Studies on the influence of various experimental conditions on electrochemical generation of ferrate(VI) in NaOH-KOH mixed electrolyte

Ferrate(VI) was prepared by electrooxidation in diaphragm electrolyzer with iron wire gauze as anode and NaOH-KOH mixed solution as electrolyte. The influences of various experimental conditions, such as the volume ratio of NaOH-KOH mixed electrolyte, temperature, current density, passivation of iron anode were investigated on ferrate current efficiency. Due to the low solubility of K₂FeO₄ in concentrated alkaline solution and the passivation of iron wire gauze anode, a highest current efficiency over 90% was obtained at 45°C and at a current density of 5 mA cm⁻² in mixed electrolyte with the volume ratio of NaOH: KOH equal to 6: 4. The result is superior to using NaOH and KOH as electrolyte respectively. In addition, polarization curves, scanning electron microscopy (SEM) and electrochemical impedance spectroscopy (EIS) were employed to further study the effects of synthesis conditions on ferrate(VI) in theory. Published in Russian in Elektrokhimiya, 2009, Vol. 45, No. 7, pp. 853–857. The article is published in the original.     

Copolymerization of norbornene and 5‐norbornene‐2‐yl acetate using novel bis(β‐ketonaphthylamino)Ni(II)/B(C6F5)3/AlEt3 catalytic system

Vinyl‐type copolymerization of norbornene (NBE) and 5‐NBE‐2‐yl‐acetate (NBE‐OCOMe) in toluene were investigated using a novel homogeneous catalyst system based on bis(β‐ketonaphthylamino)Ni(II)/B(C₆F₅)₃/AlEt₃. The copolymerization behavior as well as the copolymerization conditions, such as the levels of B(C₆F₅)₃ and AlEt₃, temperature, and monomer feed ratios, which influence on the copolymerization were examined. Without combination of AlEt₃, the catalytic bis(β‐ketonaphthylamino)Ni(II)/B(C₆F₅)₃ exhibited very high catalyst activity for polymerization of NBE. Combination of AlEt₃ in catalyst system resulted in low conversion for polymerization of NBE. For copolymerization of NBE and NBE‐OCOMe, involvement of AlEt₃ in catalyst is necessary. Slight addition of NBE‐OCOMe in copolymerization of NBE and NBE‐OCOMe gives rise to significant increase of catalyst activity for catalytic system bis(β‐ketonaphthylamino)Ni(II)/B(C₆F₅)₃/AlEt₃. Nevertheless, excess increase of the NBE‐OCOMe content in the comonomer feed ratios results in decrease of conversion as well as activity of catalyst. The achieved copolymers were confirmed to be vinyl‐addition copolymers through the analysis of FTIR, ¹H NMR, and ¹³C NMR spectra. ¹³C NMR studies further revealed the composition of the copolymer and the incorporation rate was 7.6–54.1 mol % ester units at a content of 30–90 mol % of the NBE‐OCOMe in the monomer feeds ratios. TGA analysis results showed that the copolymer exhibited good thermal stability (T_d > 410 °C) and failed to observe the glass transitions temperature over 300 °C. The copolymers are confirmed to be noncrystalline by WAXD analysis results and show good solubility in common organic solvents. © 2009 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 47: 3990–4000, 2009     

Short memory principle and a predictor–corrector approach for fractional differential equations

Fractional differential equations are increasingly used to model problems in acoustics and thermal systems, rheology and modelling of materials and mechanical systems, signal processing and systems identification, control and robotics, and other areas of application. This paper further analyses the underlying structure of fractional differential equations. From a new point of view, we apprehend the short memory principle of fractional calculus and farther apply a Adams-type predictor–corrector approach for the numerical solution of fractional differential equation. And the detailed error analysis is presented. Combining the short memory principle and the predictor–corrector approach, we gain a good numerical approximation of the true solution of fractional differential equation at reasonable computational cost. A numerical example is provided and compared with the exact analytical solution for illustrating the effectiveness of the short memory principle.     

继承异常的一种解决方法

继承异常用来描述在并发面向对象语言中继承与并发的冲突．对继承异常做了系统的分析，给出一种新的分类．提出在一并发对象中将同步部分与顺序部分分离，生成两个对象，通过将同步代码放入一单独对象，将继承过程分为顺序部分和同步部分，这种分离大大地减少了继承异常的发生．     

