弛豫理论对离子交换毛细管电色谱中峰压缩现象的研究

 在毛细管电色谱中,由于溶质在输运过程中所具有的电性质,常会产生一些特殊的现象。这些现象,如离子交换毛细管电色谱中产生超高柱效峰的现象,已经不能用一般的色谱理论加以解释。基于弛豫理论所建立的基本模型,在考虑溶质在两相中皆有可能发生正、反向迁移的情况下,得到了流出曲线一阶原点矩和二阶中心矩的理论表达式,并通过对溶质在两相中电扩散速率与电泳速率、电渗流速率关系的分析结果证实:溶质在固定相表面的电扩散行为可以使其保留变弱,出峰加快;而这种电扩散导致的超常柱效峰的出现具有不稳定性,只有在多方面因素综合影响匹配的情况下才可能出现。     

新型微填充柱－毛细管柱二维色谱系统过程的动力学研究

从色谱动力学角度对新型微填充柱－毛细管柱二维色谱系统过程中双柱条件与流出曲线及柱效之间的依赖关系加以系统研究。结果表明：由于双柱条件之间存在关联，双柱系统流出曲线特征与单柱系统存在一定的差异，流出曲线一阶矩和二、三阶中心矩以及双柱系统的柱效皆由预柱和主柱条件综合确定。     

可调移动重叠分离图法用于高效液相色谱多台阶梯度分离条件优化的研究

计算机辅助高效液相色谱（HPLC）分离条件优化可以低成本、快速地得到优化的分离条,因而已较为广泛地用于复杂样品的分离分析。基于移动重叠分离图方法,又发展了一种新型的多台阶梯度分离条件的优化方法可调移动重叠分离图法。该方法通过预测不同流动相条件下各组分的保留时间、峰宽和分离度,绘制出对于样品中各组分的重叠分离区域图。在对当前台阶流动相组成进行优化的同时,考虑其对后面一到两个台阶上流出组分保留的影响,实时地重新绘制对于后面台阶上流出组分的重叠分离区域图。通过观察当前台阶流动相条件对当前台阶和后面台阶上流出组分分离的影响,综合考虑样品中所有组分的分离情况,找到更接近全局最优的分离条件。通过扫描的方法对优化得到的分离条件进行微调,能够进一步提高分离效果。采用文献数据对可调移动重叠分离图法的应用加以说明,在二元流动相体系下,证明了该方法在HPLC方法建立方面的优越性。     

Reversed Capillary Electrochromatography: Investigation of Peak Symmetry for Eluting Curves of Solutes

Summary A clean method without use of organic solvents has been developed for isolation and high-performance liquid chromatographic (HPLC) determination of oxytetracycline (OTC) and sulphadimidine (SDD) in cow's milk. Isolation is rapid and simple—homogenization with an inorganic acid solution by means of a handy ultrasonic homogenizer, which is easy-to-use and portable, followed by centrifugation. Reversed-phase HPLC was performed on a C₄ column, with 1.25 mmol L⁻¹ succinic acid solution as mobile phase, and identification was by means of a photodiode-array detector. Separation of the analytes was achieved in less than 8 min. Significant linearity was established over the concentration range of 0.1–1.0 μg mL⁻¹ for both target compounds (r>0.99,P<0.01). Average recoveries of OTC and SDD (each spiked at 0.1–1.0 μg mL⁻¹) were ≥88.8, and inter- and intra-assay variability was ≤2.8%. The total time required for analysis of one sample was <20 min. The limits of quantitation of the method (μg mL⁻¹ in milk) were 0.044 for OTC and 0.023 for SDD. No organic solvent was used at any stage of the analysis.     

Preparation and evaluation of a large-volume radial flow monolithic column

In this study, a 38 mL monolith with homogeneous porous structure was produced by a single polymerization from glycidyl methacrylate (GMA) and ethylene dimethacrylate (EDMA) in the presence of porogens and an initiator. The uniform temperature distribution within the reaction system was achieved by adding reactant mixture continuously and enhancing the heat transfer ability of the polymerization system. Homogeneous porous structure in the monolith was proved by SEM and the pore size distribution profiles measured by mercury intrusion porosimetry. Experimental results from proteins separation indicated that the dynamic capacity and resolution of radial flow monolithic column were independent of flow rates. Furthermore, the pressure drop on the column was linearly dependent on the flow rate and did not exceed 1.7 MPa even at a flow rate of 50 mL/min, which proved that the prepared monolith could be used in the quick separation and preparation of biopolymers.     

Characteristics analysis of metal-clad and absorptive dielectric waveguides by a simple and accurate perturbation method

We present a simple and accurate method for characteristic analysis of metal-clad dielectric waveguides and absorptive waveguides. The real partN of the complex modal indexN=N + iN is obtained by solving the corresponding real eigenvalue equation, and the imaginary partN is given by (n/), where= + i is the complex dielectric constant of the absorptive layer, and N/ is obtained by numerical differentiation. The method is straightforward, and the cumbersome solution of complex transcendental equations is completely eliminated. Results for simple structures are in good agreement with those obtained by exact analysis.     

Approach for the Direct Synthesis of β-Dichlorosubstituted Acetanilides Using Iodine Trichloride (ICl3) as the Oxidant and Catalyst

A reliable method for direct synthesis of β‐dichlorosubstituted acetanilides is reported. The key transformation involves the oxidative and catalytic cleavage of a carbon‐carbon bond in the presence of iodine trichloride (ICl₃). In this protocol ICl₃ is used not only as the catalyst but also as the oxidant which widely broadens the scope of its application in organic synthetic chemistry.     

Comparison of standard addition and conventional isotope dilution mass spectrometry for the quantification of endogenous progesterone in milk

In this study, a standard addition–isotope dilution mass spectrometry (SA-IDMS) method for quantification of endogenous progesterone in milk has been described. The method validation results, linearity, limits of detection and quantification, recovery and uncertainty were fit for the purpose of assigning reference mass fractions to proficiency testing schemes. The developed technique was compared to the isotope dilution mass spectrometry (IDMS) method already existing in the laboratory. Analytical results of two milk samples were (1.377 ± 0.048) μg/kg and (4.457 ± 0.155) μg/kg by SA-ID-LC/MS method, while the results were (1.355 ± 0.019) μg/kg and (4.359 ± 0.059) μg/kg by ID-LC/MS, respectively. Since SA-IDMS was an effective quantitative method that overcame matrix effect, similar quantitative results from IDMS and SA-IDMS indicated that the quantification of progesterone in milk was barely influenced by matrix. Both IDMS and SA-IDMS could be used to assign reference mass fractions to progesterone in milk inter-laboratory proficiency testing schemes.