Deterministic controlled-NOT gate for single-photon two-qubit quantum logic

We demonstrate a robust implementation of a deterministic linear-optical controlled-not gate for single-photon two-qubit quantum logic. A polarization Sagnac interferometer with an embedded 45 degrees -oriented dove prism is used to enable the polarization control qubit to act on the momentum (spatial) target qubit of the same photon. The optical controlled-not gate requires no active stabilization because the two spatial modes share a common path, and it is used to entangle the polarization and momentum qubits.     

Identification of pre-sliding friction dynamics

The hysteretic nonlinear dependence of pre-sliding friction force on displacement is modeled using different physics-based and black-box approaches including various Maxwell-slip models, NARX models, neural networks, nonparametric (local) models and dynamical networks. The efficiency and accuracy of these identification methods is compared for an experimental time series where the observed friction force is predicted from the measured displacement. All models, although varying in their degree of accuracy, show good prediction capability of pre-sliding friction. Finally, we show that even better results can be achieved by using an ensemble of the best models for prediction.     

Soft X-ray optimization studies on a dense plasma focus device operated in neon and argon in repetitive mode

This paper investigates the emission characteristics of a high-performance low-energy (3-kJ) repetitive dense plasma focus device, NX2, operated at up to 1-Hz repetition rate to develop it as an intense source of soft X-rays (SXR) for microlithography and micromachining. Various SXR yield optimization studies with argon and neon as filling gases were performed under different operating conditions (charging voltage, filling pressure, anode length, and insulator sleeve length). The SXR yield was computed using signals obtained from a PIN diode SXR spectrometer with appropriate filters. When operated in neon, the average optimum SXR (/spl lambda//spl sim/1 nm) yield in 4/spl pi/ steradians was found to be up to 140 J/shot, which corresponded to a wall plug efficiency of 5.6%. Operation in argon showed that optimized SXR (/spl lambda//spl sim/0.4 nm) yield was up to 1.3 J/shot. While operating with neon under optimized conditions with a water-cooled anode in repetitive mode, the NX2 device was used as a SXR source to imprint a test lithograph on a highly sensitive chemically-amplified resist SU-8. Test structures showing the effect of a stepper with aspect ratio 3:1 on 10-/spl mu/m-thick SU-8 resist film were obtained.     

Superhydrophobicity of polytetrafluoroethylene thin film fabricated by pulsed laser deposition

Superhydrophobic polytetrafluoroethylene (PTFE) thin films were obtained by pulsed laser deposition (PLD) technique carried out with KrF excimer laser (λ = 248 nm) of about 1 J/cm² at a pressure of 1.33 Pa. The samples exhibit high water contact angle of about 170° and the sliding angle smaller than 2°. From studying the surface morphology of the prepared films, it is believed that the nano-scale surface roughness has enhanced the hydrophobic property of the PTFE. The increase of trapping air and reducing liquid-solid contact area due to the rough surface, as suggested by the Cassie-Baxter's model, should be responsible for superhydrophobicity of the PLD prepared films. This study thus provides a convenient one-step method without using wet-process to produce a superhydrophobic surface with good self-cleaning properties.     

Parametric processes in microstructured and highly nonlinear optical fibres

Optical parametric amplification is an important nonlinear process in photonic crystal fibres driven by the small effective area and the special dispersion characteristics of these fibres. Aside from its role in supercontinuum generation, parametric amplification can lead to efficient wavelength conversion, limited primarily by the uniformity of the diameter of currently available fibres. The related Bragg scattering process can be used for both wavelength conversion and optical switching, again limited by the physical characteristics of the fibres used.     

Preparation of epitaxial compositionally graded (Ba1-xSrx)TiO3 thin films with enhanced dielectric properties

Epitaxial compositionally graded (Ba_1-xSr_x)TiO₃ (BST) (0.0x0.25) thin films were deposited on (100) LaAlO₃ substrates by pulsed laser ablation, the substrates having bottom electrodes made of 100-nm-thick conductive La_0.5Sr_0.5CoO₃ (LSCO). Extensive X-ray diffraction, rocking-curve, and -scan studies indicate that the graded films are (100)-oriented and exhibit good in-plane relationships of [010]_BST//[010]_LAO and [001]_BST//[001]_LAO. For the up-graded films with barium concentration (1-x) increasing across the film thickness in the direction from the film/substrate interface to the film surface, the full width at half maximum of the BST film (200) rocking curve and the surface roughness, examined by atomic force microscopy, were larger than those of the down-graded films with barium concentration decreasing from the film/substrate interface to the film surface. The dielectric properties of the graded films, measured using vertical structures, show that at room temperature, the dielectric constant (_r) and dissipation factor (cos) at 100 kHz were 380 and 0.013 for the up-graded films, and 650 and 0.010 for the down-graded films, respectively. The dielectric behavior was enhanced in the down-graded films, which was attributed to the fact that the pure BaTiO₃ layer in the down-graded BST films not only serves as a bottom layer but also acts as an excellent seeding layer for enhancing subsequent film growth, leading to better film crystallinity and larger grain sizes in the down-graded films. The graded BST films undergo a diffuse phase transition, giving a broad, flat capacitance-versus-temperature profile. With such a graded structure, it is possible to build a dielectric thin-film capacitor having a capacitance which has a low temperature dependence over a broad temperature regime. PACS 77.55.+f; 68.55.Jk; 81.15.Fg     

A 59Co NMR study to observe the effects of ball milling on small ferromagnetic cobalt particles

To demonstrate the potential of nuclear magnetic resonance (NMR) spectroscopy for investigating detailed structural properties in ferromagnetic materials, three different particle sized cobalt (Co) powders have been ball milled for 24 h are accurately characterised by internal-field ⁵⁹Co NMR. The ⁵⁹Co NMR spectra show distinct resonance bands corresponding to the different Co sites, face-centred-cubic (fcc), hexagonal-close-packed (hcp) and stacking faults (sfs), in Co metal powders. The hcp+fcc→hcp phase transition encouraged by ball-milling was observed and quantitative values for each Co environment were obtained.     

Selective image encryption using a spatiotemporal chaotic system

A universal selective image encryption algorithm, in which the spatiotemporal chaotic system is utilized, is proposed to encrypt gray-level images. In order to resolve the tradeoff between security and performance, the effectiveness of selective encryption is discussed based on simulation results. The scheme is then extended to encrypt RGB color images. Security analyses for both scenarios show that the proposed schemes achieve high security and efficiency.     

All-Optical Wavelength Conversion with Amplitude Equalization and Pulse Shaping

A dual-wavelength-injection-locked (DWIL) Fabry-Perot (FP) laser is used as an all-optical wavelength converter and regenerator.Regenerated pulses have narrower pulse-width of 37ps.Power penalty and extinction-ratio improvement of 1.5dB and 4dB respectively were achieved.     

Polarization-Insensitive All-Optical Time-Division Demultiplexer Constructed with a Nonlinear Loop Interferometer

A polarization-insensitive 40-Gb/s time-division demultiplexer was demonstrated in a polarization-diversity loop configuration. The power penalty was measured to be 2.3 dB at a bit error rates of 10-9 for 10 Gb/s output signals.