogen-bonded adduct, an ionic pair formed by the cationic bis(dihydrogen) complex [NbCp(2)(eta(2)-H(2))(2)](+) and the homoconjugated anion pair (CF(3)COO...H...OOCCF(3))(-) was found as a minimum. It is very likely that these ionic pairs may be intermediates in the H/D exchange between the hydride ligands and the OD group observed with the more acidic alcohols in the NMR studies.