论恒力作用下质点的相对论运动

在相对论情况下，讨论了受恒力作用的质点的运动规律。     

Slutsky定理的一个推广

本文应用紧集上的连续函数是一致连续的性质，推广并证明了著名的Slutsky定理。     

覆盖亚临界到临界区的制冷工质物性快速算法

为了在亚临界到临界点这个大范围内保证制冷剂物性计算的快速、稳定、可逆,提出将整个数据区间划分成若干个子区间分别进行隐式拟合,并且保证相邻子区间连接点处的连续与光滑,以及通过求分析解从隐式方程中得到显式物性计算式的方法.以美国国家标准局开发的程序REFPROP6.01的计算结果作为数据源,以R410A为例对该方法做了验证.得出快速物性计算公式的应用范围为饱和温度-60℃至临界温度,与NIST REFPROP 6.01的计算结果进行比较表明,计算速度快1500倍,平均相对偏差小于0.01%.     

From a Nonlinear, Nonconvex Variational Problem to a Linear, Convex Formulation

   Abstract. We propose a general approach to deal with nonlinear, nonconvex variational problems based on a reformulation of the problem resulting in an optimization problem with linear cost functional and convex constraints. As a first step we explicitly explore these ideas to some one-dimensional variational problems and obtain specific conclusions of an analytical and numerical nature.     

A Dominated Theorem on 5L(2, R) and Its Application

In this paper, we give the following dominated theorem: Let φ(g) ∈ L1(G//K),φε(t)=ε> 0, and the least radical decreasing dominatedfunction φ(t) = sup |φ(y)| ∈L1(G//K). If shtφ(t) is monotonically decreasingon (0, ∞), then for any f∈L1loc(G//K) , the following inequality holds:sup |φε * f(x)| ≤ Cmf(x),where mf(x) is the Hardy-Littlewood maximal function of f, and C = ||φ||1.An application of this dominated theorem is also given.     

System Identification Models of the Equivalent Permittivity for Rain Medium

The dielectric constant for rain medium is investigated by utilizing the system identification method. The rain rate model and frequency model of permittivity in millimeter waves band for rain medium are presented. The results obtained with models are in very good agreement with references in calculating the attenuation of electromagnetic waves induced by rain, which Shows that the obtained models are valid and practicable. The cross-polar discrimination gotten with rain rate model is in agreement with references.     

Förster energy transfer from poly(arylene–ethynylene)s to an erbium–porphyrin complex

We study the infrared emission at 1.54 μm of an organolanthanide complex, Er(III)-tetraphenylporphyrin [Er(TPP)acac], both as a result of direct optical excitation and via energy transfer from host π-conjugate polymers of type poly(arylene–ethynylene) [PAE]. In the first case, the emission of the neat complex is characterized in inert transparent materials and a value of the quantum yield at 1.54 μm φ_IR=4×10⁻⁴ is measured. Then, fluorescence resonance transfer is investigated in blends of Er(TPP)acac with PAEs by monitoring the quenching of the polymer fluorescence along with the enhancement of both the visible emission of the ligand and the near-infrared band of Er³⁺. These different procedures allow a detailed analysis of the transfer efficiency within a specific implementation of the Förster model for polymeric donors. The experimental values of the critical radius R₀, ranging from 1.3 to 2.5 nm for the different blends, are in good agreement with theory for a wide interval of the physical and spectroscopic parameters. This suggests that other mechanisms for excitation transfer do not play a significant role in these materials.     

乌桕类可可脂结晶过程中表现体积变化

为了解乌桕类可可脂(CTCBE)缓冷结晶横向胀罐爆裂原因，研究CTCBE结晶过程中的膨胀特性，采用流体静力法测试了不同等温结晶条件下CTCBE结晶形成的表观密度和表观体积及其横纵向膨胀状况。结果表明，CTCBE缓冷结晶后形成外部和中部两个晶区。在5-25℃的各等温结晶范围内，当结晶温度增加时，外部结晶区域减小、表观密度变化不大；中部结晶区域增大、表观密度明显减小，CTCBE的表观体积、横向、纵向膨胀率均增大，膨胀横向大于纵向。进一步表明CTCBE在自然缓冷固化的表观体积根本上由其结晶温度决定。为有效防止横向胀罐，自然缓冷固化温度应低于10℃。     

一种小波域音频信息隐藏方法

提出了一种基于量化的小波域音频隐藏算法，将保密语音隐藏到载体音频中．为提高隐藏重和保密语音传输的安全性，对保密语音进行了小波域压缩编码和m序列的扩频调制，生成待隐藏的比特序列；通过量化方法，将编码和调制后的保密语音隐藏到载体音频的小波系数中；保密语音的恢复过程不需要使用原始音频、仿真结果表明，隐藏有保密语音的载体音频听觉质量没有明显下降，提取的保密语音感知质量较好；该算法对重量化、加噪、低通滤波等攻击均有良好的鲁棒性．     

A fast method to measure the thickness of removed layer from etching of SSNTD based on EDXRF

Solid state nuclear track detectors are commonly used for measurements of concentrations of radon gas and/or radon progeny. All these measurements depend critically on the thickness of the removed layer during etching. However, the thickness of removed layer calculated using the etching period does not necessarily provide a sufficiently accurate measure of the thickness. For example, the bulk etch rate depends on the strength of stirring during etching for the LR 115 detector. We propose here to measure the thickness of the removed layer by using energy-dispersive X-ray fluorescence spectrometry. In the present work, a reference silver nitrate pellet is placed beneath the LR 115 detector, and the fluorescence X-ray intensity for silver is then measured. We have found a linear relationship between the X-ray intensity and the thickness of the removed layer for LR 115 detector. This provides a fast method to measure the thickness of removed layer from etching of LR 115 detector. However, this method was found to be inapplicable for the CR-39 detector. Therefore, alternative methods have yet to be explored for the CR-39 detector.