Hierarchical nanostructured composite cathode with carbon nanotubes as conductive scaffold for lithium-sulfur batteries

Carbon nanotubes (CNTs) are excellent scaffolds for advanced electrode materials, resulting from their intrinsic sp2 carbon hybridization, interconnected electron pathway, large aspect ratio, hierarchical porous structures, and low cost at a large-scale production. How to make full utilization of the mass produced CNTs as building blocks for nanocomposite electrodes is not well understood yet. Herein, a composite cathode containing commercial agglomerated multi-walled CNTs and S for Li-S battery was fabricated by a facile melt-diffusion strategy. The hierarchical CNT@S coaxial nanocables exhibited a discharging capacity of 1020 and 740 mAh g-1 at 0.5 and 2.0 C, respectively. A rapid capacity decay of 0.7% per cycle at the initial 10 cycles and a slow decay rate of 0.14% per cycle for the later 140 cycles were detected. Such hierarchical agglomerated CNT@S cathodes show advantages in easy fabrication, environmentally benign, low cost, excellent scalability, and good Li ion storage performance, which are extraordinary composites for high performance Li-S battery.     

三光气与酚制备三氯甲氧基甲酸芳酯研究

研究了不同取代酚与三光气的反应,得到七种未见报道的新化合物,以IR、MS、1H NMR、13C NMR对产物进行了表征,并探索得到合适的反应催化剂、反应物浓度配比、反应时间,讨论了酚上不同取代基对反应的影响,收率在78.5～90.5%之间。     

Anionic surfactant selective electrode for the titrimetric determination of anionic surfactant

The construction and characteristic performance of a PVC membrane electrode responsive for sodium dodecylsulfate (SDS) are described in this paper. The electrode based on CTA⁺DS^? ion pair as ionophore in PVC membrane displays a Nernstian slope of ?58.8 ± 0.7 mV/decade in a 1.32 × 10^?6 to 3.75 × 10^?3 mol L^?1 concentration range and a limit of detection of 1.13 × 10^?6 mol L^?1. The electrode can be used for 3 months without showing significant changes in the value of slope or working range. The electrode has been utilized as an end point indicator electrode for potentiometric titration involving Hyamine as titrant. More than 100 titrations were carried out for the evaluation of the electrode parameters: the standard deviations of the equivalent volume and the equivalent potential, the height of the potential jump and the number of faulty titrations. The behavior of the electrode was assessed with regard to their usefulness in routine analysis.     

Annihilation of persistent slip bands and its effect on the fatigue life of copper single crystals

In single-slip-oriented copper single crystals, which were cyclically deformed under constant plastic shear strain amplitude control, a persistent slip band (PSB) was initiated on the persistent slip line (PSL) that first formed in the matrix vein dislocation structure. During intermediate temperature recovery (ITR) treatment in vacuum at 245 to 400°C, the variations in dislocation configurations and other defects of fatigued specimens were studied by using the scanning electron microscopy (SEM) electron channelling contrast (ECC) and the positron annihilation life (PAL) techniques. The results show that the ladders in the PSBs became curved and broken, or escaped locally until the PSBs disappeared completely during ITR treatment. The annihilation of the PSBs and other dislocation structures in the fatigued specimens prolonged the fatigue life to a certain extent.     

Low-temperature solubility of copper in iron: experimental study using thermoelectric power,small angle X-ray scattering and tomographic atom probe

Measuring the solubility limit of copper in iron at temperature lower than 700°C is problematic because copper diffusion is too slow in this temperature range. To overcome this difficulty, fine precipitation of copper is studied. The solubility limit of copper is measured after complete precipitation using two complementary techniques: thermoelectric power and small angle X-ray scattering. Values obtained are confirmed by tomographic atom probe and give results much higher than what is usually extrapolated from high-temperature experiments.     

Effect of long-period stacking ordered phase on thermal stability of refined grains in Mg-RE-based alloys

The refined grains in both as-cast Mg-10Y-1Zn-2Zr (WZ101?K, wt.%) and Mg-10Y-1Al (WA101, wt.%) alloys have been found to have superior thermal stability after solution treatment. Plate-shaped, but different polytypes of long-period stacking ordered (LPSO) phases distributed along grain boundaries are considered as the predominant inhibitors of grain growth. Based on the plate-shaped features of the LPSO phases, a modified Zener’s model is established and the predicted limiting grain sizes are in a good agreement with the experimental results. Therefore, this model has strong potential for designing advanced Mg-RE-based alloys with high strength and high creep resistance at high temperatures.     

Diels–Alder dimerization of Morita–Baylis–Hillman acetates catalyzed by organocatalysts

DABCO-catalyzed dimerization of Morita–Baylis–Hillman acetates to synthesize a series of 3-alkyl-4-(E)-alkenyl-cyclohex-1-ene-1,4-dicarbonyl compounds in excellent yields with modest to excellent diastereoselectivity is reported. A plausible reaction mechanism is also proposed on the basis of previous literature and preliminary investigation the asymmetric version of the reaction.     

A modified procedure for synthesis of the side chain of ceftazidime-activated thioester

A modified procedure for synthesis of the side chain of ceftazidime-activated thioester has been established. This key intermediate of ceftazidime was obtained by a more eco-friendly process than conventional methods, and the yield was much higher (up to 92.4 %). It was found that different organic bases (triethylamine or pyridine) used in this reaction had different effects. The reaction conditions were also optimized to make the route more competitive and suitable for large-scale industrial production.     

一类非线性边值问题正解的存在性

本文运用锥上的不动点理论,讨论了一类与一阶导函数有关的二阶奇性混合边值问题的正解存在性．     

一个吡啶二甲酸镉配位聚合物的合成、晶体结构及荧光性质

通过水热方法,采用H3CAM(H3CAM=4-hydroxy-pyridine-2,6-dicarboxylic acid)与Cd(NO3)2.4H2O反应,合成了1个镉配位聚合物[Cd4(HCAM)4(H2O)8]n(1),并对其结构和荧光性质进行了研究。结构分析结果表明该配合物属于单斜晶系,C2/c空间群。四个HCAM2-配体桥联4个镉离子形成了1个四核镉单元。这些孤立的单元通过氢键作用形成了1个三维配位框架。研究表明,该配合物在室温下能发出兰色荧光。