Crystallization of poly(butylene adipate) in the presence of nucleating agents

The effect of nucleating agents on the polymorphic crystallization behavior of poly(butylene adipate) (PBA) was studied with four kinds of commercially available nucleating agents, such as talc and boron nitride. The crystal structures of the α and β forms were studied with wide‐angle X‐ray diffraction. The β‐to‐α‐crystal transformation of PBA in the absence and presence of the nucleating agents in isothermal crystallization and nonisothermal crystallization processes was studied with differential scanning calorimetry and polarized optical microscopy. In both isothermal and nonisothermal crystallization, the introduction of nucleating agents selectively initiated the nucleation of the α‐form crystal, which was relatively slow in the absence of nucleating agents. The nucleating activity of the four kinds of nucleating agents in the crystallization of the PBA α‐form crystal was determined by the study of the nonisothermal crystallization, spherulite morphology, and isothermal kinetics. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 2340–2351, 2005     

广饶县海(咸)水入侵灾害防治的水文地质环境研究

广饶县咸水入侵灾害的发生在于自然环境的脆弱性和社会经济环境的严峻性。本文分析了引起海(咸)水入侵的基本矛盾, 制定了防治咸水入侵灾害的对策和措施──水文地质环境调整方案。     

Preparation of 17β‐estradiol‐imprinted material by surface‐initiated atom transfer radical polymerization and its application

A novel 17β‐estradiol molecularly imprinted polymer was grafted onto the surface of initiator‐immobilized silica by surface‐initiated atom transfer radical polymerization. The resulting molecularly imprinted polymer was characterized by elemental analysis and thermogravimetric analysis. The binding property of molecularly imprinted polymer for 17β‐estradiol was also studied with both static and dynamic methods. The results showed that the molecularly imprinted polymer possessed excellent recognition capacity for 17β‐estradiol (180.65 mg/g at 298 K), and also exhibited outstanding selectivity for 17β‐estradiol over the other competitive compounds (such as testosterone and progesterone). Then, the determination of trace 17β‐estradiol in beef samples was successfully developed by using molecularly imprinted polymer solid‐phase extraction coupled with high‐performance liquid chromatography. The limit of detection was 0.25 ng/mL, and the amount of 17β‐estradiol in beef samples was detected at 2.83 ng/g. This work proposed a sensitive, rapid, reliable, and convenient approach for the determination of trace 17β‐estradiol in complicated beef samples.     

Dual gold nanoparticle lateflow immunoassay for sensitive detection of Escherichia coli O157:H7

Two patterns of signal amplification lateral flow immunoassay (LFIA), which used anti-mouse secondary antibody-linked gold nanoparticle (AuNP) for dual AuNP-LFIA were developed. Escherichia coli O157:H7 was selected as the model analyte. In the signal amplification direct LFIA method, anti-mouse secondary antibody-linked AuNP (anti-mouse-Ab-AuNP) was mixed with sample solution in an ELISA well, after which it was added to LFIA, which already contained anti-E. coli O157:H7 monoclonal antibody-AuNP (anti-E. coli O157:H7-mAb-AuNP) dispersed in the conjugate pad. Polyclonal antibody was the test line, and anti-mouse secondary antibody was the control line in nitrocellulose (NC) membrane. In the signal amplification indirect LFIA method, anti-mouse-Ab-AuNP was mixed with sample solution and anti-E. coli O157:H7-mAb-AuNP complex in ELISA well, creating a dual AuNP complex. This complex was added to LFIA, which had a polyclonal antibody as the test line and secondary antibody as the control line in NC membrane. The detection sensitivity of both LFIAs improved 100-fold and reached 1.14 × 10³ CFU mL⁻¹. The 28 nm and 45 nm AuNPs were demonstrated to be the optimal dual AuNP pairs. Signal amplification LFIA was perfectly applied to the detection of milk samples with E. coli O157:H7 via naked eye observation.     

单轴条件下砂岩三维破裂过程的CT观测

岩石破裂过程研究一直是岩石力学专家关注的重要问题。本文采用特制的三轴压力仪与医用西门子SOMATOM -plusCT扫描仪结合 ,对砂岩进行了室内单轴压缩试验。通过对砂岩的CT图像和密度损伤增量与应力关系曲线分析 ,结果显示 ,砂岩的破裂演化过程可分为初始损伤的压密、裂纹出现—扩展、裂纹归并—分岔、裂纹重分岔—扩展以及裂纹惯通—宏观破坏等五个阶段。在初始损伤的压密阶段 ,砂岩的密度损伤增量为正值 ,速率也为正 ;在裂纹出现—扩展阶段 ,砂岩出现局部密度损伤增量减小 ,并随应力增加而由正值转为负值 ,速率也由正变负 ;在裂纹归并—分岔阶段 ,砂岩的密度损伤增量全为负值 ,速率也变快 ;在裂纹重分岔—扩展阶段 ,砂岩的密度损伤增量继续变负 ,但速率变慢 ;在裂纹惯通—宏观破坏阶段 ,砂岩的密度损伤增量继续变负 ,速率变的更快。