基于DIS数字信息化系统对透光物质透光性能的研究

采用DIS数字信息化系统,对不同浓度的蓝墨水溶液在激光光源照射下的透射平均照度及照度分布图像进行实验研究,得到了平均照度值随溶液浓度变化的规律。对不同颜色塑料膜片对白炽灯光源透过照度值及照度分布图像进行实验研究得到及其相关之规律。     

焦炉上升管内壁结焦炭层的光谱学分析及结焦机理研究

以焦炉上升管内壁结焦炭层块为研究对象，采用X射线荧光光谱仪（XRF）、X射线衍射仪（XRD）、傅里叶红外光谱仪（FTIR）和激光共聚焦拉曼光谱仪（Raman）对结焦炭层的元素组成，以及各结焦炭层的矿物组成、组成结构和分子结构进行测试。分析从结焦炭层块外表面向内表面过渡的各结焦炭层的差异性，揭示焦炉上升管内壁结焦机理。结果表明焦炉上升管内粉尘中Fe，S和Cr极易催化荒煤气中蒽、萘等稠环芳烃化合物成炭，在焦炉上升管内壁形成炭颗粒沉积，为焦油凝结挂壁提供载体，在荒煤气温度降至结焦温度时易结焦积碳。结焦炭层均含有芳香层结构，随着结焦炭层从外表面向内表面过渡，各结焦炭层的面层间距(d₀₀₂)逐渐降低、层片直径(L_a)先降低后增加、层片堆砌高度(Lc)和芳香层数(N)先稳定后增加。结焦炭层石墨化过程是由结焦炭层内表面向外表面进行，主要包括其片层外缘的羧基和部分C-O结构的降解剥离，从而形成高度规整的共轭结构。结焦炭层块中C元素是以结晶碳与无定型碳的混合物形式存在。以上研究为解决焦炉上升管内壁结焦及腐蚀问题，提高换热器换热效率，有效回收焦炉荒煤气显热，降低焦化企业能耗提供实验基础和理论依据。     

双掺(Tm3+,Tb3+)LiYF4激光器1.5 μm波长激光阈值分析

由速率方程推出了双掺（Tm^3 ,Tb^3 ）离子准四能级系统的激光阈值解析式，讨论了Tm^3 和Tb^3 离子之间的相互作用。分析了1.5μm波长附近的激光阈值和Tm^3 、Tb^3 离子的掺杂原子数分数及晶体长度的关系。结果表明，对于对应Tm^3 离子^3H4→^3F4跃迁的约1.5μm波长的激光，激活离子Tm^3 的掺杂原子数分数过大时，交叉弛豫作用将使系统阈值迅速增加。Tb^3 离子的加入，一方面能抽空激光下能级，起到降低阈值的作用；另一方面亦减少了激光上能级的寿命，使阈值升高。故Tb^3 离子有最佳掺杂原子数分数。对于Tm原子数分数为y=0.01的Tm:LiYF4晶体，Tb^3 离子的最佳掺杂原子数分数为0.002左右，同时表明，激光阈值与晶体长度有关。最佳晶体长度与Tm^3 、Tb^3 离子的掺杂原子数分数以及晶体的衍射损耗和吸收损耗有关。     

Comparative studies on the mechanism of uridine phosphorolysis

We have used quantum mechanical method to study the transition states(TSs) of uridine phosphorolysis reaction. Comparing the four different reaction pathways and the five transition states obtained, we conclude that enzymatic uridine phosphorolysis takes place mainly according to acid-catalyzed SN2 mechanism. The proposed reaction pathway is consistent with many experimental results.     

计量累积和控制图方案设计的选择

常规控制图已广泛应用于生产,国家标准<计数型累积和图>GB4887-85的实施,使得判断生产“过程”异常具有更高的灵敏度,能更经济地保证产品质量,它是常规控制图的改进与发展.在常规控制图中,为了使控制图能对小偏差有较快的反映,一般用缩小控制界线,如将3σ限改为2σ限,但会导致第一类误判率大大升高.而累积和方法可以通过对方案参数的适当选择使控制图在第一类误判率并不明显升高的情况下对小偏差反映敏感.此外,累积和方法还允许针对各种需要设计出特别适于发现某个偏差,例如1.5σ_e 的     

纳米级精度分光路双频干涉度量系统的设计

为完成快速、精确的外观轮廓度量,设计了一种新型纳米级精度分光路双频干涉度量系统。系统由低频差双频激光干涉度量模块和微探头及二维工作台两部分组成。微探针以轻敲式接近样品至几十纳米时,受原子力作用发生偏转,利用双频干涉模块度量其纵向偏转量,并对样品进行梳状式度量得到外观形貌。根据双频激光的实际光源,对原有双频干涉度量理论进行了改进提高。进行了系统组建和实验验证。结果表明:系统具有纳米级精度,可用于超精样品外观轮廓度量。     

The acoustic characteristics of clause, sentence and paragraph boundaries in Chinese Putonghua

The acoustic and perceptive characteristics of discourse units, including clauses, simple sentences, compound sentences and paragraphs, were studied. The acoustic characteristics were based on the analysis of a speech corpus consisted of ten monologues. The Perceived Boundary Strength (PBS) of the monologues was labeled on a five-point scale by 25 participants. The main results are as follows: (1) There is a significant difference in the PBS of clauses (corresponding to intonational phrase), sentences (including simple sentences and compound sentences) and paragraphs. But the PBS of simple sentences and compound sentences is the same, and the pitch reset and pause are also not significantly different between these two kinds of boundaries. (2) The pitch-based cue used to distinguish clauses, sentences and paragraphs appears to be the difference between pre- and post-boundary syllables, but not simply the pitch value of either syllable alone. (3) Declination mainly occurs within intonational phrases, whereas there is no consistent global declination in sentences or in paragraphs. (4) Pauses are longer and more varied at the boundary of larger discourse units. Moreover, there is a significant positive correlation between pause duration and degree of pitch reset at clause boundaries, but not at sentence or paragraph boundaries.     

极化子导电到能带导电的转变

采用交流法测量大功率商用钛酸钡(BT)陶瓷加热器的电阻和加热功率随温度的变化关系.结果显示,BT陶瓷的电导特性在80℃附近出现了明显的转变,从低温时的极化子跳跃导电转变为高温时的能带导电,此时,电阻出现极小值,而加热功率出现极大值.     

Banach空间中优化问题的最优性条件

首先在Contingent切锥意义下界定了Banach空间中非空集合的伪切锥和伪凸性的概念，并讨论了相应的性质，然后针对可微优化问题，在广义凸性假设下，建立了最优性条件。